- 您现在的位置：买卖IC网 > PDF目录11216 > AT90USB82-16MUR (Atmel)MCU AVR USB 8K FLASH 32-QFN PDF资料下载
参数资料
| 型号： | AT90USB82-16MUR |
| 厂商： | Atmel |
| 文件页数： | 24/38页 |
| 文件大小： | 0K |
| 描述： | MCU AVR USB 8K FLASH 32-QFN |
| 产品培训模块： | MCU Product Line Introduction megaAVR Introduction |
| 标准包装： | 5,000 |
| 系列： | AVR® 90USB |
| 核心处理器： | AVR |
| 芯体尺寸： | 8-位 |
| 速度： | 16MHz |
| 连通性： | EBI/EMI，PS/2，SPI，UART/USART，USB |
| 外围设备： | 欠压检测/复位，POR，PWM，WDT |
| 输入/输出数： | 22 |
| 程序存储器容量： | 8KB（8K x 8） |
| 程序存储器类型： | 闪存 |
| EEPROM 大小： | 512 x 8 |
| RAM 容量： | 512 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 配用： | ATSTK600-ND - DEV KIT FOR AVR/AVR32 ATSTK526-ND - KIT STARTER FOR AT90USB82/162 ATAVRDRAGON-ND - KIT DRAGON FLASH MEM AVR ATSTK525-ND - KIT STARTER FOR AT90USB AT90USBKEY2-ND - KIT DEMO FOR AT90USB |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
30
7707F–AVR–11/10
AT90USB82/162
dependent as shown in “AT90USB82/162 Typical Characteristics – Preliminary Data” on page
Main purpose of the delay is to keep the AVR in reset until it is supplied with minimum Vcc. The
delay will not monitor the actual voltage and it will be required to select a delay longer than the
Vcc rise time. If this is not possible, an internal or external Brown-Out Detection circuit should be
used. A BOD circuit will ensure sufficient Vcc before it releases the reset, and the time-out delay
can be disabled. Disabling the time-out delay without utilizing a Brown-Out Detection circuit is
not recommended.
The oscillator is required to oscillate for a minimum number of cycles before the clock is consid-
ered stable. An internal ripple counter monitors the oscillator output clock, and keeps the internal
reset active for a given number of clock cycles. The reset is then released and the device will
start to execute. The recommended oscillator start-up time is dependent on the clock type, and
varies from 6 cycles for an externally applied clock to 32K cycles for a low frequency crystal.
The start-up sequence for the clock includes both the time-out delay and the start-up time when
the device starts up from reset. When starting up from Power-save or Power-down mode, Vcc is
assumed to be at a sufficient level and only the start-up time is included.
6.4
Low Power Crystal Oscillator
Pins XTAL1 and XTAL2 are input and output, respectively, of an inverting amplifier which can be
configured for use as an On-chip Oscillator, as shown in Figure 6-4. Either a quartz crystal or a
ceramic resonator may be used.
This Crystal Oscillator is a low power oscillator, with reduced voltage swing on the XTAL2 out-
put. It gives the lowest power consumption, but is not capable of driving other clock inputs, and
may be more susceptible to noise in noisy environments.
C1 and C2 should always be equal for both crystals and resonators. The optimal value of the
capacitors depends on the crystal or resonator in use, the amount of stray capacitance, and the
electromagnetic noise of the environment. Some initial guidelines for choosing capacitors for
use with crystals are given in Table 6-3. For ceramic resonators, the capacitor values given by
the manufacturer should be used.
Table 6-2.
Number of Watchdog Oscillator Cycles
Typ Time-out (V
CC = 5.0V)
Typ Time-out (V
CC = 3.0V)
Number of Cycles
0 ms
0
4.1 ms
4.3 ms
512
65 ms
69 ms
8K (8,192)
相关PDF资料 |
PDF描述 |
|---|---|
| ADG201HSKR-REEL | IC SWITCH QUAD SPST 16SOIC |
| ADG1406BRUZ-REEL7 | IC MULTIPLEXER 8X1 28TSSOP |
| ADG201HSJPZ | IC SWITCH QUAD SPST 20PLCC |
| ADG333ABR | IC SWITCH QUAD SPDT 20SOIC |
| ADG333ABRS | IC SWITCH QUAD SPDT 20SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT90USBKEY | 功能描述:开发板和工具包 - AVR Demo board f/AVR MCU & AT90USB RoHS:否 制造商:Arduino 产品:Evaluation Boards 工具用于评估:ATMega32U4 核心:AVR 接口类型:I2C, UART, USB 工作电源电压:6 V to 20 V |
| AT90USBKEY2 | 功能描述:开发板和工具包 - AVR AVR USB Eval Kit RoHS:否 制造商:Arduino 产品:Evaluation Boards 工具用于评估:ATMega32U4 核心:AVR 接口类型:I2C, UART, USB 工作电源电压:6 V to 20 V |
| AT-910 | 制造商:HRS 制造商全称:HRS 功能描述:Stripline Mounting Fixed Attenuators (DC to 8 GHz) |
| AT-910(40) | 功能描述:衰减器 -IC RoHS:否 制造商:Skyworks Solutions, Inc. 最大衰减:18 dB 容差: 阻抗: 功率额定值:30 dBm 安装风格:SMD/SMT 工作温度范围:- 40 C to + 85 C |
| AT-913(40) | 功能描述:衰减器 -IC RoHS:否 制造商:Skyworks Solutions, Inc. 最大衰减:18 dB 容差: 阻抗: 功率额定值:30 dBm 安装风格:SMD/SMT 工作温度范围:- 40 C to + 85 C |
发布紧急采购，3分钟左右您将得到回复。