参数资料
| 型号： | BR93L46FJ-WE2 |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 36/41页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 1KBIT 2MHZ 8SOP |
| 标准包装： | 1 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 1K (64 x 16) |
| 速度： | 2MHz |
| 接口： | Microwire 3 线串行 |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOP-J |
| 包装： | 标准包装 |
| 产品目录页面： | 1380 (CN2011-ZH PDF) |
| 其它名称： | BR93L46FJ-WE2DKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页
BR93L -W Series, 93A □□ -WM Series, BR93H □□ -WC Series
Technical Note
6) Notes on power ON/OFF
? At power ON/OFF, set CS “L”.
When CS is “H”, this IC gets in input accept status (active). At power ON, set CS “L” to prevent malfunction from noise.
(When CS is in “L” status, all inputs are cancelled.) At power decline low power status may prevail. Therefore, at power
OFF, set CS “L” to prevent malfunction from noise.
VCC
VCC
GND
VCC
CS
GND
Bad example
Good example
Fig.52 Timing at power ON/OFF
（ Bad example ） CS pin is pulled up to Vcc.
In this case, CS becomes “H” (active status), EEPROM may
malfunction or have write error due to noises. This is true even
when CS input is High-Z.
（ Good example ） It is “L” at power ON/OFF.
Set 10ms or higher to recharge at power OFF.
When power is turned on without observing this condition,
IC internal circuit may not be reset.
○ POR citcuit
This IC has a POR (Power On Reset) circuit as a mistake write countermeasure. After POR action, it gets in write
disable status. The POR circuit is valid only when power is ON, and does not work when power is OFF. However, if CS is
“H” at power ON/OFF, it may become write enable status owing to noises and the likes. For secure actions, observe the
follwing conditions.
1. Set CS=”L”
2. Turn on power so as to satisfy the recommended conditions of tR, tOFF, Vbot for POR circuit action.
t R
V CC
Recommended conditions of t R , t OFF , Vbot
t R
t O FF
V bot
10m s or below
10m s or higher 0.3V or below
0
○ LVCC circuit
t OFF
Vbot
Fig.53 Rise waveform diagram
100m s or below 10m s or higher 0.2V or below
LVCC (VCC-Lockout) circuit prevents data rewrite action at low power, and prevents wrong write.
At LVCC voltage (Typ.=1.9V) or below, it prevent data rewrite.
7) Noise countermeasures
○ VCC noise (bypass capacitor)
When noise or surge gets in the power source line, malfunction may occur, therefore, for removing these, it is
recommended to attach a by pass capacitor (0.1 μ F) between IC VCC and GND, At that moment, attach it as close to IC
as possible.And, it is also recommended to attach a bypass capacitor between board VCC and GND.
SK noise
When the rise time (tR) of SK is long, and a certain degree or more of noise exists, malfunction may occur owing to clock
bit displacement.
To avoid this, a Schmitt trigger circuit is built in SK input. The hysteresis width of this circuit is set about 0.3, if noises
exist at SK input, set the noise amplitude 0.3p-p or below. And it is recommended to set the rise time (tR) of SK 100ns or
below. In the case when the rise time is 100ns or higher, take sufficient noise countermeasures. Make the clock rise, fall
time as small as possible.
www.rohm.com
? 2011 ROHM Co., Ltd. All rights reserved.
36/40
2011.09 - Rev.G
相关PDF资料 |
PDF描述 |
|---|---|
| A42MX24-1PQ208 | IC FPGA MX SGL CHIP 36K 208-PQFP |
| ABM43DTBT-S189 | CONN EDGECARD 86POS R/A .156 SLD |
| ABM43DTAT-S189 | CONN EDGECARD 86POS R/A .156 SLD |
| M1A3PE1500-2FGG676 | IC FPGA 1KB FLASH 1.5M 676-FBGA |
| A3PE1500-2FG676 | IC FPGA 1KB FLASH 1.5M 676-FBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BR93L46F-LE2 | 制造商:ROHM 制造商全称:Rohm 功能描述:High Reliability Serial EEPROMs High Reliability Series |
| BR93L46FV | 制造商:未知厂家 制造商全称:未知厂家 功能描述:EEPROM |
| BR93L46FVT-W | 制造商:ROHM 制造商全称:Rohm 功能描述:Microwire BUS 1Kbit(64 x 16bit) EEPROM |
| BR93L46FVT-WE2 | 功能描述:电可擦除可编程只读存储器 MICROWIRE BUS 1Kbit 1.8-5.5V Supply RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| BR93L46FV-W | 制造商:ROHM Semiconductor 功能描述:EEPROM,1kb,64Wx16b,Microwire Bus,SSOP8 |
发布紧急采购，3分钟左右您将得到回复。