参数资料
| 型号： | CS5373A-ISZR |
| 厂商： | Cirrus Logic Inc |
| 文件页数： | 18/40页 |
| 文件大小： | 0K |
| 描述： | IC DAC/MODULATOR LP/HP 28-SSOP |
| 标准包装： | 1,000 |
| 类型： | 调制器 |
| 分辨率（位）： | 24 b |
| 采样率（每秒）： | 512k |
| 电压电源： | 模拟和数字，双 ± |
| 电源电压： | ± 2.5V，3.3V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 28-SSOP |
| 包装： | 带卷 (TR) |
| 配用： | CDB5378-ND - EVALUATION BOARD FOR CS5378 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
CS5373A
DS703F2
25
calibration and differential pulse tests. In mode
4, both sets of analog outputs (OUT and BUF)
are enabled.
5.3.2
DC Differential
The second DC test mode (MODE 5) enables
the modulator and DC test circuitry to create a
precision differential DC analog output voltage
as the final measurement for gain calibration
and as the step/pulse output for differential
pulse tests. In mode 5, both sets of analog out-
puts (OUT and BUF) are enabled.
In DC differential mode (MODE 5) the level-
shifting buffer circuitry adds low-level 32 kHz
switched-capacitor noise to the DC output.
This noise is out of the measurement band-
width
for
systems
designed
with
a
CS3301A/02A amplifier and CS5373A modu-
lator and is rejected by the CS5378 digital fil-
ter. This 32 kHz switched-capacitor noise
does not affect DC system tests, though it may
be visible on an oscilloscope at high gain lev-
els.
By
measuring
both
DC
test
modes
(MODE 4, 5), precision gain-calibration coeffi-
cients can be calculated for the measurement
channel. By first measuring the differential off-
set of the DC common mode output (MODE 4)
and then measuring the DC differential mode
amplitude (MODE 5), a precise offset-correct-
ed, volts-to-codes conversion ratio can be cal-
culated. This known ratio is then used along
with the CS5378 digital filter GAIN register to
normalize the full-scale amplitude to match
other channels in the measurement network.
By switching between DC common mode
(MODE 4)
and
DC
differential
mode
(MODE 5), pulse waveforms can be created to
characterize the step response of the mea-
surement channel. If a pulse test requires pre-
cise timing control, an external controller
should directly toggle the MODE pins of the
CS5373A to avoid delays associated with writ-
ing to the CS5378 digital filter GPIO register.
Sensor impedance can be measured using
DC differential mode (MODE 5), provided
matched series resistors are installed between
the BUF analog outputs and the sensor. Ap-
plying the known DC differential voltage to the
resistor-sensor-resistor string permits a ratio-
metric sensor impedance calculation from the
measured voltage drop across the sensor.
Switching
between
DC
differential
mode
(MODE 5) and modulator mode (MODE 0) can,
in the case of a moving-coil geophone, test basic
parameters of the electro-mechanical transfer
function. The voltage relaxation characteristic of
the sensor when switching the analog outputs
from a differential DC voltage to high impedance
depends primarily on the geophone resonant
frequency and damping factor.
5.4 Sleep Mode
Sleep mode (MODE 7) saves system power
when measurements are not required by turning
off the modulator, AC test circuitry, and DC test
circuitry. In sleep mode the modulator digital out-
puts and the BUF and OUT analog outputs are
high impedance.
OUT+
OUT-
BUF+
BUF-
CS5373A
MODE 4
Approx
-0.15 VDC
Common
Mode
Approx
-0.15 VDC
Common
Mode
OUT+
OUT-
BUF+
BUF-
CS5373A
MODE 5
Maximum
2.5 VDC
Differential
Maximum
2.5 VDC
Differential
Figure 12. DC Test Modes
相关PDF资料 |
PDF描述 |
|---|---|
| CS5376A-IQZ | IC FILTER DGTL MULTI-CH 64-TQFP |
| CS61577-IL1Z | IC LINE INTERFACE T1/E1 28PLCC |
| CS61584A-IQ3Z | IC LINE INTERFACE T1/E1 64LQFP |
| CS61884-IRZ | IC LN INTERF T1/E1/J1 160-LFBGA |
| CS8130-CS | IC IR TRANSCEIVER 2-5V 20-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CS5374 | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:Dual High-performance Amplifier & ΔΣ Modulator |
| CS5374_0910 | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:Dual High-performance Amplifier & ΔΣ Modulator |
| CS5374-CNZ | 功能描述:差分放大器 2-Ch DS Modulator & Hydrophone RoHS:否 制造商:Texas Instruments 通道数量:1 Channel 带宽:2.4 GHz 可用增益调整:6 dB to 26 dB 输入补偿电压: 共模抑制比（最小值）:- 40 dB 工作电源电压:4.75 V to 5.25 V 电源电流:100 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:WQFN-24 封装:Reel |
| CS5376 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:CS5376 Rev. A Errata|Geophysical|A/D Converters |
| CS5376A | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:Low-power, Multi-channel Decimation Filter |
发布紧急采购，3分钟左右您将得到回复。