- 您现在的位置：买卖IC网 > PDF目录17031 > EVAL-AD7715-3EBZ (Analog Devices Inc)BOARD EVALUATION FOR AD7715 PDF资料下载
参数资料
| 型号： | EVAL-AD7715-3EBZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 24/40页 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION FOR AD7715 |
| 标准包装： | 1 |
| ADC 的数量： | 1 |
| 位数： | 16 |
| 采样率（每秒）： | 500 |
| 数据接口： | 串行 |
| 输入范围： | ±VREF/增益 |
| 在以下条件下的电源（标准）： | 5.3mW @ 3.3 V |
| 工作温度： | -40°C ~ 85°C |
| 已用 IC / 零件： | AD7715-3 |
| 已供物品： | 板，CD |
| 相关产品： | AD7715ARUZ-5-ND - IC ADC 16BIT SIGMA-DELTA 16TSSOP AD7715ARUZ-3-ND - IC ADC 16BIT SIGMA-DELTA 16TSSOP AD7715ANZ-3-ND - IC ADC 16BIT SIGMA-DELTA 16DIP AD7715ARUZ-5REEL7-ND - IC ADC 16BIT SIGMA-DELTA 16TSSOP AD7715ARUZ-3REEL7-ND - IC ADC 16BIT SIGMA-DELTA 16TSSOP AD7715ARZ-3REEL-ND - IC ADC 16BIT SIGMA-DELTA 16SOIC AD7715ARZ-3-ND - IC ADC 16BIT 3V 16-SOIC AD7715ANZ-5-ND - IC ADC 16BIT 5V 16-DIP AD7715ARZ-5REEL-ND - IC ADC 16BIT 5V 16-SOIC AD7715ARZ-5-ND - IC ADC 16BIT SIGMA-DELTA 16-SOIC 更多... |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
AD7715
Rev. D | Page 30 of 40
The serial interface can be reset by exercising the RESET input
on the part. It can also be reset by writing a series of 1s on the
DIN input. If a Logic 1 is written to the AD7715 DIN line for
at least 32 serial clock cycles, the serial interface is reset. This
ensures that in three-wire systems that if the interface gets lost
either via a software error or by some glitch in the system, it can
be reset back into a known state. This state returns the interface
to where the AD7715 is expecting a write operation to its com-
munications register. This operation in itself does not reset the
contents of any registers, but because the interface was lost, the
information that was written to any of the registers is unknown
and it is advisable to set up all registers again.
the AD7715 with CS used to decode the part.
is for a
read operation from the AD7715’s output shift register, while
shows a write operation to the input shift register. It is
possible to read the same data twice from the output register
even though the
DRDY line returns high after the first read
operation. Take care, however, to ensure that the read operations
have been completed before the next output update is about to
take place.
The AD7715 serial interface can operate in three-wire mode by
tying the CS input low. In this case, the SCLK, DIN and DOUT
lines are used to communicate with the AD7715 and the status
of DRDY can be obtained by interrogating the MSB of the com-
munications register. This scheme is suitable for interfacing to
microcontrollers. If CS is required as a decoding signal, it can
be generated from a port bit. For microcontroller interfaces, it is
recommended that the SCLK idles high between data transfers.
Some microprocessor or microcontroller serial interfaces have
a single serial data line. In this case, it is possible to connect
the DOUT and DIN lines of the AD7715 together and connect
them to the single data line of the processor. A 10 kΩ pull-up
resistor should be used on this single data line. In this case, if
the interface gets lost, because the read and write operations
share the same line the procedure to reset it back to a known
state is somewhat different than described previously. It requires
a read operation of 24 serial clocks followed by a write operation
where a Logic 1 is written for at least 32 serial clock cycles to
ensure that the serial interface is back into a known state.
The AD7715 can also be operated with CS used as a frame
synchronization signal. This scheme is suitable for DSP
interfaces. In this case, the first bit (MSB) is effectively clocked
out by CS because CS would normally occur after the falling
edge of SCLK in DSPs. The SCLK can continue to run between
data transfers provided the timing numbers are obeyed.
DOUT
SCLK
CS
DRDY
MSB
t5
t7
t8
t9
LSB
t6
t3
t4
t10
08
51
9-
0
08
Figure 8. Read Cycle Timing Diagram
DIN
SCLK
CS
MSB
LSB
t11
t12
t15
t16
t13
t14
08
51
9-
00
9
Figure 9. Write Cycle Timing Diagram
相关PDF资料 |
PDF描述 |
|---|---|
| MLG1005S0N3C | INDUCTOR MULTILAYER 0.3NH 0402 |
| DC1500A-C | BOARD SAR ADC LTC2391-16 |
| STD17W-F | WIRE & CABLE MARKERS |
| EVAL-AD7705EBZ | BOARD EVALUATION FOR AD7705 |
| DC1500A-B | BOARD SAR ADC LTC2392-16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EVAL-AD7715-3EBZ1 | 制造商:AD 制造商全称:Analog Devices 功能描述:3 V/5 V, 450 ??A 16-Bit, Sigma-Delta ADC |
| EVAL-AD7715-5EB | 制造商:Analog Devices 功能描述:EVLAUATION BOARD - Bulk |
| EVAL-AD7716EB | 制造商:Analog Devices 功能描述:LC2MOS 22-BIT DATA ACQUISITION SYSTEM 制造商:Analog Devices 功能描述:EVALUATION BOARD - Bulk |
| EVAL-AD7716EBZ | 制造商:Analog Devices 功能描述:EVAL BRD AD7716 - Bulk |
| EVAL-AD7718EB | 制造商:Analog Devices 功能描述:Evaluation Kit For 8-/10-Channel, Low Voltage, Low Power, Segma-Delta ADCs 制造商:Rochester Electronics LLC 功能描述:EVALUATION BOARD I.C. - Bulk |
发布紧急采购，3分钟左右您将得到回复。