参数资料
| 型号： | BD9853AFV-E2 |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 7/17页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM 16-SSOP |
| 标准包装： | 1 |
| PWM 型： | 控制器 |
| 输出数： | 2 |
| 频率 - 最大： | 2MHz |
| 电源电压： | 4.5 V ~ 16 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 标准包装 |
| 产品目录页面： | 1373 (CN2011-ZH PDF) |
| 其它名称： | BD9853AFV-E2DKR |
BD9853AFV
Technical Note
● Block functional descriptions
? Triangular wave oscillator
Connecting the resistor that sets the triangular wave oscillation frequency at the RT terminal generates the triangular wave,
which is input into the CH1 and CH2 PWM comparator.
? Error amp
The INV pin detects the output voltage, compares it to the programmed output voltage and amplifies the difference for
output by the FB pin. (The 0.8V reference is the comparison voltage. The tolerance is 1.25%.)
? PWM comparator
The PWM comparator converts the error amp (FB) voltage into a pulse width modulated waveform that goes to the FET
driver and turns FET output ON.
? FET driver
The push-pull FET driver directly drives the external MOSFET,providing high-side(OUT1H,OUT2H) switching at voltages
between Vcc ? REGB, and low-side switching in the 0 ? REGA voltage range. (REGA = 5V; REGB= VCC -5V internal power)
? Standby function
The standby function enables output ON/OFF control by the STB pin. Output is ON when STB voltage is HIGH.
With the STB pin set HIGH, the output ON/OFF for each channel can be independently controlled by one of the
SCP/SOFT1, 2 pins.
? Soft Start/Short Circuit Protection (SCP)
Connecting the external capacitor on the SCP/SOFT1, 2 pins sets the SCP delay time and soft start time.
When STB is HIGH and the IC starts up, the capacitors on the SCP/SOFT1, 2 pins charge up at 2uA, stabilizing when the
system reaches 1.3V.
If load conditions change rapidly, causing the output voltage in either channel to fall to 70% or less of the set output voltage
(INV voltage 0.56 or lower), the SCP/SOFT1, 2 external capacitors will charge further until output for both channels
switches OFF at 2.3V.
? Under Voltage Lockout (UVLO)
Under Voltage lockout prevents IC malfunctions that could otherwise occur due to intermittent or fluctuating power supply
voltage, or insufficient voltage during start-up.When the VCC voltage falls to 4.1V or below, both channel outputs are
turned OFF, while the SCP/SOFT1, 2 pins are simultaneously set LOW.
The UVLO detection voltage includes 0.1V hysteresis width to prevent malfunctions from input voltage fluctuations.
? Thermal Shutdown (TSD)
The TSD circuit protects the IC against thermal runaway and heat damage.
? The TSD thermal sensor detects junction temperature. When the temperature reaches the TSD threshold (175 ℃ ), the
circuit switches the output of both channels OFF, and also switches REGA and REGB OFF. At the same time, it sets the
SCP/SOFT1, 2 pins LOW. The hysteresis width (15 ℃ ) provided between the TSD function start temperature (threshold)
and the stop temperature serves to prevent malfunctions from temperature fluctuations.
www.rohm.com
? 2009 ROHM Co., Ltd. All rights reserved.
7/16
2009.05 - Rev.A
相关PDF资料 |
PDF描述 |
|---|---|
| BD9862MUV-E2 | IC PMIC PS TFT-LCD 24VQFN |
| BH25FB1WG-TR | IC REG LDO 2.5V .15A 5SSOP |
| BH30NB1WHFV-TR | IC REG LDO 3V .15A 5HVS0F |
| BH31PB1WHFV-TR | IC REG LDO 3.1V .15A HVSOF5 |
| BH31RB1WGUT-E2 | IC REG LDO 3.1V .15A 4-VCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BD9853FV | 制造商:ROHM 制造商全称:Rohm 功能描述:2 Channel Switching Regulator Controller |
| BD9855MWV | 制造商:ROHM 制造商全称:Rohm 功能描述:Silicon Monolithic Integrated Circuit |
| BD9859EFJ | 制造商:ROHM 制造商全称:Rohm 功能描述:Simple Step-down Switching Regulators with Built-in Power MOSFET |
| BD9859EFJ-E2 | 制造商:ROHM Semiconductor 功能描述: |
| BD9860MUV-E2 | 制造商:ROHM Semiconductor 功能描述:3CH SWITCH. REG. CONTROLLER - Tape and Reel 制造商:ROHM Semiconductor 功能描述:IC REG CTLR SW 3CH VQFNV4040 |
发布紧急采购，3分钟左右您将得到回复。