参数资料
型号: CS1601-FSZ
厂商: Cirrus Logic Inc
文件页数: 13/16页
文件大小: 0K
描述: IC PFC CONTROLLER BALLAST 8SOIC
产品变化通告: CS1501, 1601 Datasheet Update Change 11/Jan/2012
设计资源: CS150x/160x PCB Layout Guidelines
Driving Mosfets with CS1501/1601
CS1501/1601 Driving ZCD Pin from Mosfet Drain
特色产品: CS1501/CS1601 Power Factor Correction IC Controllers
标准包装: 100
类型: PFC/镇流器控制器
频率: 70kHz
电流 - 电源: 1.5mA
电流 - 输出: 1A
电源电压: 7.9 V ~ 17 V
工作温度: -40°C ~ 125°C
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOIC
包装: 散装
其它名称: 598-1915
CS1601
5.11 Overpower Protection
The CS1601 incorporates an internal overpower protection
(OPP) algorithm that provides protection from overload
conditions. This algorithm uses the condition that output
power is a function of the boost inductor (see section 5.4
Under moderate overload, V link may droop up to 10% while
maintaining rated power and PFC. Further increasing the load
current causes V link to drop below the startup threshold
(~360V). Below this threshold, the circuit switches the
operating mode to startup with more power available to raise
V link . As V link reaches its nominal value, startup mode is
canceled and power is now limited to the rated value. If the
overload is still present, this cycle will repeat.
If a sustained overload, or a repeated cycle of overload
events, is detected for greater than 112 ms, the CS1601 shuts
down for 2.5 seconds and then attempts to restart.
5.13 Internal Overtemperature Protection
An internal thermal sensor triggers a shutdown when the
temperature exceeds 135°C (nominal) on the silicon. The
sensor sends a signal to the core that supplies current to all
internal digital logic, cutting off power from them. Once the
temperature of the IC has dropped by 9°C (nominal), the
sensor resets, allowing power to the logic.
5.14 Standby (STBY) Function
The standby (STBY) pin provides a means by which an
external signal can cause the CS1601 to enter a non-
operating, low-power state. The STBY input is intended to be
driven by an open-collector/open-drain device. Internal to the
pin, there is a pull-up resistor connected to the V DD pin, as
shown in Figure 22. Since the pull-up resistor has a high
impedance, a filter capacitor (up to 1000pF) may be required
on this pin.
5.12 Open/Short Loop Protection
8
VDD
If the PFC output sense resistor, R IFB , fails (open or short to
GND), the measured output voltage decreases at a slew rate of
about 2 V/ ? s, which is determined by the ADC sampling rate.
The IC stops the gate drive when the measured output voltage is
STBY
2
600k
CS1601
lower than the measured line voltage. The IC resumes gate drive
switching when the current into the IFB pin becomes larger than
or equal to the current into the IAC pin, and V link is greater than
the peak of the line voltage (V rect(pk) ). The maximum response
time of open/short loop protection for R IFB is about 150 ? s.
<1 nF
See Text
6
GND
If the PFC input sense resistor R IAC fails (open or short to GND),
the current reference signal supplied to the IC on pin IAC falls to
zero.
DS931F3
Figure 22. STBY Pin Connection
When the STBY pin is not used, it is recommended that the pin
be tied to V DD (pulled high).
13
相关PDF资料
PDF描述
CS2001YDWFR20 IC REG BST FLYBK ADJ 1.2A 20SOIC
CS2841BEDR14G IC REG CTRLR BST FLYBK CM 14SOIC
CS5101EN14G IC REG BUCK 5V 1.5A 14DIP
CS51033GDR8G IC REG CTRLR BUCK PWM 8-SOIC
CS51414GD8 IC REG BUCK 1.5A 8SOIC
相关代理商/技术参数
参数描述
CS1601-FSZR 制造商:Cirrus Logic 功能描述:IC PFC CONTROLLER DCM OCP (FOR LIGHTING) - Tape and Reel 制造商:Cirrus Logic 功能描述:IC PFC CTRLR BALLAST 8SOIC 制造商:Cirrus Logic 功能描述:PFC Controller
CS1601H 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:Digital PFC Controller for Electronic Ballasts
CS1601H-FSZ 制造商:Cirrus Logic 功能描述:IC PFC CONTROLLER DCM OCP (100KHZ) - Bulk 制造商:Cirrus Logic 功能描述:IC PFC CTRLR BALLAST 8SOIC 制造商:Cirrus Logic 功能描述:PFC Controller
CS1601H-FSZR 制造商:Cirrus Logic 功能描述:IC PFC CONTROLLER DCM OCP (100KHZ) - Tape and Reel 制造商:Cirrus Logic 功能描述:IC PFC CTRLR BALLAST 8SOIC 制造商:Cirrus Logic 功能描述:PFC Controller
CS16034_STRADELLA-IP-28-T2 功能描述:LENSSQUARE28 POS100*100MM (D)9,2 制造商:ledil 系列:Stradella 零件状态:在售 类型:透镜 颜色:透明 LED 数:32 透镜样式:方形,带圆顶 透镜尺寸:100mm x 100mm 透镜透明度:- 光学图像:非对称 视角:- 配套使用/相关制造商:Cree,Lumileds,Osram 材料:丙烯酸 安装类型:螺钉 标准包装:78