- 您现在的位置：买卖IC网 > PDF目录68993 > FA5515P (FUJI ELECTRIC CO LTD) 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP8 PDF资料下载
参数资料
| 型号： | FA5515P |
| 厂商： | FUJI ELECTRIC CO LTD |
| 元件分类： | 稳压器 |
| 英文描述： | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP8 |
| 封装： | DIP-8 |
| 文件页数： | 10/22页 |
| 文件大小： | 260K |
| 代理商： | FA5515P |
FA551X
18
8. Simple voltage control on the primary side
In a flyback type power supply, the output voltages of the power
supply and auxiliary winding voltage are almost proportional to
the number of winding turns of the transformer. This
characteristic can be used in the circuit shown in Figure 30,
where the output voltage can easily be made constant by
detecting the auxiliary winding voltage.
However, this is an easy output voltage control method, and the
output voltage precision and regulation are therefore not as
good.
To reduce output pulse width completely to 0%, the FB pin
voltage must fall below 0.9V and R5 must be set below about
1k
from the characteristics of the FB pin voltage and source
current.
9. Disabling the overload shutdown function
As shown in Figure 31, connect a 10k
resistor R6 between
the FB pin and the ground. The FB pin voltage then does not
rise sufficiently high to reach the shutdown threshold voltage
when an overload occurs so that IC does not enter OFF latch
mode. Use a 5% or better-precision resistor for R6.
Even with this connection, the overvoltage shutdown function is
available.
10. Polarities for overcurrent detecting and their
characteristics
The FA5510/11 uses positive polarity detection for overcurrent
limiting (number 3 pin of IS pin) and the FA5514/15 uses
negative polarity detection. The characteristics of positive and
negative polarity detection are summarized below. Select one
in accordance with the circuit used. (See item 4 in “Description
of each circuit.”)
Positive detection (FA5510/11)
Wiring is easy because the ground can be shared by the main
circuit and IC peripherals.
It is easy to correct the current detected as overload against
the input voltage.
Negative detection (FA5514/15)
The MOSFET drive current does not flow to the current
detection resistor and therefore it hardly affects overcurrent
detection.
11. Correcting overload detection current (FA5510/11 only)
If the power supply output is overloaded, the overcurrent
limiting function restricts the output power and the overload
shutdown function stops the IC. The output current when an
overload occurs varies depending on the input voltage; the
higher the input voltage, the more the overload detection
current may increase. If any problems occur as a result of the
appearance of this symptom, connect resistor R8 between
current detection resistor Rs and the IS (+) pin and add resistor
R7 for correction as shown in Figure 32. The standard
resistance of R8 is several hundred ohms, and that of R7 is
from several hundred kilohms to several megohms.
Note that the above correction slightly lowers the output current
when overload even where the input voltage is low. This
correction is available only for the FA5510/11 that uses positive
polarity for overcurrent detection.
Fig. 30
Simple voltage control circuit
FB
GND
VCC
REF
FA551X
R5
C2
n3
n1
n2
C1
Vout
6
7
4
2
FB
GND
FA551X
C4
R3
R6
2
4
10k
Fig. 31
Disabling overload shutdown function
FA5510/11
IS(+)
R8
R7
Rs
C1
T1
DB
~
+
–
AC input
3
Fig. 32
Correction of overload detection current
相关PDF资料 |
PDF描述 |
|---|---|
| FA5514N | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5515N | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5510N | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5511P | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP8 |
| FA5514P | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FA5515P-D1 | 制造商:Fuji Electric 功能描述: |
| FA551X | 制造商:未知厂家 制造商全称:未知厂家 功能描述:CMOS IC For Switching Power Supply Control |
| FA5526 | 制造商:FUJI 制造商全称:Fuji Electric 功能描述:Fuji Switching Power Control IC |
| FA5527 | 制造商:FUJI 制造商全称:Fuji Electric 功能描述:Fuji Switching Power Control IC |
| FA5527P-A2 | 制造商:Fuji Electric 功能描述: |
发布紧急采购，3分钟左右您将得到回复。