参数资料
型号: YKNIFEX4HW
英文描述: IC APEX 20KE FPGA 100K
中文描述: 耶洛奈夫参考平台硬件设计手册
文件页数: 8/24页
文件大小: 186K
代理商: YKNIFEX4HW
Yellowknife X4 Hardware Reference Manual
Page 15 /22
Motorola Inc.
Unrestricted Distribution Permitted
98 Feb 20
In full operating mode, VCC = 5V, and the supply current is exclusively due to the SRAM
(the APC does not draw power from the battery in this state) so the current demand is less
than 20mA. VBAT will be supplied through the VCC-to-VBAT diode. The battery pro-
tection diode will be reverse biased so no current drain will occur until VCC drops below
4.15V.
Note also that since the SRAM is not operated at VCC, but at VCC-VF, it is necessary to
insure that inputs do not exceed the SRAM’s maximum ratings of VCC-0.3V by using
low-voltage TTL components to isolate the SRAM from the rest of the system. When the
system is battery powered, the inputs are not driven so limits are cannot be exceeded.
Under system power, the voltage to the SRAM is within this range even at high currents
and low temperatures due to the 3.3V TTL drivers. Variations in the system VCC supply
will match variations in the VSRAM so the SRAM is safe from overvoltages.
2.13 I/O Ports
There are numerous I/O ports on the Yellowknife platform. Some are connectors located
on the back panel in accordance with ATX chassis guidelines, others are attached via
cables. The parallel, keyboard , mouse, and two serial connectors are on the back panel of
the ATX chassis, eliminating cabling. These connectors are equivalent with standard PC-
type connectors. Inside the chassis, the motherboard containsconnectors for cables to IDE
and SCSI disk drives, a oppy disk, and an IrDA transciever.
The oppy connector is a standard CHRP connector, which is not the same as that used on
a PC, though it is very similar. In particular, several pins have been redened:
The keyboard and mouse connections are 6-pin mini-DIN connectors for PS/2-type
devices, similar to most modern PCs. The voltage supply for the keyboard and mouse is
protected by a self-resetting fuse instead of the typical self-destructive fuse, as specied
by the PC’97 guidelines.
The two serial ports are driven with the 75LP185. The ‘LP185 is preferred because it has
the ability to withstand 15kV ESD discharges without external circuitry. Equivalent parts
such as the 75C185 are also available, but without the ESD protection. Many other manu-
facturers make suitable parts that may be used, such as the Maxim MAX211. If non-ESD
protected parts are chosen, additional protection will be needed on the serial port signals.
The IrDA connector allows cabling to a standard IrDA modules available from a wide
variety of sources, such as Hewlett-Packard, Novalog, etc.
Table 3: Floppy Connector Changes
Pin
Old
Function
New
Function
Description
1
GND
F_EJECT#
Low strobe ejects the oppy.
3
GND
NC
Key
4
NC
MSEN0
Media sense 0.
相关PDF资料
PDF描述
YL001U2V2A1N 4 & 6 Tumbler Camlocks
YL202EW030R PULSE CAPACITORS FOR FLASH LAMP APPLICATIONS
YL202EW055R PULSE CAPACITORS FOR FLASH LAMP APPLICATIONS
YL2LUR61D T-3/4 SINGLE COLOR LED ARRAY, RED, 1.8 mm
YL352EW013R PULSE CAPACITORS FOR FLASH LAMP APPLICATIONS
相关代理商/技术参数
参数描述
YKP1568VG5 制造商:INTEGRAL 制造商全称:INTEGRAL 功能描述:8 - BIT MICROCONTROLLER FOR REMOTE CONTROL TRANSMITTERS
YKS1MNG1752A 制造商:KYOCERA Corporation 功能描述:VOLT CONTROLLED OSCILLATORS
YKW-06 制造商:WELTREND 制造商全称:WELTREND 功能描述:Step-down Switching Controller
YL00132A2A1N 制造商:C&K Components 功能描述:Switch Key Lock SPDT 90? Flat Key Panel Mount
YL00132A8A1N 功能描述:键锁开关 SWITCHLOCK RoHS:否 制造商:C&K Components 触点形式:1 Form A (SPST-NO) 开关功能:Momentary 触点额定值: 电流额定值:100 mA 电压额定值 AC:250 VAC 端接类型:Through Hole 键类型:Keyswitch 变址: 位置数量:1 外壳材料: