参数资料
型号: 71M6515H-IGT/F
厂商: MAXIM INTEGRATED PRODUCTS INC
元件分类: 模拟信号调理
英文描述: SPECIALTY ANALOG CIRCUIT, PQFP64
封装: LEAD FREE, LQFP-64
文件页数: 41/60页
文件大小: 826K
代理商: 71M6515H-IGT/F
71M6515H
Energy Meter IC
DATA SHEET
JULY 2011
Page: 46 of 60
2005
2011 Teridian Semiconductor Corporation
1.6
A Maxim Integrated Products Brand
If higher precision is required, the host must calculate the RMS voltages from the values in the VASQSUM, VBSQSUM, and
VCSQSUM registers.
Example: The register VRMS_B reads the value 425,778,000. Assuming VMAX to be 600V, and using the
formula above, we determine the RMS voltage of phase B to:
V
RMS
85
.
226
60
600
10
8781
.
6
425778000
9
=
=
WH_A (0x00), WH_B (0x01), WH_C (0x02)
These registers hold the real energy collected during the previous accumulation interval. The magnitude of the values is
determined by:
Wh
In
IMAX
VMAX
LSB
8
_
10
4045
.
9
13
=
Example: The register WH_A reads the value 236,675 for one accumulation interval of one second. Assuming
600V for VMAX, 208A for IMAX, and unity gain, we determine the real energy to be:
E = 236,675*600*208*9.4045*10
-13 Wh = 0.0277781Wh.
By multiplying with 3,600, we get 100Wh/h, which means the applied power is 100W.
FREQ_DELTA_T (0x11)
This register holds frequency and temperature information in two bytes each.
Bits 31-16: These bits (FREQUENCY) represent the frequency of the input signal selected with the F_SELECT bit of the
CONFIG register. One LSB is equivalent to 0.1Hz.
MAIN_EDGE_CNT (0x35)
This register holds the number of zero crossings of the input phase selected by the F_SELECT bits in the CONFIG register
detected in the previous accumulation interval. The value in MAIN_EDGE_CNT can be used by the host to correct its own
RTC or to synchronize events to the line voltage.
Registers Controlling Alarms and Thresholds
CREEP_THRSLD (0x1D)
The four bytes written to this register determine the creep threshold. Setting a creep threshold helps suppressing I2H, Wh
and VARh readings when the values of WSUM and VARSUM are determined to be below the creep threshold.
Example: The creep threshold of a meter operating with an accumulation interval of 1000ms is to be configured
to be 15mA at 240V. The meter is using a VMAX of 600V, an IMAX of 208A, and is not using the additional gain
of 8. The numerical value for the CREEP_THRSLD register is to be determined.
With 15mA, the power per phase will be 3.6W, or 0.001Wh per second. With the LSB of WSUM readings given
as 9.4045*10
-13*VMAX*IMAX [Wh], we determine the value to:
n = 0.001Wh / (9.4045*10
-13*VMAX*IMAX /In_8 Wh) = 8520.2
The rounded down value of 8520 is written to the CREEP_THRSLD register.
SAG (0x2E)
This register holds the voltage and timing threshold for sag detection.
Bits 15-0: These bits (SAG_CNT) hold the sag count. A sag condition must persist for at least SAG_CNT samples before a
sag alarm is generated. The allowed range is 1 to (2
15-1), and the default is 80 (31.7ms). The time period defined by
SAG_CNT is:
T = SAG_CNT*397
s
相关PDF资料
PDF描述
7234 SPECIALTY ANALOG CIRCUIT, CDIP22
7244 SPECIALTY ANALOG CIRCUIT, PDIP20
7250 SPECIALTY ANALOG CIRCUIT, PDIP16
73S8009CN-32IMR/F SPECIALTY ANALOG CIRCUIT, QCC32
73S8009CN-32IM/F SPECIALTY ANALOG CIRCUIT, QCC32
相关代理商/技术参数
参数描述
71M6515H-IGTR 制造商:Maxim Integrated Products 功能描述:71M6515H-IGT - T/REEL - Tape and Reel 制造商:Maxim Integrated Products 功能描述:Metering Systems on a Chip - SoC Energy Meter IC
71M6515H-IGTR/F 功能描述:计量片上系统 - SoC Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6515H-IGTW/F 功能描述:计量片上系统 - SoC Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6515H-IGTW1 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Up to 10ppmC precision ultra-stable voltage reference Digital temperature compensation
71M6515H-IGTWR1 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Up to 10ppmC precision ultra-stable voltage reference Digital temperature compensation