参数资料
型号: IR2166
厂商: International Rectifier
英文描述: RES 560 OHM 1/10W 5% SM
中文描述: 功率因数校正
文件页数: 23/29页
文件大小: 371K
代理商: IR2166
IR2166
www.irf.com
23
When the switch MPFC is turned on, the inductor
LPFC is connected between the rectified line
input (+) and (-) causing the current in LPFC to
charge up linearly. When MPFC is turned off,
LPFC is connected between the rectified line
input (+) and the DC bus capacitor CBUS
(through diode DPFC) and the stored current in
LPFC flows into CBUS. As MPFC is turned on
and off at a high-frequency, the voltage on CBUS
charges up to a specified voltage. The feedback
loop of the IR2166 regulates this voltage to a
fixed value by continuously monitoring the DC
voltage and adjusting the on-time of MPFC
accordingly. For an increasing DC bus the on-
time is decreased, and for a decreasing DC bus
the on-time is increased. This negative feedback
control is performed with a slow loop speed and
a low loop gain such that the average inductor
current smoothly follows the low-frequency line
input voltage for high power factor and low THD.
The on-time of MPFC therefore appears to be
fixed (with an additional modulation to be
discussed later) over several cycles of the line
voltage. With a fixed on-time, and an off-time
determined by the inductor current discharging
to zero, the result is a system where the
switching frequency is free-running and
constantly changing from a high frequency near
the zero crossing of the AC input line voltage,
to a lower frequency at the peaks (Figure 7).
Figure 7: Sinusoidal line input voltage (solid line), triangular
PFC Inductor current and smoothed sinusoidal line input
current (dashed line) over one half-cycle of the line input
voltage.
When the line input voltage is low (near the zero
crossing), the inductor current will charge up to
a small amount and the discharge time will be
fast resulting in a high switching frequency.
When the input line voltage is high (near the
peak), the inductor current will charge up to a
higher amount and the discharge time will be
longer giving a lower switching frequency. The
triangular PFC inductor current is then smoothed
by the EMI filter to produce a sinusoidal line
input current.
The PFC control circuit of the IR2166 (Figure 8)
only requires four control pins: VBUS, COMP,
ZX and PFC. The VBUS pin is for sensing the
DC bus voltage (via an external resistor voltage
divider), the COMP pin programs the on-time of
MPFC and the speed of the feedback loop, the
ZX pin detects when the inductor current
discharges to zero (via a secondary winding
from the PFC inductor), and the PFC pin is the
low-side gate driver output for MPFC.
V, I
t
相关PDF资料
PDF描述
IR2166PBF PFC & BALLAST CONTROL IC
IR2166S PFC & BALLAST CONTROL IC
IR2167 PFC BALLAST CONTROL IC
IR2167S PFC Ballast Control. Thermal Overload Protection. Brown Out Protection. Programmable Preheat and Frequency. Programmable Deadtime in a 20 Lead SOIC package
IR2170 OVER CURRENT SENSING IC
相关代理商/技术参数
参数描述
IR2166PBF 功能描述:功率驱动器IC PFC Ballast Cntrl RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
IR2166PBF 制造商:International Rectifier 功能描述:Controller IC Output Voltage Max.:25V
IR2166S 功能描述:IC PFC/BALLAST CONTROL 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 照明,镇流器控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:CCFL 控制器 频率:40 ~ 80 kHz 电流 - 电源:5mA 电流 - 输出:- 电源电压:4.5 V ~ 5.5 V 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC(0.154",3.90mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR) 其它名称:90-3991V+V01
IR2166SPBF 功能描述:功率驱动器IC PFC BALLAST CTRL IC 600V 15.6V VCC ESD RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
IR2166STRPBF 功能描述:功率驱动器IC PFC Ballast Cntrl RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube