- 您现在的位置：买卖IC网 > PDF目录16543 > EVAL-ADF4113EBZ1 (Analog Devices Inc)BOARD EVAL FOR ADF4113 PDF资料下载
参数资料
| 型号： | EVAL-ADF4113EBZ1 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 5/28页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL FOR ADF4113 |
| 标准包装： | 1 |
| 主要目的： | 计时，频率合成器 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | ADF4113 |
| 主要属性： | 单路整数-N PLL |
| 次要属性： | 1.75GHz 图形用户界面 |
| 已供物品： | 板，线缆，软件 |
| 相关产品： | ADF4113BCPZ-ND - IC PLL FREQ SYNTHESIZER 20-LFCSP ADF4113BCPZ-RL7-ND - IC PLL FREQ SYNTHESIZER 20-LFCSP ADF4113BCPZ-RL-ND - IC PLL FREQ SYNTHESIZER 20-LFCSP ADF4113HVBRUZ-RL7-ND - IC CHARGE PUMP HV SYNTH 16-TSSOP ADF4113HVBRUZ-RL-ND - IC CHARGE PUMP HV SYNTH 16-TSSOP ADF4113HVBCPZ-RL7-ND - IC CHARGE PUMP HV SYNTH 20-LFCSP ADF4113HVBCPZ-RL-ND - IC CHARGE PUMP HV SYNTH 20-LFCSP ADF4113HVBRUZ-ND - IC CHARGE PUMP HV SYNTH 16-TSSOP ADF4113HVBCPZ-ND - IC CHARGE PUMP HV SYNTH 20-LFCSP ADF4113BRUZ-REEL7TR-ND - IC SYNTHESZR FREQ PLL RF 16TSSOP 更多... |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
Data Sheet
ADF4110/ADF4111/ADF4112/ADF4113
Rev. F | Page 13 of 28
PHASE FREQUENCY DETECTOR (PFD) AND
CHARGE PUMP
The PFD takes inputs from the R counter and N counter (N =
BP + A) and produces an output proportional to the phase and
frequency difference between them. Figure 31 is a simplified
schematic. The PFD includes a programmable delay element
that controls the width of the antibacklash pulse. This pulse
ensures that there is no dead zone in the PFD transfer function
and minimizes phase noise and reference spurs. Two bits in the
reference counter latch, ABP2 and ABP1, control the width of
the pulse. See Table 7.
P
PROGRAMMABLE
DELAY
U3
CLR2
Q2
D2
U2
CLR1
Q1
D1
CHARGE
PUMP
DOWN
UP
HI
U1
ABP1
ABP2
R DIVIDER
N DIVIDER
CP OUTPUT
R DIVIDER
N DIVIDER
CP
CPGND
V
03496-0-031
Figure 31. PFD Simplified Schematic and Timing (In Lock)
MUXOUT AND LOCK DETECT
The output multiplexer on the ADF4110 family allows the user
to access various internal points on the chip. The state of
MUXOUT is controlled by M3, M2, and M1 in the function
latch. Table 9 shows the full truth table. Figure 32 shows the
MUXOUT section in block diagram form.
Lock Detect
MUXOUT can be programmed for two types of lock detect:
digital lock detect and analog lock detect.
Digital lock detect is active high. When LDP in the R counter
latch is set to 0, digital lock detect is set high when the phase
error on three consecutive phase detector (PD) cycles is less
than 15 ns. With LDP set to 1, five consecutive cycles of less
than 15 ns are required to set the lock detect. It stays high until
a phase error greater than 25 ns is detected on any subsequent
PD cycle.
The N-channel open-drain analog lock detect should be
operated with a 10 k nominal external pull-up resistor. When
lock has been detected, this output is high with narrow low-
going pulses.
CONTROL
MUX
DVDD
MUXOUT
DGND
ANALOG LOCK DETECT
DIGITAL LOCK DETECT
R COUNTER OUTPUT
N COUNTER OUTPUT
SDOUT
03496-0-032
Figure 32. MUXOUT Circuit
INPUT SHIFT REGISTER
The ADF4110 family digital section includes a 24-bit input shift
register, a 14-bit R counter, and a 19-bit N counter comprised of
a 6-bit A counter and a 13-bit B counter. Data is clocked into
the 24-bit shift register on each rising edge of CLK MSB first.
Data is transferred from the shift register to one of four latches
on the rising edge of LE. The destination latch is determined by
the state of the two control bits (C2, C1) in the shift register.
These are the two LSBs, DB1 and DB0, as shown in Figure 2.
The truth table for these bits is shown in Table 5.
Table 6 shows a summary of how the latches are programmed.
Table 5. C2, C1 Truth Table
Control Bits
C2
C1
Data Latch
0
R Counter
0
1
N Counter (A and B)
1
0
Function Latch (Including Prescaler)
1
Initialization Latch
相关PDF资料 |
PDF描述 |
|---|---|
| EBM31DCBN | CONN EDGECARD 62POS R/A .156 SLD |
| EBM31DCBH | CONN EDGECARD 62POS R/A .156 SLD |
| ECE-T2GA681FA | CAP ALUM 680UF 400V 20% SNAP |
| EBM31DCBD | CONN EDGECARD 62POS R/A .156 SLD |
| EBM31DCAN | CONN EDGECARD 62POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EVAL-ADF4113EBZ2 | 功能描述:BOARD EVAL FOR ADF4113 1750MHZ RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:PSoC® 主要目的:电源管理，热管理 嵌入式:- 已用 IC / 零件:- 主要属性:- 次要属性:- 已供物品:板，CD，电源 |
| EVAL-ADF4113HVEB1Z | 功能描述:BOARD EVALUATION FOR ADF4113HV RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:- 主要目的:电信，线路接口单元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要属性:T1/J1/E1 LIU 次要属性:- 已供物品:板，电源，线缆，CD 其它名称:82EBV2081 |
| EVAL-ADF4118EB1 | 制造商:AD 制造商全称:Analog Devices 功能描述:WCDMA Evaluation Board For PLL Frequency Synthesizer |
| EVAL-ADF4118EBZ1 | 功能描述:BOARD EVAL FOR ADF4118 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:- 主要目的:电信，线路接口单元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要属性:T1/J1/E1 LIU 次要属性:- 已供物品:板，电源，线缆，CD 其它名称:82EBV2081 |
| EVAL-ADF4118EBZ11 | 制造商:AD 制造商全称:Analog Devices 功能描述:RF PLL Frequency Synthesizers |
发布紧急采购，3分钟左右您将得到回复。