- 您现在的位置：买卖IC网 > PDF目录10978 > AD9832BRUZ-REEL (Analog Devices Inc)IC DDS 10BIT 25MHZ CMOS 16TSSOP PDF资料下载
参数资料
| 型号： | AD9832BRUZ-REEL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 5/28页 |
| 文件大小： | 0K |
| 描述： | IC DDS 10BIT 25MHZ CMOS 16TSSOP |
| 产品培训模块： | Direct Digital Synthesis Tutorial Series (1 of 7): Introduction Direct Digital Synthesizer Tutorial Series (7 of 7): DDS in Action Direct Digital Synthesis Tutorial Series (3 of 7): Angle to Amplitude Converter Direct Digital Synthesis Tutorial Series (6 of 7): SINC Envelope Correction Direct Digital Synthesis Tutorial Series (4 of 7): Digital-to-Analog Converter Direct Digital Synthesis Tutorial Series (2 of 7): The Accumulator |
| 标准包装： | 2,500 |
| 分辨率（位）： | 10 b |
| 主 fclk： | 25MHz |
| 调节字宽（位）： | 32 b |
| 电源电压： | 2.97 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 16-TSSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
Data Sheet
AD9832
Rev. E | Page 13 of 28
CIRCUIT DESCRIPTION
The AD9832 provides an exciting new level of integration
for the RF/communications system designer. The AD9832
combines the numerical controlled oscillator (NCO), a sine
look-up table, frequency and phase modulators, and a DAC
on a single integrated circuit.
The internal circuitry of the AD9832 consists of three main
sections. They are:
Numerical controlled oscillator (NCO) and phase modulator
Sine look-up table
DAC
The AD9832 is a fully integrated direct digital synthesis (DDS)
chip. The chip requires a reference clock, a low precision resistor,
and eight decoupling capacitors to provide digitally created sine
waves up to 12.5 MHz. In addition to the generation of this RF
signal, the chip is fully capable of a broad range of simple and
complex modulation schemes. These modulation schemes are
fully implemented in the digital domain, allowing accurate and
simple realization of complex modulation algorithms using DSP
techniques.
NUMERICAL CONTROLLED OSCILLATOR AND
PHASE MODULATOR
The NCO and phase modulator consists of two frequency select
registers, a phase accumulator, and four phase offset registers.
The main component of the NCO is a 32-bit phase accumulator
that assembles the phase component of the output signal. Continuous
time signals have a phase range of 0 to 2 π. Outside this range of
numbers, the sinusoid functions repeat themselves in a periodic
manner. The digital implementation is no different. The accumulator
simply scales the range of phase numbers into a multibit digital
word. The phase accumulator in the AD9832 is implemented
with 32 bits. Therefore, in the AD9832, 2π = 232. Likewise, the
ΔPhase term is scaled into this range of numbers 0 < ΔPhase <
232 1.
f = ΔPhase × fMCLK/232
where 0 < ΔPhase < 232.
The input to the phase accumulator (that is, the phase step) can
be selected from either the FREQ0 register or the FREQ1 register
and can be controlled by the FSELECT pin or the FSELECT bit.
NCOs inherently generate continuous phase signals, thus
avoiding any output discontinuity when switching between
frequencies.
Following the NCO, a phase offset can be added to perform
phase modulation using the 12-bit PHASEx registers. The contents
of these registers are added to the most significant bits of the NCO.
The AD9832 has four PHASEx registers, the resolution of these
registers being 2 π/4096.
SINE LOOK-UP TABLE (LUT)
To make the output useful, the signal must be converted from
phase information into a sinusoidal value. Because phase information
maps directly into amplitude, a ROM LUT converts the phase
information into amplitude. To do this, the digital phase
information is used to address a sine ROM LUT. Although the
NCO contains a 32-bit phase accumulator, the output of the
NCO is truncated to 12 bits. Using the full resolution of the phase
accumulator is impractical and unnecessary because this would
require a look-up table of 232 entries.
It is only necessary to have sufficient phase resolution in the
LUTs so that the dc error of the output waveform is dominated
by the quantization error in the DAC. This requires the look-up
table to have two more bits of phase resolution than the 10-bit DAC.
DIGITAL-TO-ANALOG CONVERTER
The AD9832 includes a high impedance current source 10-bit
DAC, capable of driving a wide range of loads at different speeds.
Full-scale output current can be adjusted for optimum power
and external load requirements by using a single external
resistor (RSET).
The DAC is configured for single-ended operation. The load
resistor can be any value required, as long as the full-scale
voltage developed across it does not exceed the voltage compliance
range. Because full-scale current is controlled by RSET, adjustments
to RSET can balance changes made to the load resistor. However,
if the DAC full-scale output current is significantly less than 4 mA,
the linearity of the DAC may degrade.
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B1H-IX-B1 | CONVERTER MOD DC/DC 52V 75W |
| AD9834BRUZ-REEL7 | IC DDS 10BIT 50MHZ LP 20TSSOP |
| VE-B1H-IW-B1 | CONVERTER MOD DC/DC 52V 100W |
| VE-B1F-IX-B1 | CONVERTER MOD DC/DC 72V 75W |
| MCF51AC256BCPUE | MCU 32BIT 256K FLASH 64-LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD9832BRUZ-REEL7 | 功能描述:IC DDS 10BIT 25MHZ CMOS 16TSSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 直接数字合成 (DDS) 系列:- 产品变化通告:Product Discontinuance 27/Oct/2011 标准包装:2,500 系列:- 分辨率（位）:10 b 主 fclk:25MHz 调节字宽（位）:32 b 电源电压:2.97 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| AD9833 | 制造商:AD 制造商全称:Analog Devices 功能描述:+2.5 V to +5.5 V, 25 MHz Low Power CMOS Complete DDS |
| AD9833BRM | 功能描述:IC WAVEFORM GEN PROG 10-MSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 直接数字合成 (DDS) 系列:- 产品变化通告:Product Discontinuance 27/Oct/2011 标准包装:2,500 系列:- 分辨率（位）:10 b 主 fclk:25MHz 调节字宽（位）:32 b 电源电压:2.97 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| AD9833BRM-REEL | 制造商:Analog Devices 功能描述:Direct Digital Synthesizer 25MHz 1-DAC 10-Bit Serial 10-Pin MSOP T/R 制造商:Analog Devices 功能描述:PROGRAMMABLE WAVEFORM GENERATOR 10MSOP - Tape and Reel |
| AD9833BRM-REEL7 | 功能描述:IC WAVEFORM GEN PROG 10-MSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 直接数字合成 (DDS) 系列:- 产品变化通告:Product Discontinuance 27/Oct/2011 标准包装:2,500 系列:- 分辨率（位）:10 b 主 fclk:25MHz 调节字宽（位）:32 b 电源电压:2.97 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。