- 您现在的位置：买卖IC网 > PDF目录1915 > DS2480B+ (Maxim Integrated Products)IC LINE DRVR W/SENSOR 1-W 8-SOIC PDF资料下载
参数资料
| 型号： | DS2480B+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 9/32页 |
| 文件大小： | 0K |
| 描述： | IC LINE DRVR W/SENSOR 1-W 8-SOIC |
| 产品培训模块： | 1-Wire Communications Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 100 |
| 类型： | 线路驱动器，发射器 |
| 驱动器/接收器数： | 1/0 |
| 规程： | RS232 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 管件 |
| 产品目录页面： | 1429 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
DS2480B
Maxim Integrated........................................................................................................................................................................................... 17
A Write-1 and Read Data time slot is comprised of the segments tLOW1, tDSO and tHIGH. During Write-1
time slots, after the Write-1 low time tLOW1 is over, the DS2480B waits for the duration of the data sample
offset and then samples the voltage at the 1-Wire bus to read the response. After this, the waiting time
tHIGH1 must expire before the time slot is complete. A Write-0 time slot only consists of the two segments
tLOW0 and tREC0.
If the network is large or heavily loaded, one should select flexible speed and extend tLOW1 to more than
8s to allow the 1-Wire bus to completely discharge. Since a large or heavily loaded network needs more
time to recharge, it is also recommended to delay sampling the bus for reading. A higher value for tDSO
will increase the voltage margin and also provide extra energy to the slave devices when generating a
long series of write 0 time slots. However, the total of tLOW1 + tDSO should not exceed 22s*. Otherwise
the slave device responding may have stopped pulling the bus low when transmitting a logic 0.
The idle time between time slots within a byte or during a 12-bit sequence while the Search Accelerator is
on is 0. Between bytes, 12-bit search sequences and single bits the idle time depends on the RS232 data
rate and the host’s response time. The response byte is sent to the host as soon as the last time slot of a
byte, 12-bit sequence or the command is completed.
Figure 6b. WRITE-1 AND READ DATA TIME SLOT
Speed
tLOW1
tDSO
tHIGH1
tSLOT*
Standard
8s
3s
49s
60s
Overdrive
1s
8s
10s
Flexible
8s to 15s
3s to 10s
49s
60s to 74s
Figure 6c. WRITE-0 TIME SLOT
Speed
tLOW0
tREC0
tSLOT*
Standard
57s
3s
60s
Overdrive
7s
3s
10s
Flexible
57s
3s to 10s
60s to 67s
*In a 5V environment (±1V, full temperature range) the tolerance of the internal time base of 1-Wire
slave devices is much narrower than what it is when operated at the minimum voltage of 2.8V. Therefore,
the timing generated by the DS2480B is in compliance with the requirements of all 1-Wire/iButton 1-
Wire devices.
相关PDF资料 |
PDF描述 |
|---|---|
| DS2482X-100+T | IC MASTER I2C-1WIRE 1CH 9-WLP |
| DS2482X-101+T | IC MASTER I2C-1WIRE 1CH 9-WLP |
| DS2483Q+T | IC I2C TO 1WIRE BRIDGE 8TDFN |
| DS2490Y | IC BRIDGE CLIP USB TO 1-W 24SOIC |
| DS26303LN-75+A3 | IC LIU E1/T1/J1 3.3V 144-ELQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2480B | 制造商:Maxim Integrated Products 功能描述:IC SERIAL LINE DRIVER 2480 SOIC8 |
| DS2480B/T&R | 功能描述:缓冲器和线路驱动器 RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
| DS2480B+ | 功能描述:缓冲器和线路驱动器 Serial - 1-Wire Line Driver RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
| DS2480B+R | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Serial to 1-Wire Line Driver |
| DS2480B+T | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Serial to 1-Wire Line Driver |
发布紧急采购，3分钟左右您将得到回复。