参数资料
| 型号： | XR88C681CP/40-F |
| 厂商： | Exar Corporation |
| 文件页数： | 76/101页 |
| 文件大小： | 0K |
| 描述： | IC UART CMOS DUAL 40PDIP |
| 标准包装： | 9 |
| 特点： | * |
| 通道数： | 2，DUART |
| FIFO's： | 1 字节，3 字节 |
| 电源电压： | 4.75 V ~ 5.25 V |
| 带并行端口： | 是 |
| 带CMOS： | 是 |
| 安装类型： | 通孔 |
| 封装/外壳： | 40-DIP（0.600"，15.24mm） |
| 供应商设备封装： | 40-PDIP |
| 包装： | 管件 |
| 其它名称： | 1016-1328-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页当前第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页
XR88C681
76
Rev. 2.11
RXDn
Receive Holding
Register
Receive Shift Register
Transmit Shift Register
Transmit Holding
Register
TXCn
TXDn
Incoming
Serial Data
Outgoing
Serial Data
RXCn
Note:
The CPU has no access to the Serial Data during Remote Loopback Mode.
Figure 41. A Block Diagram Depicting Remote Loopback Mode
In this mode:
1. Received data is transmitted on the channel’s TXDn
output
2. Received data is not sent to the CPU and the error
status conditions are not checked.
3. Parity and framing (stop bits) are transmitted as
received.
4. The receiver must be enabled.
5. The received break is echoed as received until the
next valid start bit is detected.
MR2n[5] - Transmitter Request-to-Send Control
Ordinarily, the RTS (Request to Send) output is asserted
or negated by invoking the “SET OUTPUT PORT BITS
COMMAND” or “CLEAR OUTPUT PORT BITS
COMMAND” in the appropriate manner, by the system
software. However, setting MR2n[5] = 1 allows the
Channel Transmitter to negate RTS automatically, one bit
time after the characters in the TSR and THR have been
transmitted and are now empty.
Figure 44 presents a diagram illustrate how a
Transmitter-Controlled Request-to-Send configuration
would function.
MR2n[4] - Clear to Send Control
If this bit is a 0, the channels -CTSn input (IP0 for Channel
A, or IP1 for Channel B) has no effect on the transmitter. If
the bit is a “1”, the transmitter will check the state of its
-CTSn input each time is it ready to send a character. If
-CTSn is low (or “true”), the character is transmitted. If
-CTSn is high (or negated), TXDn remains in the marking
state and the transmission of the next character is
delayed until -CTSn goes low. Changes in the -CTSn
input while a character is being serialized do not affect
transmission of that character. This phenomenon is
further illustrated in
Figure 42 and Figure 44.
相关PDF资料 |
PDF描述 |
|---|---|
| AT89C51RB2-RLRIM | IC MCU FLASH 8051 16K 5V 44-VQFP |
| XR16V2550IM-F | IC UART FIFO 16B 48TQFP |
| MAX7311AWG+T | IC I/O EXPANDER I2C 16B 24SOIC |
| XR16L2750CM-F | IC UART FIFO 64B DUAL 48TQFP |
| XR20M1172IL32-F | IC UART FIFO I2C/SPI 64B 32QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XR88C681J | 制造商:Exar Corporation 功能描述: |
| XR88C681J-F | 功能描述:UART 接口集成电路 0.5V-2V UART temp -45 to 85C RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| XR88C681JTR-F | 功能描述:UART 接口集成电路 Dual Channel UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| XR88C681MN-S0968 | 制造商:Exar Corporation 功能描述: |
| XR88C681N/40 | 制造商:EXAR 制造商全称:EXAR 功能描述:CMOS DUAL CHANNEL UART (DUART) |
发布紧急采购，3分钟左右您将得到回复。