参数资料
| 型号： | EM773FHN33,551 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 10/51页 |
| 文件大小： | 0K |
| 描述： | IC ENERGY METER ARM 32VQFN |
| 其它有关文件： | EM773 Energy Metering IC Training |
| 特色产品： | EM773 Energy Metering IC |
| 标准包装： | 260 |
| 核心处理器： | ARM? Cortex?-M0 |
| 芯体尺寸： | 32-位 |
| 速度： | 48MHz |
| 连通性： | I²C，SPI，UART/USART |
| 外围设备： | 欠压检测/复位，POR，WDT |
| 输入/输出数： | 25 |
| 程序存储器容量： | 32KB（32K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 8K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 1.8 V ~ 3.6 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-VQFN 裸露焊盘 |
| 包装： | 托盘 |
| 配用： | 568-6681-ND - BOARD EVAL EM773 METER EU PLUG 568-6680-ND - BOARD EVAL EM773 METER US PLUG |
| 其它名称： | 568-5213 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页
EM773
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 2 — 3 January 2012
18 of 51
NXP Semiconductors
EM773
Energy metering IC
7.16 System control
7.16.1 Start logic
The start logic connects external pins to corresponding interrupts in the NVIC. Each pin
shown in Table 2 as input to the start logic has an individual interrupt in the NVIC interrupt
vector table. The start logic pins can serve as external interrupt pins when the chip is
running. In addition, an input signal on the start logic pins can wake up the chip from
Deep-sleep mode when all clocks are shut down.
The start logic must be configured in the system configuration block and in the NVIC
before being used.
7.16.2 Reset
Reset has four sources on the EM773: the RESET pin, the Watchdog reset, Power-On
Reset (POR), and the BrownOut Detection (BOD) circuit. The RESET pin is a Schmitt
trigger input pin. Assertion of chip reset by any source, once the operating voltage attains
a usable level, starts the IRC and initializes the flash controller.
A LOW-going pulse as short as 50 ns resets the part.
When the internal Reset is removed, the processor begins executing at address 0, which
is initially the Reset vector mapped from the boot block. At that point, all of the processor
and peripheral registers have been initialized to predetermined values.
An external pull-up resistor is required on the RESET pin if Deep power-down mode is
used.
7.16.3 Brownout detection
The EM773 includes four levels for monitoring the voltage on the VDD pin. If this voltage
falls below one of the four selected levels, the BOD asserts an interrupt signal to the
NVIC. This signal can be enabled for interrupt in the Interrupt Enable Register in the NVIC
in order to cause a CPU interrupt; if not, software can monitor the signal by reading a
dedicated status register. Four additional threshold levels can be selected to cause a
forced reset of the chip.
7.16.4 Code security (Code Read Protection - CRP)
This feature of the EM773 allows user to enable different levels of security in the system
so that access to the on-chip flash and use of the Serial Wire Debugger (SWD) and
In-System Programming (ISP) can be restricted. When needed, CRP is invoked by
programming a specific pattern into a dedicated flash location. IAP commands are not
affected by the CRP.
In addition, ISP entry via the PIO0_1 pin can be disabled without enabling CRP. For
details see the EM773 user manual.
There are three levels of Code Read Protection:
1. CRP1 disables access to the chip via the SWD and allows partial flash update
(excluding flash sector 0) using a limited set of the ISP commands. This mode is
useful when CRP is required and flash field updates are needed but all sectors can
not be erased.
相关PDF资料 |
PDF描述 |
|---|---|
| ENC28J60T/SO | IC ETHERNET CTRLR W/SPI 28SOIC |
| ENC624J600T-I/PT | IC ETHERNET CTRLR W/SPI 64-TQFP |
| EP1AGX90EF1152I6 | IC ARRIA GX FPGA 90K 1152FBGA |
| EP1C3T144A8N | IC CYCLONE FPGA 2910 LE 144-TQFP |
| EP1K100FC484-1N | IC ACEX 1K FPGA 100K 484-FBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EM77565 | 制造商:EMC 制造商全称:ELAN Microelectronics Corp 功能描述:ADPCM WITH PCM CODEC |
| EM77930 | 制造商:EMC 制造商全称:ELAN Microelectronics Corp 功能描述:USB + BB Controller |
| EM77950 | 制造商:EMC 制造商全称:ELAN Microelectronics Corp 功能描述:BB Controller |
| EM77F900 | 制造商:EMC 制造商全称:ELAN Microelectronics Corp 功能描述:USB HUB+BB Controller |
| EM780FP16AS-45LF | 制造商:EMLSI 制造商全称:Emerging Memory & Logic Solutions Inc 功能描述:64K x16 bit Super Low Power and Low Voltage Full CMOS Static RAM |
发布紧急采购，3分钟左右您将得到回复。