参数资料
| 型号： | XRT75L04IV |
| 厂商： | Exar Corporation |
| 文件页数： | 2/57页 |
| 文件大小： | 0K |
| 描述： | IC LIU E3/DS3/STS-1 4CH 176LQFP |
| 标准包装： | 72 |
| 类型： | 线路接口装置（LIU） |
| 驱动器/接收器数： | 4/4 |
| 规程： | DS3，E3，STS-1 |
| 电源电压： | 3.135 V ~ 3.465 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 176-LQFP |
| 供应商设备封装： | 176-TQFP（24x24） |
| 包装： | 托盘 |
第1页当前第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页
XRT75L04
8
FOUR CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
REV. 1.0.4
91
100
130
121
REQEN_0
REQEN_1
REQEN_2
REQEN_3
I
Receive Equalizer On/Off - Channel 0:
Receive Equalizer On/Off- Channel 1:
Receive Equalizer On/Off - Channel 2:
Receive Equalier On/Off- Channel 3:
Tie these pins “High” to enable the receive equalizer.
NOTES:
1.
This input pin is ignored and should be connected to GND if the
XRT75L04 is operating in the HOST Mode
2.
This pin is internally pulled down.
87
RxON/
SDI
I
Hardware Mode: Receiver Turn ON Input
Host Mode: Serial Data Input:
Function of this pin depends on whether the XRT75L04 is configured to operate
in Hardware mode or Host mode.
In Hardware mode, setting this input pin “High” turns on and enables the
Receivers of all three channels.
NOTES:
1.
If the XRT75L04 is configured in HOST mode, this pin functions as
SDI input pin (please refer to the pin description for Microprocessor
Interface)
2.
This pin is internally pulled down.
86
RxClkINV/
CS
I
Hardware Mode: RxClk INVERT
Host Mode: Chip Select:
Function of this pin depends on whether the XRT75L04 is configured to operate
in Hardware mode or Host mode.
In Hardware mode, setting this input pin “High” configures the Receiver Sec-
tion of all channels to invert the RxClk_n output signals and outputs the recov-
ered data via RPOS_n and RNEG_n on the falling edge of RxClk_n.
NOTE: If the XRT75L04 is configured in HOST mode, this pin functions as CS
input pin (please refer to the pin description for Microprocessor
Interface).
85
RxMON/
SDO
I
Hardware Mode: Receive Monitoring Mode
Host Mode: Serial Data Output:
In Hardware mode, when this pin is tied “High” all 4 channels configure into
monitoring channels. In the monitoring mode, the Receiver is capable of moni-
toring the signals with 20 dB flat loss plus 6 dB cable attenuation. This allows
monitoring very weak signal before declaring LOS.
In HOST Mode each channel can be independently configured to be a monitor-
ing channel by setting the bits in the channel control registers.
NOTE: If the XRT75L04 is configured in HOST mode, this pin functions as SDO
pin (please refer to the pin description for the Microprocessor Interface).
RECEIVE INTERFACE
PIN #SIGNAL NAME
TYPE
DESCRIPTION
相关PDF资料 |
PDF描述 |
|---|---|
| VI-23W-MY | CONVERTER MOD DC/DC 5.5V 50W |
| XRT75L03DIVTR-F | IC LIU E3/DS3/STS-1 3CH 128LQFP |
| IDT72835LB15PF | IC FIFO SYNC DL 2048X18 128TQFP |
| XRT75L06IB | IC LIU E3/DS3/STS-1 6CH 217BGA |
| ISL26132AVZ-T | IC ADC 24BIT SRL 80SPS 24TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT75L04IV-F | 功能描述:外围驱动器与原件 - PCI 4-Ch DS3, E3, STS-1 RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| XRT75L04IVTR | 功能描述:时钟合成器/抖动清除器 4CH E3/DS3/STS1 JITTER ATTENUATOR RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel |
| XRT75L04IVTR-F | 功能描述:时钟合成器/抖动清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel |
| XRT75L06 | 制造商:EXAR 制造商全称:EXAR 功能描述:SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR |
| XRT75L06D | 制造商:EXAR 制造商全称:EXAR 功能描述:SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER |
发布紧急采购，3分钟左右您将得到回复。