- 您现在的位置：买卖IC网 > PDF目录294782 > A1280A-1CQG172M FPGA, 1232 CLBS, 8000 GATES, 60 MHz, CQFP172 PDF资料下载
参数资料
| 型号： | A1280A-1CQG172M |
| 元件分类： | FPGA |
| 英文描述： | FPGA, 1232 CLBS, 8000 GATES, 60 MHz, CQFP172 |
| 封装： | CERAMIC, CQFP-172 |
| 文件页数： | 4/54页 |
| 文件大小： | 333K |
| 代理商： | A1280A-1CQG172M |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
RadTolerant FPGAs
1- 8
v3.1
Package Thermal Characteristics
The device junction to case thermal characteristic is
θ
jc,
and the junction to ambient air characteristic is
θ
ja. The
thermal characteristics for
θ
ja are shown with two
different air flow rates.
Maximum junction temperature is 150°C.
A sample calculation of the absolute maximum power
dissipation allowed for a CQFP 172-pin package at
military temperature is as follows:
EQ 1-2
Power Dissipation
General Power Equation
P = [ICCstandby + ICCactive] * VCC + IOL * VOL * N +
IOH * (VCC – VOH) * M
EQ 1-3
where:
ICCstandby is the current flowing when no inputs
or outputs are changing.
ICCactive is the current flowing due to CMOS
switching.
IOL, IOH are TTL sink/source currents.
VOL, VOH are TTL level output voltages.
N equals the number of outputs driving TTL loads
to VOL.
M equals the number of outputs driving TTL loads
to VOH.
Accurate values for N and M are difficult to determine
because they depend on the family type, on design
details, and on the system I/O. The power can be divided
into two components: static and active.
Static Power Component
Actel FPGAs have small static power components that
result in power dissipation lower than that of PALs or
PLDs. By integrating multiple PALs or PLDs into one
FPGA, an even greater reduction in board-level power
dissipation can be achieved.
The power due to standby current is typically a small
component of the overall power. Standby power is
calculated below for commercial, worst-case conditions.
The static power dissipated by TTL loads depends on the
number of outputs driving HIGH or LOW and on the DC
load current. Again, this value is typically small. For
instance, a 32-bit bus sinking 4 mA at 0.33 V will
generate 42 mW with all outputs driving LOW, and
140 mW with all outputs driving HIGH.
Table 1-6 Package Thermal Characteristics
Package Type
Pin Count
θ
jc
θ
ja
Still Air
θ
ja
300 ft./min.
Units
Ceramic Quad Flat Pack
8
7.8
40
30
°C/W
132
7.2
35
25
°C/W
172
6.8
25
20
°C/W
196
6.4
23
15
°C/W
256
6.2
20
10
°C/W
Max. junction temp. (°C) – Max. military temp.
θ
ja
°C/W
()
-----------------------------------------------------------------------------------------------------------------------
150°C – 125°C
25°C/W
---------------------------------------1.0W
==
ICC
VCC
Power
2 mA
5.25 V
10.5 mW
相关PDF资料 |
PDF描述 |
|---|---|
| A1280A-CQG172B | FPGA, 1232 CLBS, 8000 GATES, 41 MHz, CQFP172 |
| A1280A-CQG172M | FPGA, 1232 CLBS, 8000 GATES, 41 MHz, CQFP172 |
| A1020B-CQ84C | FPGA, 547 CLBS, 2000 GATES, 37 MHz, CQFP84 |
| A14100A-1CQ256B | FPGA, 1377 CLBS, 30000 GATES, 100 MHz, CQFP256 |
| A1280A-1CQ172E | FPGA, 1232 CLBS, 8000 GATES, 60 MHz, CQFP172 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A1280A-1CQG176B | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
| A1280A-1CQG176C | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
| A1280A-1CQG176I | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
| A1280A-1CQG176M | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
| A1280A-1PG160B | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:ACT 2 Family FPGAs |
发布紧急采购，3分钟左右您将得到回复。