参数资料
型号: A8502KLPTR-T
厂商: Allegro Microsystems Inc
文件页数: 13/35页
文件大小: 0K
描述: IC LED DVR WHITE MULTI 16-TSSOP
标准包装: 8,000
拓扑: PWM,升压(升压)
输出数: 2
内部驱动器:
类型 - 主要: 车载,背光
类型 - 次要: 白色 LED
频率: 580kHz ~ 2MHz
电源电压: 5 V ~ 40 V
安装类型: 表面贴装
封装/外壳: 16-TSSOP(0.173",4.40mm)裸露焊盘
供应商设备封装: 16-TSSOP-EP
包装: 带卷 (TR)
工作温度: -40°C ~ 125°C
A8502
Wide Input Voltage Range, High Efficiency
Fault Tolerant LED Driver
If a LEDx pin is shorted to ground the A8502 will not proceed
with soft start until the short is removed from the LEDx pin. This
prevents the A8502 from powering-up and putting an uncon-
trolled amount of current through the LEDs.
Inrush current caused by
Soft start function
During soft start the LEDx pins are set to sink (I LEDSS ) and the
boost switch current is reduced to the I SWSS(LIM) level to limit
the inrush current generated by charging the output capacitors.
When the converter senses that there is enough voltage on the
LEDx pins the converter proceeds to increase the LED current to
the preset regulation current and the boost switch current limit is
switched to the I SW(LIM) level to allow the A8502 to deliver the
necessary output power to the LEDs. This is shown in figure 6.
Frequency selection
The switching frequency on the boost regulator is set by the resis-
C1
C2
C3
C4
enabling the disconnect
switch (when used)
I OUT
I IN
V OUT
PWM/EN
Operation during
I SWSS(lim)
Normal operation
I SW(lim)
tor connected to the FSET/SYNC pin. The switching frequency
can be can be anywhere from 580 kHz to 2.3 MHz. Figure 7
shows the typical switching frequencies, in MHz, for given resis-
t
Figure 6. Startup diagram showing the input current, output voltage, and
output current; shows I OUT (ch1, 200 mA/div.), I IN (ch2, 1 A/div.), V OUT
(ch3, 20 V/div.), and PWM/EN (ch4, 5 V/div.), time = 1 ms/div.
tor values, in k Ω .
In case during operation a fault occurs that will increase the
switching frequency, the FSET/SYNC pin is clamped to a
maximum switching frequency of no more than 3.5 MHz. If the
FSET/SYNC pin is shorted to GND the part will shut down. For
more details see the Fault Mode table later in this datasheet.
2.1
1.9
A8502
A8502
1.7
1.5
1.3
1.1
GND
LED1
LED2
GND
LED1
LED2
0.9
0.7
0.5
1.54 k Ω
10.0
12.5
15.0
17.5
20.0
22.5
25.0
30.0
32.5
35.0
Resistance for R SET (k Ω )
Figure 5. Channel select setup: (left) using only channel LED1,
(right) using both channels.
Figure 7. Typical Switching Frequency versus value of R FSET resistor.
Allegro MicroSystems, LLC
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
13
相关PDF资料
PDF描述
A8504EECTR-T IC LED DRVR WHT/RGB BCKLGT 26QFN
A8507ELBTR-T IC DRIVER WLED/RGB 24-SOIC
A8508GLPTR-T IC LED DVR WHITE 8X120MA 24TSSOP
A8509GLPTR-T IC LED DVR WHITE 4X120MA 24TSSOP
A8510GECTR-T IC LED DRVR BCKLGHT/WHT 26QFN-EC
相关代理商/技术参数
参数描述
A8503 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:High Efficiency 6-Channel, 2 MHz, WLED/RGB Driver
A8503EECTR-T 功能描述:IC LED DRVR WHT/RGB BCKLGT 26QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:1 系列:- 恒定电流:- 恒定电压:- 拓扑:PWM,切换式电容器(充电泵) 输出数:1 内部驱动器:是 类型 - 主要:背光 类型 - 次要:白色 LED 频率:642kHz 电源电压:2.7 V ~ 5.5 V 输出电压:5V 安装类型:表面贴装 封装/外壳:10-VFDFN 裸露焊盘 供应商设备封装:10-VSON 包装:剪切带 (CT) 工作温度:-30°C ~ 85°C 产品目录页面:1371 (CN2011-ZH PDF) 其它名称:BD1603NUV-E2CT
A8503GECTR-T 功能描述:IC LED DVR WHT/RGB BKLGT 26QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 恒定电流:- 恒定电压:- 拓扑:升压(升压),切换式电容器(充电泵) 输出数:1 内部驱动器:是 类型 - 主要:背光 类型 - 次要:白色 LED 频率:625kHz ~ 875kHz 电源电压:2.7 V ~ 5.3 V 输出电压:5V 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽) 供应商设备封装:10-µMAX 包装:带卷 (TR) 工作温度:-40°C ~ 85°C
A8504 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:WLED/RGB Backlight Driver for Medium Size LCDs
A8504910100N 功能描述:环形MIL规格后盖 Backshell, Envrn, EMI/RFI, Strt, Nickel, Size 48 RoHS:否 制造商:Amphenol PCD MIL 类型:MIL-DTL-38999 III, IV 系列:AS85049 产品类型:Environmental EMI/RFI Backshells 外壳类型:Straight 外壳大小:18 外壳材质:Aluminum Alloy