- 您现在的位置：买卖IC网 > PDF目录16834 > CDB5464U (Cirrus Logic Inc)BOARD EVAL FOR CS5464 ADC PDF资料下载
参数资料
| 型号： | CDB5464U |
| 厂商： | Cirrus Logic Inc |
| 文件页数： | 21/46页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL FOR CS5464 ADC |
| 标准包装： | 1 |
| 主要目的： | 电源管理，电度表/功率表 |
| 嵌入式： | 是，MCU，8 位 |
| 已用 IC / 零件： | CS5464 |
| 主要属性： | 电能表 |
| 次要属性： | 图形用户接口，SPI? 和 USB 接口 |
| 已供物品： | 板，线缆，软件 |
| 产品目录页面： | 754 (CN2011-ZH PDF) |
| 相关产品： | CS5464-ISZR-ND - IC ENERGY METERING 1PHASE 28SSOP 598-1194-5-ND - IC ENERGY METERING 1PHASE 28SSOP 598-1193-5-ND - IC PWR/ENERGY METER 3CH 28-SSOP |
| 其它名称： | 598-1554 CDB-5464U |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页
CS5464
For each enabled input channel, the measured value is
rectified and compared to the associated level register .
Over the duration window, the number of samples
above and below the level are counted. If the number of
samples below the level exceeds the number of sam-
ples above, a Status register bit V1 SAG (V2 SAG ),
I1 FAULT (I2 FAULT ) is set, indicating a sag or fault condi-
tion. (see Figure 7 )..
Figure 7. Sag and Fault Detect
6.12 Epsilon
The Epsilon register is used to set the gain of the 90°
phase shift used in the quadrature power calculation.
The value in the Epsilon register is the ratio of the line
frequency to the output word rate (OWR). It is, by de-
fault, 50/4000 (0.0125), for 50 Hz line and 4000 Hz
sample (OWR) frequencies.
For 60 Hz line frequency, it is 60/4000 (0.015). Other
output word rates (OWR) can be used.
Epsilon can also be calculated automatically by the
CS5464 by setting the AFC bit in the Mode Control
( Modes ) register. The Frequency Update bit (FUP) in
the Status register is set every time the Epsilon register
has been automatically updated.
6.13 Temperature Measurement
The on-chip temperature sensor is designed to mea-
sure temperature and optionally compensate for tem-
perature drift of the voltage reference. It uses the V BE of
a transistor to determine temperature.
Temperature measurements are stored in the Temper-
ature register ( T ) which, by default, is configured to a
range of ±128 degrees on the Celsius (°C) scale.
DS682F3
The application program can change both the scale and
range of Temperature ( T ) by changing the Temperature
Gain ( T GAIN ) and Temperature Offset ( T OFF ) registers.
Two values must be known — the transistor’s ? V BE per
degree, and the transistor’s V BE at 0 degrees. At the
time of this publication, these values are:
?? V BE (per degree) = 0.2769523 mV/°C or °K
V BE 0 = 79.2604368 mV at 0°C
To determine the values to write to T GAIN and T OFF , use
the following formulae:
T GAIN = AD FS / ? V BE / T FS x 2 17
T OFF = -V BE 0 / AD FS x 2 23
In the above equations, AD FS is the full-scale input
range of the temperature A/D converter or 833.333 mV
and T FS is the desired full-scale range of the Tempera-
ture register. The binary exponents are the bit positions
of the binary point of these registers.
To use the Celsius scale (°C) and cover the chip’s op-
erating temperature range of -40°C to +85°C, the Tem-
perature register range needs to be ±128 degrees. T FS
should be 128 degrees.
T GAIN = 833.333 / 0.2769523 / 128 x 131072
= 3081155 (0x2F03C3)
T OFF = -79.2604368 / 833.333 x 8388608
= -797862 (0xF3D35A)
These are the actual default values for these registers.
T GAIN and T OFF can also be used to calibrate the gain
and/or offset of the temperature sensor or A/D convert-
er. (See Section 9. System Calibration on page 39).
To use the Kelvin (°K) scale, simply add 273 times
? V BE / AD FS x 2 23 to T OFF since 0°C = 273°K,. You will
also need more range. Since -40°C to +85°C is 233°K
to 358°K, a T FS of 512 degrees should be used in the
T GAIN calculation.
To use the Fahrenheit (°F) scale, multiply ? V BE by 5/9
and add 32 times the new ? ? V BE ? / AD FS x 2 23 to T OFF
since 0°C = 32°F. You will also want to use a ? T FS of 256
degrees to cover the -40°C to +85°C range.
The Temperature register ( T ) updates every 2240 out-
put word rate (OWR) samples. The Status register bit
TUP indicates when T is updated.
21
相关PDF资料 |
PDF描述 |
|---|---|
| H6MMS-2618M | DIP CABLE - HDM26S/AE26M/HDM26S |
| MAX6126A41+T | IC VREF SERIES PREC 4.096V 8UMAX |
| H1DXH-3436G | IDC CABLE - HKR34H/AE34G/X |
| PCMB104T-2R0MS | COIL 2.0 UH POWER CHOKE 20% SMD |
| MAX6126A30+T | IC VREF SERIES PREC 3V 8-UMAX |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CDB5464U-Z | 制造商:Cirrus Logic 功能描述:EVAL BD PB-FREE DEMO BOARD FOR CS5464 - Boxed Product (Development Kits) 制造商:Cirrus Logic 功能描述:Eval Board |
| CDB5466U | 功能描述:数据转换 IC 开发工具 Eval Bd F/Residental Pow-Meter Apps RoHS:否 制造商:Texas Instruments 产品:Demonstration Kits 类型:ADC 工具用于评估:ADS130E08 接口类型:SPI 工作电源电压:- 6 V to + 6 V |
| CDB5466U-Z | 制造商:Cirrus Logic 功能描述:PB-FREEEVAL BOARD FOR CS5466 WITH USB - Bulk |
| CDB5467U | 功能描述:数据转换 IC 开发工具 Eval Bd 4-Ch Sngl-Phs Pow/Energy RoHS:否 制造商:Texas Instruments 产品:Demonstration Kits 类型:ADC 工具用于评估:ADS130E08 接口类型:SPI 工作电源电压:- 6 V to + 6 V |
| CDB5471 | 制造商:Cirrus Logic 功能描述:Tools Development kit Kit Con |
发布紧急采购，3分钟左右您将得到回复。