参数资料
| 型号： | AT24C01B-TH-T |
| 厂商： | Atmel |
| 文件页数： | 6/25页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 1KBIT 1MHZ 8TSSOP |
| 标准包装： | 5,000 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 1K (128 x 8) |
| 速度： | 400kHz，1MHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 带卷 (TR) |
3. Device Operation
CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an external device.
Data on the SDA pin may change only during SCL low time periods (see Figure 5-2 on page 8 ).
Data changes during SCL high periods will indicate a start or stop condition as defined below.
START CONDITION: A high-to-low transition of SDA with SCL high is a start condition which
must precede any other command (see Figure 5-3 on page 8 ).
STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition. After a
read sequence, the stop command will place the EEPROM in a standby power mode (see Fig-
ure 5-3 on page 8 ).
ACKNOWLEDGE: All addresses and data words are serially transmitted to and from the
EEPROM in 8-bit words. The EEPROM sends a zero to acknowledge that it has received each
word. This happens during the ninth clock cycle.
STANDBY MODE: The AT24C01B features a low-power standby mode which is enabled: (a)
upon power-up and (b) after the receipt of the STOP bit and the completion of any internal
operations.
2-WIRE SOFTWARE RESET: After an interruption in protocol, power loss or system reset, any
2-wire part can be protocol reset by following these steps: (a) Create a start bit condition, (b)
Clock 9 cycles, (c) Create another start bit followed by a stop bit condition as shown below. The
device is ready for next communication after above steps have been completed.
Start bit
Dummy Clock Cycles
Start bit
Stop bit
SCL
1
2
3
8
9
SDA
6
AT24C01B
5156E–SEEPR–10/08
相关PDF资料 |
PDF描述 |
|---|---|
| XC2V1000-6FFG896C | IC FPGA VIRTEX-II 2M 896-FBGA |
| XC2V1000-5FFG896I | IC FPGA VIRTEX-II 2M 896-FBGA |
| XC5VLX50-2FF676C | IC FPGA VIRTEX-5 50K 676FBGA |
| EB43-S4R606XS | CONN EDGEBOARD DUAL 120POS 3A |
| XC5VLX50-2FFG676C | IC FPGA VIRTEX-5 50K 676-FBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT24C01BTH-T | 制造商:Atmel Corporation 功能描述:EEPROM Serial-2Wire 1K-bit 128 x 8 2.5V/3.3V/5V 8-Pin TSSOP T/R |
| AT24C01B-TP25-B | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Two-wire Automotive Temperature Serial EEPROM |
| AT24C01B-TP25-T | 制造商:Atmel Corporation 功能描述: |
| AT24C01B-TSU-T | 功能描述:电可擦除可编程只读存储器 NIPDAU AUTO 2.5V - IND 1.8V RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| AT24C01BU3-UU-T | 功能描述:电可擦除可编程只读存储器 1.8V-IND 1.8V RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
发布紧急采购，3分钟左右您将得到回复。