参数资料
| 型号： | AT32UC3A0256-ALUT |
| 厂商： | Atmel |
| 文件页数： | 92/97页 |
| 文件大小： | 0K |
| 描述： | IC MCU AVR32 256KB FLASH 144LQFP |
| 产品培训模块： | AVR UC3 Audio Application MCU Product Line Introduction AVR EVK1105 Digital Audio Gateway Kit AVR® UC3 Introduction |
| 标准包装： | 300 |
| 系列： | AVR®32 UC3 A0 |
| 核心处理器： | AVR |
| 芯体尺寸： | 32-位 |
| 速度： | 66MHz |
| 连通性： | EBI/EMI，以太网，I²C，SPI，SSC，UART/USART，USB OTG |
| 外围设备： | 欠压检测/复位，POR，PWM，WDT |
| 输入/输出数： | 109 |
| 程序存储器容量： | 256KB（256K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 64K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 1.65 V ~ 1.95 V |
| 数据转换器： | A/D 8x10b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 144-LQFP |
| 包装： | 托盘 |
| 配用： | ATSTK600-RC33-ND - STK600 ROUTING CARD AVR ATEVK1105-ND - KIT EVAL FOR AT32UC3A0 ATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMR ATEVK1100-ND - KIT DEV/EVAL FOR AVR32 AT32UC3A |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页当前第92页第93页第94页第95页第96页第97页
2006 Microchip Technology Inc.
DS70119E-page 91
dsPIC30F6010
FIGURE 15-4:
DEAD-TIME TIMING DIAGRAM
15.8
Independent PWM Output
An independent PWM Output mode is required for driv-
ing certain types of loads. A particular PWM output pair
is in the Independent Output mode when the corre-
sponding PMOD bit in the PWMCON1 register is set.
No dead-time control is implemented between adjacent
PWM I/O pins when the module is operating in the
Independent mode and both I/O pins are allowed to be
active simultaneously.
In the Independent mode, each duty cycle generator is
connected to both of the PWM I/O pins in an output
pair. By using the associated duty cycle register and
the appropriate bits in the OVDCON register, the user
may select the following signal output options for each
PWM I/O pin operating in the Independent mode:
I/O pin outputs PWM signal
I/O pin inactive
I/O pin active
15.9
Single Pulse PWM Operation
The PWM module produces single pulse outputs when
the PTCON control bits PTMOD<1:0> = 10. Only edge-
aligned outputs may be produced in the Single Pulse
mode. In Single Pulse mode, the PWM I/O pin(s) are
driven to the active state when the PTEN bit is set.
When a match with a duty cycle register occurs, the
PWM I/O pin is driven to the inactive state. When a
match with the PTPER register occurs, the PTMR reg-
ister is cleared, all active PWM I/O pins are driven to
the inactive state, the PTEN bit is cleared, and an
interrupt is generated.
15.10 PWM Output Override
The PWM output override bits allow the user to manu-
ally drive the PWM I/O pins to specified logic states,
independent of the duty cycle comparison units.
All control bits associated with the PWM output over-
ride function are contained in the OVDCON register.
The upper half of the OVDCON register contains eight
bits, POVDxH<4:1> and POVDxL<4:1>, that determine
which PWM I/O pins will be overridden. The lower half
of
the
OVDCON
register
contains
eight
bits,
POUTxH<4:1> and POUTxL<4:1>, that determine the
state of the PWM I/O pins when a particular output is
overridden via the POVD bits.
15.10.1
COMPLEMENTARY OUTPUT MODE
When a PWMxL pin is driven active via the OVDCON
register, the output signal is forced to be the comple-
ment of the corresponding PWMxH pin in the pair.
Dead-time insertion is still performed when PWM
channels are overridden manually.
15.10.2
OVERRIDE SYNCHRONIZATION
If the OSYNC bit in the PWMCON2 register is set, all
output overrides performed via the OVDCON register
are synchronized to the PWM time base. Synchronous
output overrides occur at the following times:
Edge-Aligned mode, when PTMR is zero.
Center-Aligned modes, when PTMR is zero and
when the value of PTMR matches PTPER.
Duty Cycle Generator
PWMxH
PWMxL
Time selected by DTSxA bit (A or B)
Time selected by DTSxI bit (A or B)
相关PDF资料 |
PDF描述 |
|---|---|
| UX60SC-MB-5S8 | CONN RCPT MINI USB2.0 5POS SLD |
| ZX62D-B-5P8 | CONN RCPT MCR USB B SMD TH SHLL |
| AT91SAM7X256B-AU | IC MCU 256KB FLASH 100LQFP |
| ATMEGA165PV-8MU | IC AVR MCU 16K 8MHZ 64-QFN |
| AT32UC3C1256C-AUT | IC MCU AVR32 256K FLASH 100TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT32UC3A0256AU-ALUT | 功能描述:32位微控制器 - MCU 256KB Flash Audio 85Deg RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
| AT32UC3A0256-CTUR | 功能描述:32位微控制器 - MCU 256KB, 144FFBGA Ind RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
| AT32UC3A0256-CTUT | 功能描述:32位微控制器 - MCU 256KB, 144FFBGA Ind RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
| AT32UC3A0512 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:AVR32 32-Bit Microcontroller |
| AT32UC3A0512_08 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:AVR32 32-Bit Microcontroller |
发布紧急采购，3分钟左右您将得到回复。