参数资料
| 型号： | DS2505P+T&R |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 19/24页 |
| 文件大小： | 0K |
| 描述： | IC OTP 16KBIT 6TSOC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 4,000 |
| 格式 - 存储器： | EPROMs |
| 存储器类型： | EPROM OTP |
| 存储容量： | 16K（16K x 1） |
| 接口： | 1 线 串行 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 6-LSOJ |
| 供应商设备封装： | 6-TSOC |
| 包装： | 带卷 (TR) |
DS2505
(Figure 11) should be applied for 480 μs, after which the bus master returns the data line to an idle high
state controlled by the pullup resistor. Note that due to the high voltage programming requirements for
any 1-Wire EPROM device, it is not possible to multidrop non-EPROM based 1-Wire devices with the
DS2505 during programming. An internal diode within the non-EPROM based 1-Wire devices will
attempt to clamp the data line at approximately 8 volts and could potentially damage these devices.
INITIALIZATION PROCEDURE “RESET AND PRESENCE PULSES” Figure 9
* In order not to mask interrupt signaling by other devices on the 1-Wire bus, t RSTL + t R should always be
less than 960 μs.
READ/WRITE TIMING DIAGRAM Figure 10
RESISTOR
MASTER
19 of 24
相关PDF资料 |
PDF描述 |
|---|---|
| A42MX24-3PL84I | IC FPGA MX SGL CHIP 36K 84-PLCC |
| EP4CGX75DF27C8 | IC CYCLONE IV GX FPGA 75K 672FBG |
| A42MX24-2PQ208 | IC FPGA MX SGL CHIP 36K 208-PQFP |
| A42MX24-2PQG208 | IC FPGA MX SGL CHIP 36K 208-PQFP |
| EP4CE75F29C9LN | IC CYCLONE IV FPGA 75K 780FBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2505P-UNW | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:UniqueWare Add-Only Memory |
| DS2505P-UNW-1154 | 制造商:Maxim Integrated Products 功能描述: |
| DS2505P-UNW-PPPP | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:UniqueWare Add-Only Memory |
| DS2505T | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:16-kbit Add-Only Memory |
| DS2505TR | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:16-kbit Add-Only Memory |
发布紧急采购，3分钟左右您将得到回复。