参数资料
| 型号： | DS2149QN+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 15/32页 |
| 文件大小： | 0K |
| 描述： | IC LIU T1/J1 5V 28-PLCC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 37 |
| 类型： | 线路接口装置（LIU） |
| 规程： | T1/J1 |
| 电源电压： | 4.75 V ~ 5.25 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-LCC（J 形引线） |
| 供应商设备封装： | 28-PLCC（11.51x11.51） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
DS2149
22 of 32
In software mode, the device can generate an interrupt to indicate that the QRSS pattern synchronization
has been declared or lost. Clearing the QRSS bit in the interrupt mask register enables the interrupt. Use
the QPD output to increment an external bit error counter and use the interrupt to reset the counter. The
QRSS bit in the status register is set when the QRSS pattern is detected and cleared when pattern is lost
(more than 6 bit errors in a window of 64 bits). The QRSS bit in the transition status register indicates
that the QRSS status has changed since the last QRSS interrupt clear command.
10.2.3 In-Band Network Loop-Up or Loop-Down Code Generator
In-band network loop-up or loop-down transmission is available in software mode only. The loop-up
code is transmitted when PAT0 = 1 and PAT1 = 0 in CR2. Logic errors and bipolar violations can still be
inserted when loop codes are being transmitted.
10.3Error Insertion and Detection
10.3.1 Bipolar Violation Insertion (INSBPV)
INSBPV is available in NRZ mode. Sampling occurs on the falling edge of TCLK. A rising edge on the
NSBPV pin inserts a BPV on the next available mark, except in the following conditions:
1) If the BPV would violate a B8ZS codeword.
2) When LLB and TAIS are both active. In this case, the BPV is looped back to the BPV pin and the line
driver transmits all ones with no violation.
3) When RLB is active.
4) When NLOOP is active.
BPVs can be inserted in both NRZ and bipolar data modes when the DS2149 is configured to transmit
internally generated data patterns (QRSS or in-band loop codes).
10.3.2 Logic Error Insertion (INSLE)
When transmitting QRSS or in-band loop codes, a logic error is inserted into the outbound data pattern on
a rising edge of the INSLER pin. Remember, when transmitting the QRSS pattern, logic error insertion is
inhibited if the error would replace a 1 with a 0 and result in a string of 15 or more consecutive 0s.
10.3.3 Logic Error Detection (QPD)
After QRSS pattern synchronization, logic errors are reported at the QPD output pin. If a logic error
occurs, the QPD pin goes high for one-half RCLK cycle. In software mode, the CLKE pin determines the
phase relationship between QPD and RCLK. When CLKE is low, QPD is high when RCLK is high.
When CLKE is high, QPD is high when RCLK is low. To count logic errors, use the QPD output to
increment an external error counter. A continuous output high indicates loss of synchronization to the
QRSS pattern or receive-carrier loss.
10.3.4 Bipolar Violation Detection (BPV)
When the B8ZS encoders and decoders are disabled or when configured for NRZ mode, bipolar
violations are reported at the BPV output pin. BPV goes high for a full clock cycle to indicate a bipolar
violation. When the B8ZS encoders and decoders are enabled, BPVs that are not part of codewords are
not reported.
相关PDF资料 |
PDF描述 |
|---|---|
| DS21348GN | IC LIU LN T1/E1/J1 3.3V 49-BGA |
| VI-241-MX-F3 | CONVERTER MOD DC/DC 12V 75W |
| MAX214EPI+ | IC TXRX RS-232 PROG 28-DIP |
| MAX214EWI+ | IC TXRX RS-232 PROG 28-SOIC |
| HI5767/2IA | CONV A/D 10BIT 20MSPS 28-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2149QN/T&R | 制造商:Maxim Integrated Products 功能描述:IC LINE INTERFACE 5V T1/J1 PLCC 制造商:Maxim Integrated Products 功能描述:Network Controller & Processor ICs 5V T1/J1 Line Interface |
| DS2149QN/T&R+ | 制造商:Maxim Integrated Products 功能描述:FRAMER J1/T1 5V 28PLCC - Tape and Reel |
| DS2149QN/T&R | 功能描述:网络控制器与处理器 IC 5V T1/J1 Line Interface RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| DS2149QN+ | 功能描述:网络控制器与处理器 IC 5V T1/J1 Line Interface RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| DS2149QN+T&R | 制造商:Maxim Integrated Products 功能描述:FRAMER J1/T1 5V 28PLCC - Tape and Reel 制造商:Maxim Integrated Products 功能描述:MXMDS2149QN+T&R 5V T1/J1 LIU T&R IND PLC 制造商:Maxim Integrated Products 功能描述:IC LIU T1/J1 5V 28-PLCC 制造商:Maxim Integrated Products 功能描述:Network Controller & Processor ICs 5V T1/J1 Line Interface |
发布紧急采购，3分钟左右您将得到回复。