收藏本站
参数资料
型号： 20-101-1051
厂商： Rabbit Semiconductor
文件页数： 100/164页
文件大小： 0K
描述： MODULE RABBITCORE RCM3365
标准包装： 1
系列： RabbitCore®
模块/板类型： MPU 核心模块
适用于相关产品： RCM3365
其它名称： 316-1111
34
RabbitCore RCM3365/RCM3375
4.2 Serial Communication
The RCM3365/RCM3375 does not have any serial transceivers directly on the board.
However, a serial interface may be incorporated into the board the RCM3365/RCM3375
is mounted on. For example, the Prototyping Board has RS-232 and RS-485 transceiver
chips.
4.2.1 Serial Ports
There are six serial ports designated as Serial Ports A, B, C, D, E, and F. All six serial
ports can operate in an asynchronous mode up to the baud rate of the system clock divided
by 8. An asynchronous port can handle 7 or 8 data bits. A 9th bit address scheme, where
an additional bit is sent to mark the first byte of a message, is also supported.
Serial Port A is normally used as a programming port, but may be used either as an asyn-
chronous or as a clocked serial port once the RCM3365/RCM3375 has been programmed
and is operating in the Run Mode.
Serial Port B is available on the RCM3365/RCM3375, and may be used as an
asynchronous port. PB0 is used to enable Dynamic C to detect whether the xD-Picture
Card is installed. If the card detect is not needed by your application program, you may
remove R96 (see Figure A-5) to disable the xD-Picture Card detect, and then use Serial
Port B as a clocked serial port.
Serial Ports C and D can also be operated in the clocked serial mode. In this mode, a clock
line synchronously clocks the data in or out. Either of the two communicating devices can
supply the clock.
Serial Ports E and F can also be configured as HDLC serial ports. The IrDA protocol is
also supported in SDLC format by these two ports.
4.2.2 Ethernet Port
Figure 8 shows the pinout for the RJ-45 Ethernet port (J2). Note that some Ethernet
connectors are numbered in reverse to the order used here.
Figure 8. RJ-45 Ethernet Port Pinout
Three LEDs are placed next to the RJ-45 Ethernet jack, one to indicate an Ethernet link
(LINK) one to indicate Ethernet activity (ACT), and one to indicate the 10/100Base-T speed.
The RJ-45 connector is shielded to minimize EMI effects to/from the Ethernet signals.
ETHERNET
RJ-45 Plug
1. E_Tx+
2. E_Tx
3. E_Rx+
6. E_Rx
1
8
RJ-45 Jack
相关PDF资料
PDF描述
305-030-520-204 CONN CARDEDGE 30POS .156 GREEN
20-101-1196 MODULE RABBITCORE RCM3900
20-101-1105 MODULE RCM4100 RABBITCORE
20-101-1028 MODULE RABBITCORE RCM3750
046232104015800+ CONN FFC/FPC 4POS 1MM VERT SMD
相关代理商/技术参数
参数描述
20-101-1055 功能描述:模块化系统 - SOM RCM3375 RABBITCORE RoHS:否 制造商:Digi International 外观尺寸:ConnectCore 9P 处理器类型:ARM926EJ-S 频率:150 MHz 存储容量:8 MB, 16 MB 存储类型:NOR Flash, SDRAM 接口类型:I2C, SPI, UART 工作电源电压:3.3 V 最大工作温度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-1066 功能描述:模块化系统 - SOM RCM3720 PROTO RS232 RoHS:否 制造商:Digi International 外观尺寸:ConnectCore 9P 处理器类型:ARM926EJ-S 频率:150 MHz 存储容量:8 MB, 16 MB 存储类型:NOR Flash, SDRAM 接口类型:I2C, SPI, UART 工作电源电压:3.3 V 最大工作温度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-1067 功能描述:模块化系统 - SOM RCM3305 MODULE RoHS:否 制造商:Digi International 外观尺寸:ConnectCore 9P 处理器类型:ARM926EJ-S 频率:150 MHz 存储容量:8 MB, 16 MB 存储类型:NOR Flash, SDRAM 接口类型:I2C, SPI, UART 工作电源电压:3.3 V 最大工作温度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-1068 功能描述:模块化系统 - SOM RCM3315 MODULE RoHS:否 制造商:Digi International 外观尺寸:ConnectCore 9P 处理器类型:ARM926EJ-S 频率:150 MHz 存储容量:8 MB, 16 MB 存储类型:NOR Flash, SDRAM 接口类型:I2C, SPI, UART 工作电源电压:3.3 V 最大工作温度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-1087 制造商:Digi International 功能描述:RCM3365 RABBITSYS - Bulk 制造商:Digi International Inc 功能描述:BOARD PROTO RCM3365 RS232 制造商:Rabbit Semiconductor 功能描述:RCM3365 Rabbit Sys
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*