参数资料
型号: AD650KNZ
厂商: Analog Devices Inc
文件页数: 15/20页
文件大小: 385K
描述: IC CONVERTER V-F/F-V 14DIP
标准包装: 25
类型: 电压至频率和频率至电压
频率 - 最大: 1MHz
全量程: ±150ppm/°C
线性: ±0.1%
安装类型: 通孔
封装/外壳: 14-DIP(0.300",7.62mm)
供应商设备封装: 14-PDIP
包装: 管件
产品目录页面: 786 (CN2011-ZH PDF)
Data Sheet
AD650
 
Rev. E | Page 15 of 20
A second major difference is that the output only sinks 1 mA to
the negative supply. There is no pulldown stage at the output
other than the 1 mA current source used for the V-to-F
conversion. The op amp sources a great deal of current from the
positive supply, and it is internally protected by current limiting.
The output of the op amp can be driven to within 3 V of the
positive supply when it is not sourcing external current. When
sourcing 10 mA the output voltage can be driven to within 6 V
of the positive supply.
A third difference between this op amp and a normal device is
that the inverting input, Pin 3, is bias current compensated and
the noninverting input is not bias-current compensated. The
bias current at the inverting input is nominally zero, but can be
as much as 20 nA in either direction. The noninverting input
typically has a bias current of 40 nA that always flows into the
node (an npn input transistor). Therefore, it is not possible to
match input voltage drops due to bias currents by matching
input resistors.
The op amp has provisions for trimming the input offset
voltage. A potentiometer of 20 k?is connected from Pin 13 to
Pin 14 and the wiper is connected to the positive supply
through a 250 k?resistor. A potential of about 0.6 V is
established across the 250 k?resistor, and the 3 糀 current is
injected into the null pins. It is also possible to null the op amp
offset voltage by using only one of the null pins and by using a
bipolar current either into or out of the null pin. The amount of
current required is very smalltypically less than 3 糀. This
technique is shown in the Applications section of this data
sheet; the autozero circuit uses this technique.
The bipolar offset current is activated by connecting a 1.24 k?
resistor between Pin 4 and the negative supply. The resulting
current delivered to the op amp noninverting input is nominally
0.5 mA and has a tolerance of ?0%. This current is then used
to provide an offset voltage when Pin 2 is tied to ground through
a resistor. The 0.5 mA that appears at Pin 2 is also flowing
through the 1.24 k?resistor. An external resistor is used to
activate the bipolar offset current source to provide the lowest
tolerance and temperature drift of the resulting offset voltage.
It is possible to use other values of resistance between Pin 4 and
V
S
 to obtain a bipolar offset current different from 0.5 mA.
Figure 19 shows the relationship between the bipolar offset
current and the value of the resistor used to activate the source.
&
200
500
4000
EXTERNAL RESISTOR
400
600
800
1000
1000
1500
2000
2500
3000
3500
 
Figure 19. Bipolar Offset Current vs. External Resistor
 
相关PDF资料
PDF描述
RBC13DRYN CONN EDGECARD 26POS .100 EXTEND
IDT71256SA15TPI IC SRAM 256KBIT 15NS 28DIP
VI-J1R-CX-F1 CONVERTER MOD DC/DC 7.5V 75W
V28A36C200BG2 CONVERTER MOD DC/DC 36V 200W
AD7741YRZ IC CONVERTER VOLT TO FREQ 8SOIC
相关代理商/技术参数
参数描述
AD650KNZ 制造商:Analog Devices 功能描述:IC VOLTAGE CONVERTER
AD650KP 制造商:未知厂家 制造商全称:未知厂家 功能描述:Converter
AD650S 制造商:AD 制造商全称:Analog Devices 功能描述:Voltage-to-Frequency and Frequency-to-Voltage Converter
AD650SD 功能描述:IC V-F/F-V CONV 1MHZ 14-CDIP RoHS:否 类别:集成电路 (IC) >> PMIC - V/F 和 F/V 转换器 系列:- 标准包装:1 系列:- 类型:频率至电压 频率 - 最大:10kHz 全量程:- 线性:±0.3% 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 供应商设备封装:8-SOIC 包装:Digi-Reel® 其它名称:LM2917MX-8/NOPBDKR
AD650SD/883B 功能描述:电压频率转换及频率电压转换 IC - V/F CONVERTER IC RoHS:否 制造商:Texas Instruments 全标度频率:4000 KHz 线性误差:+/- 1 % FSR 电源电压-最大: 电源电压-最小: 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格:Through Hole 封装 / 箱体:PDIP-14 封装:Tube