- 您现在的位置：买卖IC网 > PDF目录17030 > EVAL-AD974CB (Analog Devices Inc)BOARD EVAL FOR AD974 PDF资料下载
参数资料
| 型号： | EVAL-AD974CB |
| 厂商： | Analog Devices Inc |
| 文件页数： | 8/20页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL FOR AD974 |
| 标准包装： | 1 |
| ADC 的数量： | 1 |
| 位数： | 16 |
| 采样率（每秒）： | 200k |
| 数据接口： | 串行 |
| 输入范围： | ±10 V |
| 在以下条件下的电源（标准）： | 120mW @ 200kSPS |
| 工作温度： | -40°C ~ 85°C |
| 已用 IC / 零件： | AD974 |
| 已供物品： | 板 |
| 相关产品： | AD974BRZ-ND - IC DAS 16BIT 4CH 200KSPS 28SOIC AD974BNZ-ND - IC DAS 16BIT 4CH 200KSPS 28DIP AD974ARZ-ND - IC DAS 16BIT 4CH 200KSPS 28-SOIC AD974ARSZ-ND - IC DAS 16BIT 4CH 200KSPS 28-SSOP AD974ANZ-ND - IC DAS 16BIT 4CH 200KSPS 28DIP AD974BRS-RL7-ND - IC DAS 16BIT 4CH 200KSPS 28SSOP AD974BRSZ-ND - IC DAS 16BIT 4CH 200KSPS 28-SSOP AD974BRS-ND - IC DAS 16BIT 4CH 200KSPS 28-SSOP AD974BR-ND - IC DAS 16BIT 4CH 200KSPS 28-SOIC AD974BN-ND - IC DAS 16BIT 4CH 200KSPS 28-DIP 更多... |
REV. A
AD974
–16–
AC PERFORMANCE
The AD974 is fully specified and tested for dynamic perfor-
mance specifications. The ac parameters are required for signal
processing applications such as speech recognition and spectrum
analysis. These applications require information on the ADC’s
effect on the spectral content of the input signal. Hence, the
parameters for which the AD974 is specified include S/(N+D),
THD and Spurious Free Dynamic Range. These terms are
discussed in greater detail in the following sections.
As a general rule, it is recommended that the results from sev-
eral conversions be averaged to reduce the effects of noise and
thus improve parameters such as S/(N+D) and THD. AC per-
formance can be optimized by operating the ADC at its maxi-
mum sampling rate of 200 kHz and digitally filtering the resulting
bit stream to the desired signal bandwidth. By distributing noise
over a wider frequency range the noise density in the frequency
band of interest can be reduced. For example, if the required
input bandwidth is 50 kHz, the AD974 could be oversampled
by a factor of 4. This would yield a 6 dB improvement in the
effective SNR performance.
FREQUENCY – kHz
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
–100
–110
–125
0
1020
30
40
50
607080
90
100
AMPLITUDE
–
dB
5
15
25
3545
55
6575
8595
5280 POINT FFT
fSAMPLE = 200kHz
fIN = 20kHz
SNRD = 86.7dB
THD = 100.7dB
Figure 16. FFT Plot
DC PERFORMANCE
The factory calibration scheme used for the AD974 compen-
sates for bit weight errors that may exist in the capacitor array.
The mismatch in capacitor values is adjusted (using the calibra-
tion coefficients) during a conversion, resulting in excellent dc
linearity performance. Figures 17 and 18, respectively, show
typical INL and DNL plots for the AD974 at +25
°C.
A histogram test is a statistical method for deriving an A/D
converter’s differential nonlinearity. A ramp input is sampled
by the ADC and a large number of conversions are taken at
each voltage level, averaged and then stored. The effect of
averaging is to reduce the transition noise by 1/n. If 64 samples
are averaged at each point, the effect of transition noise is
reduced by a factor of 8; i.e., a transition noise of 0.8 LSBs rms
is reduced to 0.1 LSBs rms. Theoretically the codes, during a
test of DNL, would all be the same size and therefore have an
equal number of occurrences. A code with an average number
of occurrences would have a DNL of “0.” A code that is
different from the average would have a DNL that was either
greater or less than zero LSB. A DNL of –1 LSB indicates that
there is a missing code present at the 16-bit level and that the
ADC exhibits 15-bit performance.
SAMPLES – K
2.0
1.5
1.0
0.5
0
–0.5
–1.0
–1.5
–2.0
0
5
10
15
20
25
30
35
40
45
50
55
60
66
100%
Figure 17. INL Plot
SAMPLES – K
2.0
1.5
1.0
0.5
0
–0.5
–1.0
–1.5
–2.0
0
5
10
15
20
25
30
35
40
45
50
55
60
66
100%
Figure 18. DNL Plot
INPUT SIGNAL FREQUENCY – kHz
90
1
1000
100
10
80
70
60
50
40
30
20
10
SNR+D (dB) FOR AD974
SINAD
(dB)
FOR
V
IN
=
0dB
Figure 19. S/(N+D) vs. Input Frequency
相关PDF资料 |
PDF描述 |
|---|---|
| GBM25DCTI | CONN EDGECARD 50POS DIP .156 SLD |
| GCC12DREH-S93 | CONN EDGECARD 24POS .100 EYELET |
| PI5PD2065TAEX | IC POWER DIST USB 2.3A 5SOT23 |
| EYM12DTMS-S189 | CONN EDGECARD 24POS R/A .156 SLD |
| PI5PD2065WEX | IC POWER DIST USB 2.3A 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EVAL-AD976ACB | 功能描述:BOARD EVAL FOR AD976A RoHS:否 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| EVAL-AD976CB | 功能描述:BOARD EVAL FOR AD976 RoHS:否 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| EVAL-AD977ACB | 功能描述:BOARD EVAL FOR AD977A RoHS:否 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| EVAL-AD977CB | 功能描述:BOARD EVAL FOR AD977 RoHS:否 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| EVAL-AD9830EBZ | 功能描述:BOARD EVALUATION AD9830 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:- 主要目的:电信，线路接口单元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要属性:T1/J1/E1 LIU 次要属性:- 已供物品:板，电源，线缆，CD 其它名称:82EBV2081 |
发布紧急采购，3分钟左右您将得到回复。