- 您现在的位置：买卖IC网 > PDF目录16617 > DC1018B-B (Linear Technology)DEMO BOARD FOR LT4356-2 PDF资料下载
参数资料
| 型号： | DC1018B-B |
| 厂商： | Linear Technology |
| 文件页数： | 8/26页 |
| 文件大小： | 0K |
| 描述： | DEMO BOARD FOR LT4356-2 |
| 设计资源： | DC1018B Design File DC1018B Schematic |
| 标准包装： | 1 |
| 主要目的： | 过压防护 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | LT4356-2 |
| 已供物品： | 板 |
| 相关产品： | LT4356HDE-3-ND - IC REG OVP FAULT TIMER 12DFN LT4356HS-3#PBF-ND - IC REG OVP W/LATCHOFF 16SOIC LT4356HMS-3#PBF-ND - IC REG OVP W/LATCHOFF 10-MSOP LT4356HDE-3#PBF-ND - IC REG OVP W/LATCHOFF 12DFN LT4356HS-3#TRPBF-ND - IC REG OVP FAULT TIMER 16SOIC LT4356HMS-3#TRPBF-ND - IC REG OVP FAULT TIMER 10MSOP LT4356HDE-3#TRPBF-ND - IC REG OVP FAULT TIMER 12DFN LT4356MPS-2#TRPBF-ND - IC SURGE STOPPER ADJ 16-SOIC LT4356MPS-1#TRPBF-ND - IC SURGE STOPPER ADJ 16-SOIC LT4356MPMS-1#TRPBF-ND - IC SURGE STOPPER ADJ 10-MSOP 更多... |
LT4356-1/LT4356-2
PIN FUNCTIONS
A OUT (DFN and SO Packages Only): Ampli?er Output.
Open collector output of the auxiliary ampli?er. It is capable
of sinking up to 2mA from 80V. The negative input of the
ampli?er is internally connected to a 1.25V reference.
EN: Open-Collector Enable Output. The EN pin goes high
impedance when the voltage at the OUT pin is above (V CC
– 0.7V), indicating the external MOSFET is fully on. The
state of the pin is latched until the OUT pin voltage resets
at below 0.5V and goes back up above 2V. The internal
NPN is capable of sinking up to 3mA of current from 80V
to drive an LED or opto-coupler.
Exposed Pad (DFN Package Only): Exposed pad may be
left open or connected to device ground (GND).
FB: Voltage Regulator Feedback Input. Connect this pin
to the center tap of the output resistive divider connected
between the OUT pin and ground. During an overvoltage
condition, the GATE pin is servoed to maintain a 1.25V
threshold at the FB pin. This pin is clamped internally to
7V. Tie to GND to disable the OV clamp.
FLT : Open-Collector Fault Output. This pin pulls low
after the voltage at the TMR pin has reached the fault
threshold of 1.25V. It indicates the pass transistor is
about to turn off because either the supply voltage has
stayed at an elevated level for an extended period of
time (voltage fault) or the device is in an overcurrent
condition (current fault). The internal NPN is capable of
sinking up to 3mA of current from 80V to drive an LED or
opto-coupler.
GATE: N-Channel MOSFET Gate Drive Output. The GATE pin
is pulled up by an internal charge pump current source and
clamped to 14V above the OUT pin. Both voltage and cur-
rent ampli?ers control the GATE pin to regulate the output
voltage and limit the current through the MOSFET.
GND: Device Ground.
IN + (DFN and SO Packages Only): Positive Input of the
Auxiliary Ampli?er. This ampli?er can be used as a level
detection comparator with external hysteresis or linear
regulator controlling an external PNP transistor. This pin is
clamped internally to 7V. Connect to ground if unused.
OUT: Output Voltage Sense Input. This pin senses the
voltage at the source of the N-channel MOSFET and sets
the fault timer current. When the OUT pin voltage reaches
0.7V away from V CC , the EN pin goes high impedance.
SHDN : Shutdown Control Input. The LT4356 can be shut
down to a low current mode by pulling the SHDN pin below
0.4V. Pull this pin above 2.1V or disconnect it and allow
the internal current source to turn the part back on. The
leakage current to ground at the pin should be limited to
no more than 1μA if no pull up device is used to turn the
part on. The SHDN pin can be pulled up to 100V or below
GND by 60V without damage. In shutdown, the auxiliary
ampli?er turns off in the LT4356-1 but continues operating
in the LT4356-2.
SNS: Current Sense Input. Connect this pin to the output of
the current sense resistor. The current limit circuit controls
the GATE pin to limit the sense voltage between V CC and
SNS pins to 50mV. At the same time the sense ampli?er
also starts a current source to charge up the TMR pin.
This pin can be pulled below GND by up to 60V, though
the voltage difference with the V CC pin must be limited to
less than 30V. Connect to V CC if unused.
TMR: Fault Timer Input. Connect a capacitor between this
pin and ground to set the times for early warning, fault
and cool down periods. The current charging up this pin
during fault conditions depends on the voltage difference
between the V CC and OUT pins. When V TMR reaches 1.25V,
the FLT pin pulls low to indicate the detection of a fault
condition. If the condition persists, the pass transistor
turns off when V TMR reaches the threshold of 1.35V. As
soon as the fault condition disappears, the pull up current
stops and a 2μA current starts to pull the TMR pin down.
When V TMR reaches the retry threshold of 0.5V, the GATE
pin pulls high turning back on the pass transistor.
V CC : Positive Supply Voltage Input. The positive supply
input ranges from 4V to 80V for normal operation. It
can also be pulled below ground potential by up to 60V
during a reverse battery condition, without damaging the
part. The supply current is reduced to 7μA with all the
functional blocks off.
4356fa
8
相关PDF资料 |
PDF描述 |
|---|---|
| L-07C56NJV6T | CER INDUCTOR 56NH 0402 |
| L-07C43NJV6T | CER INDUCTOR 43NH 0402 |
| L-05B5N6KV6T | CER INDUCTOR 5.6NH 0201 |
| L-05B5N1KV6T | CER INDUCTOR 5.1NH 0201 |
| H3AKH-2606G | IDC CABLE - HSC26H/AE26G/HPK26H |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DC1018B-C | 功能描述:DEMO BOARD FOR LT4356-3 RoHS:否 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:- 主要目的:数字电位器 嵌入式:- 已用 IC / 零件:AD5258 主要属性:- 次要属性:- 已供物品:板 相关产品:AD5258BRMZ1-ND - IC POT DGTL I2C1K 64P 10MSOPAD5258BRMZ10-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ100-ND - IC POT DGTL I2C 100K 64P 10MSOPAD5258BRMZ50-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ1-R7-ND - IC POT DGTL I2C 1K 64P 10MSOPAD5258BRMZ10-R7-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ50-R7-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ100-R7-ND - IC POT DGTL I2C 100K 64P 10MSOP |
| DC101-BB-B | 制造商:Carling Technologies 功能描述:D-SERIES TOGGLE SWITCH - Bulk |
| DC101-PB-B | 制造商:Carling Technologies 功能描述:D-SERIES TOGGLE SWITCH - Bulk |
| DC101-PB-B/728-15907 | 制造商:Carling Technologies 功能描述:D-SERIES TOGGLE SWITCH - Bulk |
| DC101-PB-B-XTH1 | 制造商:Carling Technologies 功能描述:D-SERIES TOGGLE SWITCH - Bulk |
发布紧急采购，3分钟左右您将得到回复。