- 您现在的位置：买卖IC网 > PDF目录14727 > IR3837MTR1PBF (International Rectifier)IC REG BUCK SYNC ADJ 14A PQFN17 PDF资料下载
参数资料
| 型号： | IR3837MTR1PBF |
| 厂商： | International Rectifier |
| 文件页数： | 16/36页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 14A PQFN17 |
| 产品培训模块： | SupIRBuck? Family and POL Design Tools Overview |
| 标准包装： | 1 |
| 系列： | SupIRBuck™ |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 14.4 V |
| 输入电压： | 1.5 V ~ 16 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 225kHz ~ 1.65MHz |
| 电流 - 输出： | 14A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 17-VQFN |
| 包装： | 标准包装 |
| 供应商设备封装： | 17-PQFN（5x6） |
| 其它名称： | IR3837MTR1PBFDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
IR3837MPbF
External Synchronization
The IR3837 incorporates an internal circuit which
enables synchronization of the internal oscillator
(using rising edge) to an external clock. An
external resistor from Rt pin to Gnd is still
required to set the free-running frequency close
to the Sync input frequency. This function is
important to avoid sub-harmonic oscillations due
to beat frequency for embedded systems when
multiple POL (point of load) regulators are used.
Applying the external signal to the Sync input
changes the effective value of the ramp signal
(Vramp/Vosc).
Vosc 1 ? 1 . 8 ? f Free _ Run f Sync .......... .......... .... (5)
Fig. 7. Connection of over current sensing resistor
As mentioned earlier, an over current is detected
if the OCSet pin goes below ground. Hence, at
the current limit threshold, V OCset =0. Then, for a
current limit setting I Limit , R OCSet is calculated as
follows:
R DS ( on ) * I Limit
R OCSet ? .......... .......... .... (4)
I OCSet
An over-current detection trips the OCP
comparator, latches OCP signal and cycles the
soft start function in hiccup mode.
The hiccup is performed by making the internal
SS signal equal to zero and counting the number
of switching cycles. The Soft Start pin is held low
until 4096 cycles have been completed. The
OCP signal resets and the converter recovers.
After every soft start cycle, the converter stays in
this mode until the overload or short circuit is
removed.
An optional 10pF-22pF filter capacitor can be
connected from OCSet pin to PGnd. It is
recommended to use this capacitor for very
narrow duty cycle applications (pulse-width
<150ns).
Thermal Shutdown
Temperature sensing is provided inside IR3837.
The trip threshold is typically set to 140 o C. When
trip threshold is exceeded, thermal shutdown
turns off both MOSFETs and resets the internal
soft start.
Automatic restart is initiated when the sensed
temperature drops within the operating range.
There is a 20 o C hysteresis in the thermal
shutdown threshold.
Rev 1.31
Equation (5) shows that the effective amplitude of
the ramp is reduced after the external Sync
signal is applied. More difference between the
frequency of the Sync and the free-running
frequency results in more change in the effective
amplitude of the ramp signal. Therefore, since
the ramp amplitude takes part in calculating the
loop-gain and bandwidth of the regulator, it is
recommended to not use a Sync frequency which
is much higher than the free-running frequency
(or vice versa). In addition, the effective value of
the ramp signal, given by equation (5), should be
used when the compensator is designed for the
regulator.
The pulse width of the external clock, which is
applied to the sync, should be greater than 100ns
and its high level should be greater than 2V,
while its lower level is less than 0.6V. For more
information refer to the Oscillator section in page-
6. If this pin is left floating, the IC will run with the
free running frequency set by the resistor Rt.
Output Voltage Tracking and Sequencing
The IR3837 can accommodate user
programmable tracking and/or sequencing
options using Vp, Vref, Enable, and Power Good
pins. In the block diagram presented on page 3,
the error-amplifier (E/A) has been depicted with
three positive inputs. Ideally, the input with the
lower voltage is used for regulating the output
voltage and the other two inputs are ignored. In
practice the voltage of the other two inputs
should be about 200mV greater than the low-
voltage input so that their effects can completely
be ignored. For normal operation, Vp is tied to
Vcc (1.5V < Vp < Vcc) and Vref is left floating
(with a bypass capacitor).
16
相关PDF资料 |
PDF描述 |
|---|---|
| MAX810TEXR+T10 | IC RESET CIRC MPU SC70-3 |
| MAX803REXR+T10 | IC RESET CIRC MPU SC70-3 |
| MAX810ZEXR+T10 | IC RESET CIRC MPU SC70-3 |
| MAX809TEXR+T10 | IC RESET CIRC MPU SC70-3 |
| MAX803LEXR+T10 | IC RESET CIRC MPU SC70-3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3837MTR1PBF | 制造商:International Rectifier 功能描述:IC DC-DC CONV 1.5 MHz QFN-17 制造商:International Rectifier 功能描述:IC, DC-DC CONV, 1.5 MHz, QFN-17 |
| IR3837MTR1PBF-CUT TAPE | 制造商:IR 功能描述:IR3837 Series 1.5 MHz 14 A Surface Mount Synchronous Buck Regulator - QFN-16 |
| IR3837MTRPBF | 功能描述:直流/直流开关调节器 14A SupIRBuck Reg 250-1500kHz, 1.5-16V RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| IR3838MPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:HIGHLY INTEGRATED 10A SINGLE-INPUT VOLTAGE, SYNCHRONOUS BUCK REGULATOR |
| IR3838MTR1PBF | 功能描述:直流/直流开关调节器 10A SupIRBuck Reg 250-1500kHz, 1.5-16V RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。