参数资料
| 型号： | AD9276BSVZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 22/48页 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT LNA/VGA/AAF 100TQFP |
| 标准包装： | 1 |
| 类型： | AAF，ADC，解调器，LNA，VGA |
| 分辨率（位）： | 12 b |
| 采样率（每秒）： | 10M ~ 80M |
| 数据接口： | 串行，SPI? |
| 电压电源： | 模拟和数字 |
| 电源电压： | 1.8V，3V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 100-TQFP 裸露焊盘 |
| 供应商设备封装： | 100-TQFP-EP（14x14） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页
AD9276
Rev. 0 | Page 29 of 48
TGC OPERATION
The TGC signal path is fully differential throughout to maxi-
mize signal swing and reduce even-order distortion; however,
the LNAs are designed to be driven from a single-ended signal
source. Gain values are referenced from the single-ended LNA
input to the differential ADC input. A simple exercise in under-
standing the maximum and minimum gain requirements is
shown in Figure 55.
The maximum gain required is determined by
(ADC Noise Floor/LNA Input Noise Floor) + Margin =
20 log(224/3.9) + 11 dB = 46 dB
The minimum gain required is determined by
(ADC Input FS/LNA Input FS) + Margin =
20 log(2/0.55) 10 dB = 3 dB
Therefore, 42 dB of gain range for a 12-bit, 40 MSPS ADC with
15 MHz of bandwidth should suffice in achieving the dynamic
range required for most of today’s ultrasound systems.
The system gain is distributed as listed in Table 9.
Table 9. Channel Gain Distribution
Section
Nominal Gain (dB)
LNA
15.6/17.9/21.3
Attenuator
42 to 0
VGA Amplifier
21/24/27/30
Filter
0
ADC
0
The linear-in-dB gain (law conformance) range of the TGC path
is 42 dB. The slope of the gain control interface is 28.5 dB/V,
and the gain control range is 0.8 V to +0.8 V. Equation 3 is the
expression for the differential voltage VGAIN, and Equation 4 is
the expression for the channel gain.
VGAIN (V) = (GAIN+) – (GAIN)
(3)
Gain (dB) = 28.5 dB/V × VGAIN + ICPT
(4)
where ICPT is the intercept point of the TGC gain.
In its default condition, the LNA has a gain of 21.3 dB (12×), and
the VGA postamp gain is 24 dB if the voltage on the GAIN+ pin
is 0 V and the voltage on the GAIN pin is 0.8 V (42 dB attenua-
tion). This results in a total gain (or ICPT) of 3.6 dB through
the TGC path if the LNA input is unmatched, or a total gain of
2.4 dB if the LNA is matched to 50 Ω (RFB = 350 Ω). However,
if the voltage on the GAIN+ pin is 1.6 V and the voltage on the
GAIN pin is 0.8 V (0 dB attenuation), the VGA gain is 24 dB.
This results in a total gain of 45 dB through the TGC path if the
LNA input is unmatched or in a total gain of 39 dB if the LNA
input is matched.
Each LNA output is dc-coupled to a VGA input. The VGA
consists of an attenuator with a range of 42 dB to 0 dB followed
by an amplifier with 21 dB/24 dB/27 dB/30 dB of gain. The
X-AMP gain interpolation technique results in low gain error
and uniform bandwidth, and differential signal paths minimize
distortion.
LNA FULL SCALE
(0.55V p-p SINGLE-ENDED)
LNA INPUT-REFERRED
NOISE FLOOR
(3.9V rms) @ AAF BW = 15MHz
LNA + VGA NOISE = 1.0nV/ Hz
MINIMUM GAIN
MAXIMUM GAIN
LNA
VGA GAIN RANGE > 42dB
MAX CHANNEL GAIN > 48dB
94dB
08
18
0
-04
9
Figure 55. Gain Requirements of TGC Operation for a 12-Bit, 40 MSPS ADC
相关PDF资料 |
PDF描述 |
|---|---|
| AD9277BSVZ | IC ADC 14BIT LNA/VGA/AAF 100TQFP |
| AD9278BBCZ | IC ADC 12BIT 50MSPS 144CSPBGA |
| AD9279BBCZ | IC ADC 12BIT 80MSPS 144CSPBGA |
| AD9393BBCZRL-80 | IC INTERFACE 80MHZ HDMI 76CSPBGA |
| AD9398KSTZ-150 | IC INTERFACE 150MHZ HDMI 100LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD9276XBCZ | 功能描述:IC ADC 12BIT LNA/VGA/AAF 制造商:analog devices inc. 系列:* 零件状态:上次购买时间 标准包装:1 |
| AD9276XSVZ | 功能描述:IC ADC 12BIT LNA/VGA/AAF 制造商:analog devices inc. 系列:* 零件状态:上次购买时间 标准包装:1 |
| AD9277 | 制造商:AD 制造商全称:Analog Devices 功能描述:Octal LNA/VGA/AAF/14-Bit ADC and CW I/Q Demodulator |
| AD9277-50EBZ | 功能描述:BOARD EVAL FOR AD9277 RoHS:是 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| AD9277BSVZ | 功能描述:IC ADC 14BIT LNA/VGA/AAF 100TQFP RoHS:是 类别:集成电路 (IC) >> 数据采集 - ADCs/DAC - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 类型:数据采集系统（DAS） 分辨率（位）:16 b 采样率（每秒）:21.94k 数据接口:MICROWIRE?，QSPI?，串行，SPI? 电压电源:模拟和数字 电源电压:1.8 V ~ 3.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:40-WFQFN 裸露焊盘 供应商设备封装:40-TQFN-EP（6x6） 包装:托盘 |
发布紧急采购，3分钟左右您将得到回复。