- 您现在的位置：买卖IC网 > PDF目录10571 > AD7452BRTZ-R2 (Analog Devices Inc)IC ADC 12BIT 555KSPS SOT23-8 PDF资料下载
参数资料
| 型号： | AD7452BRTZ-R2 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 16/29页 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 555KSPS SOT23-8 |
| 标准包装： | 1 |
| 位数： | 12 |
| 采样率（每秒）： | 555k |
| 数据接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 7.25mW |
| 电压电源： | 单电源 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-8 |
| 供应商设备封装： | SOT-23-8 |
| 包装： | 标准包装 |
| 输入数目和类型： | 1 个差分，双极 |
| 产品目录页面： | 777 (CN2011-ZH PDF) |
| 其它名称： | AD7452BRTZ-R2DKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
AD7452
Rev. B | Page 22 of 28
POWER VS. THROUGHPUT RATE
By using the power-down mode on the AD7452 when not con-
verting, the average power consumption of the ADC decreases
at lower throughput rates. Figure 39 shows how, as the through-
put rate is reduced, the device remains in its power-down state
longer and the average power consumption is reduced
accordingly. It shows this for both 5 V and 3 V power supplies.
For example, if the AD7452 is operated in continuous sampling
mode with a throughput rate of 100 kSPS and an SCLK of
10 MHz, and the device is placed in power-down mode between
conversions, the power consumption is calculated as follows:
Power Dissipation during Normal Operation = 7.25 mW max
(for VDD = 5 V)
If the power-up time is one dummy cycle (1.06 s if CS is
brought high after the 10th SCLK falling edge and then brought
low after the quiet time) and the remaining conversion time is
another cycle, i.e., 1.6 s, the AD7452 can be said to dissipate
7.25 mW for 2.66 s
during each conversion cycle.
If the throughput rate = 100 kSPS, the cycle time = 10 s and
the average power dissipated during each cycle is
(2.66/10) × 7.25 mW = 1.92 mW
For the same scenario, if VDD = 3 V, the power dissipation during
normal operation is 3.3 mW max.
The AD7452 can now be said to dissipate 3.3 mW for 2.66 s
during each conversion cycle.
The average power dissipated during each cycle with a
throughput rate of 100 kSPS is therefore
(2.66/10) × 3.3 mW = 0.88 mW
This is how the power numbers in Figure 39 are calculated.
For throughput rates above 320 kSPS, it is recommended that
the serial clock frequency be reduced for optimum power
performance.
This figure assumes a very short time to enter power-down mode. This
increases as the burst of clocks used to enter the power-down mode is
increased.
THROUGHPUT (kSPS)
100
0
350
P
O
WE
R
(mW)
0.01
50
100
150
200
250
300
0.1
1
10
VDD = 5V
VDD = 3V
03154-A
-039
Figure 39. Power vs. Throughput Rate for Power-Down Mode
MICROPROCESSOR AND DSP INTERFACING
The serial interface on the AD7452 allows the part to be directly
connected to a range of different microprocessors. This section
explains how to interface the AD7452 with some of the more
common microcontroller and DSP serial interface protocols.
AD7452 to ADSP-21xx
The ADSP-21xx family of DSPs is interfaced directly to the
AD7452 without any glue logic required.
The SPORT control register should be set up as follows:
TFSW = RFSW = 1, Alternate Framing
INVRFS = INVTFS = 1, Active Low Frame Signal
DTYPE = 00, Right-Justify Data
SLEN = 1111, 16-Bit Data-Words
ISCLK = 1, Internal Serial Clock
TFSR = RFSR = 1, Frame Every Word
IRFS = 0
ITFS = 1
To implement power-down mode, SLEN should be set to 1001
to issue an 8-bit SCLK burst.
The connection diagram is shown in Figure 40. The ADSP-21xx
has the TFS and RFS of the SPORT tied together, with TFS set
as an output and RFS set as an input. The DSP operates in
alternate framing mode and the SPORT control register is set
up as described. The frame synchronization signal generated on
the TFS is tied to CS and, as with all signal processing
applications, equidistant sampling is necessary. However in this
example, the timer interrupt is used to control the sampling rate
of the ADC; under certain conditions, equidistant sampling may
not be achieved.
相关PDF资料 |
PDF描述 |
|---|---|
| PX0921/04/S | CONN RCPT 4POS W/SOCKET |
| VE-JT4-MW-F3 | CONVERTER MOD DC/DC 48V 100W |
| SP3245ECY-L | IC TXRX RS233 28TSSOP |
| VE-JVY-MY-F4 | CONVERTER MOD DC/DC 3.3V 33W |
| VE-JT4-MW-F1 | CONVERTER MOD DC/DC 48V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD7452BRTZ-REEL7 | 功能描述:IC ADC 12BIT DIF 555KSPS SOT23-8 RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7453 | 制造商:AD 制造商全称:Analog Devices 功能描述:Pseudo Differential, 555 kSPS, 12-Bit ADC in an 8-Lead SOT-23 |
| AD7453ART-REEL7 | 制造商:Analog Devices 功能描述: |
| AD7453ARTZ-REEL7 | 功能描述:IC ADC 12BIT DFF 600KSPS SOT23-8 RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7453BRT-R2 | 制造商:Analog Devices 功能描述:ADC Single SAR 555ksps 12-bit Serial 8-Pin SOT-23 T/R 制造商:Rochester Electronics LLC 功能描述:12-BIT P/DIFF I/PUT, 600KSPS ADC I.C. - Bulk |
发布紧急采购，3分钟左右您将得到回复。