参数资料
型号: W182G
英文描述: MISCELLANEOUS CLOCK GENERATOR|CMOS|SOP|14PIN|PLASTIC
中文描述: 杂项时钟发生器|的CMOS |专科| 14PIN |塑料
文件页数: 3/9页
文件大小: 124K
代理商: W182G
W182
Document #: 38-07151 Rev. **
Page 3 of 9
Overview
The W182 product is one of a series of devices in the Cypress
PREMIS family. The PREMIS family incorporates the latest
advances in PLL spread spectrum frequency synthesizer tech-
niques. By frequency modulating the output with a low-fre-
quency carrier, peak EMI is greatly reduced. Use of this tech-
nology allows systems to pass increasingly difficult EMI testing
without resorting to costly shielding or redesign.
In a system, not only is EMI reduced in the various clock lines,
but also in all signals which are synchronized to the clock.
Therefore, the benefits of using this technology increase with
the number of address and data lines in the system. The Sim-
plified Block Diagram shows a simple implementation.
Functional Description
The W182 uses a Phase-Locked Loop (PLL) to frequency
modulate an input clock. The result is an output clock whose
frequency is slowly swept over a narrow band near the input
signal. The basic circuit topology is shown in
Figure 1
. The
input reference signal is divided by Q and fed to the phase
detector. A signal from the VCO is divided by P and fed back
to the phase detector also. The PLL will force the frequency of
the VCO output signal to change until the divided output signal
and the divided reference signal match at the phase detector
input. The output frequency is then equal to the ratio of P/Q
times the reference frequency. (Note: For the W182 the output
frequency is nominally equal to the input frequency.) The
unique feature of the Spread Spectrum Frequency Timing
Generator is that a modulating waveform is superimposed at
the input to the VCO. This causes the VCO output to be slowly
swept across a predetermined frequency band.
Because the modulating frequency is typically 1000 times
slower than the fundamental clock, the spread spectrum pro-
cess has little impact on system performance.
Frequency Selection With SSFTG
In Spread Spectrum Frequency Timing Generation, EMI re-
duction depends on the shape, modulation percentage, and
frequency of the modulating waveform. While the shape and
frequency of the modulating waveform are fixed for a given
frequency, the modulation percentage may be varied.
Using frequency select bits (FS2:1 pins), the frequency range
can be set (see
Table 2
). Spreading percentage is set with pin
SS% as shown in
Table 1
.
A larger spreading percentage improves EMI reduction. How-
ever, large spread percentages may either exceed system
maximum frequency ratings or lower the average frequency to
a point where performance is affected. For these reasons,
spreading percentage options are provided.
Freq.
Divider
Q
Phase
Detector
Modulating
Waveform
VCO
Post
Dividers
CLKOUT
(EMI suppressed)
Charge
Pump
Feedback
DiP
PLL
GND
V
DD
Σ
Clock Input
Reference Input
Figure 1. Functional Block Diagram
相关PDF资料
PDF描述
W183G MISCELLANEOUS CLOCK GENERATOR|CMOS|SOP|14PIN|PLASTIC
W184H MISCELLANEOUS CLOCK GENERATOR|CMOS|SSOP|24PIN|PLASTIC
W185H Miscellaneous Clock Generator
W185-5 Six Output Peak Reducing EMI Solution
W18NB40 N-CHANNEL 400V - 0.19ohm - 18.4A TO-247/ISOWATT218 PowerMESH MOSFET
相关代理商/技术参数
参数描述
W182-HEA-100 制造商:NTE Electronics 功能描述:
W182-HEA-25 制造商:NTE Electronics 功能描述:
W182-HEA-50 制造商:NTE Electronics 功能描述:
W183 制造商:CYPRESS 制造商全称:Cypress Semiconductor 功能描述:Full Feature Peak Reducing EMI Solution
W183-5 制造商:CYPRESS 制造商全称:Cypress Semiconductor 功能描述:Full Feature Peak Reducing EMI Solution