- 您现在的位置：买卖IC网 > Datasheet目录319 > CPC1590P (IXYS Integrated Circuits Division)MOSFET GATE DVR ISO 8-FLATPACK Datasheet资料下载
参数资料
| 型号： | CPC1590P |
| 厂商： | IXYS Integrated Circuits Division |
| 文件页数： | 6/10页 |
| 文件大小： | 0K |
| 描述： | MOSFET GATE DVR ISO 8-FLATPACK |
| 标准包装： | 50 |
| 系列： | * |
I NTEGRATED C IRCUITS D IVISION
2. Introduction
The CPC1590 is a MOSFET Gate Driver that requires
no external power supply. It can regulate an input
voltage, up to 200V, down to 12.2V for internal use. It
is specifically designed for low-duty-cycle switching
frequencies that drive 4nF of gate capacitance.
3. Functional Description
The CPC1590 is used in conjunction with a single
MOSFET transistor for remote switching of DC loads
( Figure 2 ), and two MOSFETS and a diode for remote
switching of low-frequency AC loads ( Figure 3 ) where
isolated power is unavailable.
The device uses external components, most notably a
charge storage capacitor, to satisfy design switching
and over-voltage protection requirements. Because of
this design flexibility, the designer may choose a great
number of MOSFETs for use in a wide variety of
applications. The designer simply needs to know the
MOSFET total gate charge (Q G ), and with this
information a capacitor can be chosen. The
capacitance of the storage capacitor should be greater
than, or equal to, Q G /0.5V.
The CPC1590 has two states of operation:
(1) sufficient input control current is flowing, the LED is
turned on, and the gate current is being applied. The
light from the LED is being reflected onto the
photovoltaic, which then produces a photocurrent that
Figure 2. CPC1590 DC Application Circuit
CPC1590
CPC1590
turns on the NPN bipolar transistor and provides the
charge (I x t = Q), or the gate current that is being
applied to turn on the MOSFET. (2) Sufficient input
control current is not flowing, the LED is turned off,
and gate current is not flowing. The LED is off
because V F << the minimum forward voltage required,
and not enough current is being applied. This turns on
the PNP bipolar transistor, providing a path for gate
current to discharge to V L2 .
When V LOAD is first applied, the external storage
capacitor begins to charge. The charge is sent through
a bootstrap diode to prevent the charge from escaping
and discharging through a turned-on MOSFET. The
J-FET then regulates the voltage between 10V and
16V. The input control current is applied, then the
charge is transferred from the storage capacitor
through the NPN bipolar transistor, along with the
charge from the photovoltaic, to the MOSFET gate to
accomplish a rapid turn-on. After the capacitor has
discharged and the MOSFET has turned on, the
photocurrent from the input optocoupler continues to
flow into the gate to keep the MOSFET turned on.
When the input control current is removed, the gate
current stops flowing and the PNP bipolar transistor is
on and is discharging the MOSFET gate. The
MOSFET is now off. At this point the capacitor begins
to recharge for the next turn on cycle.
The circuit below does not include over-voltage
protection.
8
CAP
1
4
N C
N C
7 A
C ST
LOAD
+V LOAD
5
G
LED +
2
6
LED -
3
www.ixysic.com
6 B
-V LOAD
R01
相关PDF资料 |
PDF描述 |
|---|---|
| CPC5002G | ISOLAT DGTL 3.75KVRMS 2CH 8-DIP |
| CPCI-D-3U-300C | PWR SUPLY DC/DC CPCI 300W 3UX8HP |
| CPD250-4530G | PWR SUP 250W 3.3/5/12/-12V QUAD |
| CS4161YN8 | IC DRIVER H-BRDG DUAL 85MA 8DIP |
| CS5461A-ISZ | IC ENERGY METERING 1PHASE 24SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CPC1590PTR | 功能描述:逻辑输出光电耦合器 Optically Isolated Gate Driver, Tape/Reel RoHS:否 制造商:Fairchild Semiconductor 绝缘电压:4243 Vrms 输出类型:Push-Pull 最大传播延迟时间:500 ns 最大正向二极管电压: 最大反向二极管电压: 最大正向二极管电流: 最大连续输出电流:2.5 A 最大功率耗散:100 mW 最大工作温度:+ 100 C 最小工作温度:- 40 C 封装 / 箱体:SO-16 封装:Tube |
| CPC1593 | 制造商:IXYS 制造商全称:IXYS Corporation 功能描述:Single-Pole, Normally Open OptoMOS?? Relay Integrated Current Limit with Voltage and Thermal Protection |
| CPC1593G | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin DIP RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| CPC1593GS | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin SM RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| CPC1593GSTR | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin SM T/R RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。