参数资料
型号: IR3086AMPBF
厂商: International Rectifier
文件页数: 8/33页
文件大小: 0K
描述: IC PHASE CONTROLLER OVP 20MLPQ
标准包装: 100
系列: XPhase™
应用: 处理器
电流 - 电源: 10mA
电源电压: 8.4 V ~ 14 V
工作温度: 0°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 20-MLPQ
供应商设备封装: 20-MLPQ(4x4)
包装: 剪切带 (CT)
其它名称: *IR3086AMPBF
IR3086APbF
50% RAMP
DUTY CYCLE
SLOPE = 80mV / % DC
VPEAK (5.0V)
VPHASE4&5 (4.5V)
SLOPE = 1.6mV / ns @ 200kHz
SLOPE = 8.0mV / ns @ 1MHz
VPHASE3&6 (3.5V)
VPHASE2&7 (2.5V)
VPHASE1&8 (1.5V)
VVALLEY (1.00V)
CLK1
CLK2
CLK3
CLK4
CLK5
CLK6
CLK7
CLK8
Figure 3. 8 Phase Oscillator Waveforms
PWM Operation
The PWM comparator is located in the Phase IC. Upon receiving a clock pulse, the PWM latch is set; the PWMRMP
voltage begins to increase; the low side driver is turned off, and the high side driver is then turned on after the non-
overlap time. When the PWMRMP voltage exceeds the Error Amplifier’s output voltage, the PWM latch is reset.
This turns off the high side driver and turns on the low side driver after the non-overlap time; it activates the Ramp
Discharge Clamp, which quickly discharges the PWMRMP capacitor to the VDAC voltage of the Control IC until the
next clock pulse.
The PWM latch is reset dominant allowing all phases to go to zero duty cycle within a few tens of nanoseconds in
response to a load step decrease. Phases can overlap and go to 100% duty cycle in response to a load step
increase with turn-on gated by the clock pulses. An Error Amplifier output voltage greater than the common mode
input range of the PWM comparator results in 100% duty cycle regardless of the voltage of the PWM ramp. This
arrangement guarantees the Error Amplifier is always in control and can demand 0 to 100% duty cycle as required.
It also favors response to a load step decrease which is appropriate given the low output to input voltage ratio of
most systems. The inductor current will increase much more rapidly than decrease in response to load transients.
This control method is designed to provide “single cycle transient response” where the inductor current changes in
response to load transients within a single switching cycle maximizing the effectiveness of the power train and
minimizing the output capacitor requirements. An additional advantage of the architecture is that differences in
ground or input voltage at the phases have no effect on operation since the PWM ramps are referenced to VDAC.
Figure 4 depicts PWM operating waveforms under various conditions.
Page 8 of 33
May 13, 2009
相关PDF资料
PDF描述
IR3086MPBF IC CONTROLLER PHASE 20MLPQ
IR3087MPBF IC XPHASE W/OVP/TM CTRL 20MLPQ
IR3087M IC XPHASE W/OVP/TM CTRL 20-MLPQ
IR3088AMPBF IC XPHASE CONTROL 20L-MLPQ
IR3088AMTR IC XPHASE W/FAULT DET 20L-MLPQ
相关代理商/技术参数
参数描述
IR3086AMPBF 制造商:International Rectifier 功能描述:Controller IC Package/Case:20-MLPQ
IR3086AMTR 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASETM PHASE IC WITH OVP, FAULT AND OVERTEMP DETECT
IR3086AMTRPBF 功能描述:开关变换器、稳压器与控制器 XPHASE PHASE IC Overtemp 2.5A 200ns RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
IR3086AMTRPBF-CUT TAPE 制造商:IR 功能描述:IR3086APbF Series 14 V 400 KHz Phase IC Combined with an IR XPhaseTM Control IC
IR3086APBF 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE PHASE IC WITH OVP, FAULT AND OVERTEMP DETECT