- 您现在的位置：买卖IC网 > PDF目录97870 > DS83C530-QNL (MAXIM INTEGRATED PRODUCTS INC) 8-BIT, MROM, 33 MHz, MICROCONTROLLER, PQCC52 PDF资料下载
参数资料
| 型号： | DS83C530-QNL |
| 厂商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分类： | Microcontroller |
| 英文描述： | 8-BIT, MROM, 33 MHz, MICROCONTROLLER, PQCC52 |
| 封装： | PLASTIC, LCC-52 |
| 文件页数： | 17/45页 |
| 文件大小： | 649K |
| 代理商： | DS83C530-QNL |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页
DS87C530/DS83C530 EPROM/ROM Microcontrollers with Real-Time Clock
24 of 45
The ring oscillator runs at approximately 2MHz to 4MHz but will not be a precise value. Do not conduct
real-time precision operations (including serial communication) during this ring period. Figure 6 shows
how the operation would compare when using the ring, and when starting up normally. The default state
is to exit Stop mode without using the ring oscillator.
The RGSL ring-select bit at EXIF.1 (EXIF; 91h) controls this function. When RGSL = 1, the CPU will
use the ring oscillator to exit Stop mode quickly. As mentioned above, the processor will automatically
switch from the ring to the crystal after a delay of 65,536 crystal clocks. For a 3.57MHz crystal, this is
approximately 18ms. The processor sets a flag called RGMD- Ring Mode, located at EXIF.2, that tells
software that the ring is being used. The bit will be a logic 1 when the ring is in use. Attempt no serial
communication or precision timing while this bit is set, since the operating frequency is not precise.
Figure 6. Ring Oscillator Exit from Stop Mode
EMI REDUCTION
One of the major contributors to radiated noise in an 8051-based system is the toggling of ALE. The
DS87C530/DS83C530 allow software to disable ALE when not used by setting the ALEOFF (PMR.2) bit
to 1. When ALEOFF = 1, ALE will still toggle during an off-chip MOVX. However, ALE will remain in
a static when performing on-chip memory access. The default state of ALEOFF = 0 so ALE toggles with
every instruction cycle.
NOTE: DIAGRAM ASSUMES THAT THE OPERATION FOLLOWING STOP REQUIRES LESS THAN 18ms TO COMPLETE.
相关PDF资料 |
PDF描述 |
|---|---|
| DS87C530-QNL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQCC52 |
| DS83C530-QCL | 8-BIT, MROM, 33 MHz, MICROCONTROLLER, PQCC52 |
| DS87C530-KCL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, CQCC52 |
| DTA-03D-1.5-TA-P | POSITION, LINEAR SENSOR-AC, -3-3mm |
| DTA-01D-3-SA-P | POSITION, LINEAR SENSOR-AC, -1-1mm |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS83C530-QNL+ | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:EPROM/ROM Microcontrollers with Real-Time Clock |
| DS83CH20 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Peripheral (Multifunction) Controller |
| DS84 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| DS840 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| DS843 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
发布紧急采购，3分钟左右您将得到回复。