参数资料
型号: AT90USB1287-MUR
厂商: Atmel
文件页数: 54/106页
文件大小: 0K
描述: MCU AVR 128K FLASH 16MHZ 64QFN
产品培训模块: MCU Product Line Introduction
megaAVR Introduction
标准包装: 1,000
系列: AVR® 90USB
核心处理器: AVR
芯体尺寸: 8-位
速度: 16MHz
连通性: EBI/EMI,I²C,SPI,UART/USART,USB,USB OTG
外围设备: 欠压检测/复位,POR,PWM,WDT
输入/输出数: 48
程序存储器容量: 128KB(128K x 8)
程序存储器类型: 闪存
EEPROM 大小: 4K x 8
RAM 容量: 8K x 8
电压 - 电源 (Vcc/Vdd): 2.7 V ~ 5.5 V
数据转换器: A/D 8x10b
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 64-VFQFN 裸露焊盘
包装: 带卷 (TR)
51
7593L–AVR–09/12
AT90USB64/128
8.
Power management and sleep modes
Sleep modes enable the application to shut down unused modules in the MCU, thereby saving
power. The AVR provides various sleep modes allowing the user to tailor the power consump-
tion to the application’s requirements.
To enter any of the five sleep modes, the SE bit in SMCR must be written to logic one and a
SLEEP instruction must be executed. The SM2, SM1, and SM0 bits in the SMCR Register select
which sleep mode (Idle, ADC Noise Reduction, Power-down, Power-save, or Standby) will be
activated by the SLEEP instruction. See Table 8-1 for a summary. If an enabled interrupt occurs
while the MCU is in a sleep mode, the MCU wakes up. The MCU is then halted for four cycles in
addition to the start-up time, executes the interrupt routine, and resumes execution from the
instruction following SLEEP. The contents of the Register File and SRAM are unaltered when
the device wakes up from sleep. If a reset occurs during sleep mode, the MCU wakes up and
executes from the Reset Vector.
Figure 7-1 on page 40 presents the different clock systems in the Atmel AT90USB64/128, and
their distribution. The figure is helpful in selecting an appropriate sleep mode.
8.0.1
SMCR – Sleep Mode Control Register
The Sleep Mode Control Register contains control bits for power management.
Bits 3, 2, 1 – SM2..0: Sleep Mode Select Bits 2, 1, and 0
These bits select between the six available sleep modes as shown in Table 8-1.
Note:
1. Standby modes are only recommended for use with external crystals or resonators.
Bit 1 – SE: Sleep Enable
The SE bit must be written to logic one to make the MCU enter the sleep mode when the SLEEP
instruction is executed. To avoid the MCU entering the sleep mode unless it is the programmer’s
purpose, it is recommended to write the Sleep Enable (SE) bit to one just before the execution of
the SLEEP instruction and to clear it immediately after waking up.
Bit
7654
32
10
––––
SM2
SM1
SM0
SE
SMCR
Read/write
RRRR
R/W
Initial value
0000
00
Table 8-1.
Sleep mode select.
SM2
SM1
SM0
Sleep mode
000
Idle
0
1
ADC noise reduction
010
Power-down
011
Power-save
100
Reserved
101
Reserved
110
Standby (1)
1
Extended Standby (1)
相关PDF资料
PDF描述
AT90USB1287-AUR MCU AVR 128K FLASH 16MHZ 64TQFP
VE-BTF-IX CONVERTER MOD DC/DC 72V 75W
VI-B3X-IX-F2 CONVERTER MOD DC/DC 5.2V 75W
VE-BTF-IW CONVERTER MOD DC/DC 72V 100W
VI-B3X-IW-F4 CONVERTER MOD DC/DC 5.2V 100W
相关代理商/技术参数
参数描述
AT90USB128X 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:USB DFU Bootloader
AT90USB162 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-bit Microcontroller with 8/16K Bytes of ISP Flash and USB Controller
AT90USB162-16AU 功能描述:8位微控制器 -MCU AVR USB 16K FLASH RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
AT90USB162-16AUR 功能描述:8位微控制器 -MCU 16K Flash RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
AT90USB162-16MU 功能描述:8位微控制器 -MCU AVR USB 16K FLASH RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT