参数资料
| 型号： | X4325V8I-4.5A |
| 厂商： | Intersil |
| 文件页数： | 12/22页 |
| 文件大小： | 0K |
| 描述： | IC SUPERVISOR CPU 32K EE 8-TSSOP |
| 标准包装： | 200 |
| 类型： | 简单复位/加电复位 |
| 监视电压数目： | 1 |
| 复位： | 高有效 |
| 复位超时： | 最小为 100 ms |
| 电压 - 阀值： | 4.62V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 管件 |
X4323, X4325
Figure 10. Writing 12-bytes to a 64-byte Page Starting at Location 60.
8 Bytes
4 Bytes
Address
=7
Address Pointer
Ends Here
Addr = 8
Address
60
Address
n-1
The master terminates the Data Byte loading by issuing
a stop condition, which causes the device to begin the
nonvolatile write cycle. As with the byte write operation,
all inputs are disabled until completion of the internal
write cycle. See Figure 9 for the address, acknowledge,
and data transfer sequence.
Stops and Write Modes
Stop conditions that terminate write operations must
Figure 11. Acknowledge Polling Sequence
Byte load completed
by issuing STOP.
Enter ACK Polling
Issue START
be sent by the master after sending at least 1 full data
byte plus the subsequent ACK signal. If a stop is
issued in the middle of a data byte, or before 1 full
data byte plus its associated ACK is sent, then the
device will reset itself without performing the write. The
contents of the array will not be effected.
Acknowledge Polling
The disabling of the inputs during nonvolatile cycles
Issue Slave Address
Byte (Read or Write)
ACK
returned?
YES
NO
Issue STOP
can be used to take advantage of the typical 5ms write
cycle time. Once the stop condition is issued to indi-
cate the end of the master’s byte load operation, the
device initiates the internal nonvolatile cycle. Acknowl-
edge polling can be initiated immediately. To do this,
the master issues a start condition followed by the
Slave Address Byte for a write or read operation. If the
device is still busy with the nonvolatile cycle then no
ACK will be returned. If the device has completed the
Nonvolatile Cycle
complete. Continue
command sequence?
YES
Continue Normal
Read or Write
Command Sequence
NO
Issue STOP
write operation, an ACK will be returned and the host
can then proceed with the read or write operation.
Refer to the flow chart in Figure 11.
12
PROCEED
FN8122.1
May 25, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| X45620V20I-2.7 | IC VOLT MON DUAL SW EEPR 20TSSOP |
| X4645V8I-4.5A | IC SUPERVISOR CPU 64K EE 8-TSSOP |
| X4C105V20I | IC SUPERVISOR NOVRAM/EE 20-TSSOP |
| X5001V8I-4.5A | IC SUPERVISOR CPU 8-TSSOP |
| X5045V14I-4.5A | IC SUPERVISOR CPU 4K EE 14-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| X-4328-TT-R | 功能描述:音频指示器及警报器 9VDC 12MA 108DBA 2800HZ RoHS:否 制造商:PUI Audio 产品:Indicators 声压级:85 dB 音调:Continuous 频率:2300 Hz +/- 300 Hz 电压额定值:5 VDC 电流额定值:30 mA 端接类型: 直径:12 mm 安装:Through Hole |
| X433-133.33M | 制造商:CONNOR-WINFIELD 制造商全称:Connor-Winfield Corporation 功能描述:5.0x7.0mm Surface Mount LVCMOS Clock Oscillator Series |
| X4350PSF1 | 制造商:ABB Low Voltage Products and Systems 功能描述:CCT,350VA,460V/120V SINGLE |
| X436 | 制造商:Heyco Products Inc 功能描述: |
| X-439289A | 制造商:Volex Group 功能描述:LEAD 5A BLACK 3M |
发布紧急采购，3分钟左右您将得到回复。