参数资料
型号: WJLXT972MLC.A4-864101
厂商: CORTINA SYSTEMS INC
元件分类: 网络接口
英文描述: DATACOM, ETHERNET TRANSCEIVER, PQFP48
封装: ROHS COMPLIANT, LQFP-48
文件页数: 18/99页
文件大小: 1526K
代理商: WJLXT972MLC.A4-864101
Page 25
Cortina Systems LXT971A Single-Port 10/100 Mbps PHY Transceiver
LXT971A PHY
Datasheet
249414, Revision 5.2
13 September 2007
5.2 Network Media / Protocol
Support
calculation truncation errors found in traditional DSP-based receivers (typically complex
DSP engines with A/D converters). This results in improved receiver noise and cross-talk
performance.
The OSP signal processing scheme also requires substantially less computational logic
than traditional DSP-based designs. This lowers power consumption and also reduces the
logic switching noise generated by DSP engines. This logic switching noise can be a
considerable source of EMI generated on the device’s power supplies.
The OSP-based LXT971A PHY provides improved data recovery, EMI performance, and
low power consumption.
5.2
Network Media / Protocol Support
This section includes the following:
The LXT971A PHY supports both 10BASE-T and 100BASE-TX Ethernet over twisted-pair
or 100 Mbps Ethernet over fiber media (100BASE-FX).
5.2.1
10/100 Network Interface
The network interface port consists of five external pins (two differential signal pairs and a
signal detect pin). The I/O pins are shared between twisted-pair (TP) and fiber. For
specific pin assignments, see Section 4.0, Signal Descriptions, on page 17.
The LXT971A PHY output drivers can generate one of the following outputs:
100BASE-TX
10BASE-T
100BASE-FX
When not transmitting data, the LXT971A PHY generates IEEE 802.3-compliant link
pulses or idle code. Depending on the mode selected, input signals are decoded as one of
the following:
100BASE-TX
10BASE-T
100BASE-FX
Auto-negotiation/parallel detection or manual control is used to determine the speed of
this interface.
5.2.1.1
Twisted-Pair Interface
The LXT971A PHY supports either 100BASE-TX or 10BASE-T connections over 100
Ω,
Category 5
, Unshielded Twisted Pair (UTP) cable. When operating at 100 Mbps, the
LXT971A PHY continuously transmits and receives MLT3 symbols. When not transmitting
data, the LXT971A PHY generates “IDLE” symbols.
During 10 Mbps operation, Xilink* Manchester-encoded data is exchanged. When no data
is being exchanged, the line is left in an idle state. Link pulses are transmitted periodically
to keep the link up.
相关PDF资料
PDF描述
WJLXT972MLC.A4-864115 DATACOM, ETHERNET TRANSCEIVER, PQFP48
WJLXT972MLC.A4SE001 DATACOM, ETHERNET TRANSCEIVER, PQFP48
WJLXT972MLC.A4SE000 DATACOM, ETHERNET TRANSCEIVER, PQFP48
WJLXT972MLC.A4SE001 DATACOM, ETHERNET TRANSCEIVER, PQFP48
WJLXT972MLC.A4SE000 DATACOM, ETHERNET TRANSCEIVER, PQFP48
相关代理商/技术参数
参数描述
WJM1000 功能描述:射频模块 902-928 MHz US ISM EPC Class 1 Gen 2 RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
WJM3000 功能描述:射频模块 902-928 MHz US ISM EPC Class 1 Gen 2 RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
WJ-MP204C-W1 制造商:Black Box Corporation 功能描述:1 year warranty for WJ-MP204C
WJ-MP204C-W3 制造商:Black Box Corporation 功能描述:3 year warranty for WJ-MP204C
WJMX12-SM 制造商:Panasonic Industrial Company 功能描述:SERVICE MANUAL PANASONIC