- 您现在的位置：买卖IC网 > Datasheet目录319 > CPC1590P (IXYS Integrated Circuits Division)MOSFET GATE DVR ISO 8-FLATPACK Datasheet资料下载
参数资料
| 型号： | CPC1590P |
| 厂商： | IXYS Integrated Circuits Division |
| 文件页数： | 8/10页 |
| 文件大小： | 0K |
| 描述： | MOSFET GATE DVR ISO 8-FLATPACK |
| 标准包装： | 50 |
| 系列： | * |
I NTEGRATED C IRCUITS D IVISION
between 10V and 16V. The capacitor’s voltage rating
should be two to three times this range.
The designer should select the storage capacitor
based on the particular application requirements. If the
final product requires operating at a higher ambient
temperature range of -40°C to +110°C, then it is better
to select COG/NPO capacitors in order to meet
minimum capacitance requirements.
4.3 Transistor Selection
The CPC1590 charges and discharges an external
MOSFET transistor. The selection of the MOSFET is
determined by the user to meet the specific power
5. CPC1590 Used as an AC Switch
The CPC1590 can be used in other configurations.
One typical configuration is shown in Figure 3 , which
is called an AC Switch. This simply means that either
terminal can be positive or negative. This configuration
CPC1590
requirements for the load. The CPC1590 output
voltage is listed in the specification, but, as mentioned
earlier, there must be little or no gate leakage.
Another parameter that plays a significant role in the
selection of the transistor is the gate drive voltage
available from the part. The CPC1590 uses
photovoltaic cells to collect the optical energy
generated by the internal LED; to generate more
voltage, the photovoltaic diodes are stacked. As such,
the voltage of the photovoltaic stack reduces with
increased temperature. The user must select a
transistor that will maintain the load current at the
maximum temperature, given the V GS in the CPC1590
specifications.
The design considerations are identical for this
application. Diodes D1 and D2 must have voltage
ratings greater than the breakdown voltage of the
MOSFETs.
requires a second MOSFET (Q2) and two rectifying
diodes (D1 and D2).
Figure 3. Application Circuit for Using the CPC1590 as an AC Switch
CPC1590
8 V CAP
1
4
N C
N C
7 V L1
D1
LOAD
+/- V LOAD
C ST
5
V G
Q1
LED +
2
D2
LED -
3
6 V L2
Q2
+/- V LOAD
6. Conclusion
See IXYS Integrated Circuits Division’s Application Note, AN-202, for a thorough discussion, and for examples of
device usage, component selection, and over-voltage protection circuitry.
8
www.ixysic.com
R01
相关PDF资料 |
PDF描述 |
|---|---|
| CPC5002G | ISOLAT DGTL 3.75KVRMS 2CH 8-DIP |
| CPCI-D-3U-300C | PWR SUPLY DC/DC CPCI 300W 3UX8HP |
| CPD250-4530G | PWR SUP 250W 3.3/5/12/-12V QUAD |
| CS4161YN8 | IC DRIVER H-BRDG DUAL 85MA 8DIP |
| CS5461A-ISZ | IC ENERGY METERING 1PHASE 24SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CPC1590PTR | 功能描述:逻辑输出光电耦合器 Optically Isolated Gate Driver, Tape/Reel RoHS:否 制造商:Fairchild Semiconductor 绝缘电压:4243 Vrms 输出类型:Push-Pull 最大传播延迟时间:500 ns 最大正向二极管电压: 最大反向二极管电压: 最大正向二极管电流: 最大连续输出电流:2.5 A 最大功率耗散:100 mW 最大工作温度:+ 100 C 最小工作温度:- 40 C 封装 / 箱体:SO-16 封装:Tube |
| CPC1593 | 制造商:IXYS 制造商全称:IXYS Corporation 功能描述:Single-Pole, Normally Open OptoMOS?? Relay Integrated Current Limit with Voltage and Thermal Protection |
| CPC1593G | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin DIP RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| CPC1593GS | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin SM RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| CPC1593GSTR | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin SM T/R RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。