- 您现在的位置：买卖IC网 > PDF目录1811 > IRU3046CFTR (International Rectifier)IC REG CTRLR BUCK PWM VM 24TSSOP PDF资料下载
参数资料
| 型号： | IRU3046CFTR |
| 厂商： | International Rectifier |
| 文件页数： | 7/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 24TSSOP |
| 标准包装： | 1 |
| PWM 型： | 电压模式 |
| 输出数： | 2 |
| 频率 - 最大： | 450kHz |
| 占空比： | 90% |
| 电源电压： | 5 V ~ 12 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 24-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 剪切带 (CT) |
| 产品目录页面： | 1384 (CN2011-ZH PDF) |
| 其它名称： | *IRU3046CFTR IRU3046CFCT |
IRU3046
For higher efficiency, a low ESR capacitor is recom-
mended.
For the buck converter, the inductor value for desired
operating ripple current can be determined using the fol-
lowing relation:
For V I N 1 =5V, choose two Poscap from Sanyo
6TPB330M (6.3V, 330 m F, 40m V , 3A)
D i
V IN - V OUT = L 3 D t ; D t = D 3
1
f S
V OUT
; D = V IN
For V IN2 =12V, choose two 16TPB47M (16V, 47 m F,
L = (V IN - V OUT ) 3
V OUT
V IN 3D i 3 f S
---(6)
70m V , 1.4A).
Output Capacitor Selection
The criteria to select the output capacitor is normally
based on the value of the Effective Series Resistance
(ESR). In general, the output capacitor must have low
enough ESR to meet output ripple and load transient
requirements, yet have high enough ESR to satisfy sta-
bility requirements. The ESR of the output capacitor is
calculated by the following relationship:
Where:
V IN = Maximum Input Voltage
V OUT = Output Voltage
? i = Inductor Ripple Current
f S = Switching Frequency
? t = Turn On Time
D = Duty Cycle
For D i 1 =30% of I 1 , we get: L 1 =2.18 m H
For D i 2 =30% of I 2 , we get: L 2 =2.7 m H
D V O
ESR [ D I O
---(5)
The Coilcraft DO5022HC series provides a range of in-
ductors in different values and low profile for large cur-
Where:
D V O = Output Voltage Ripple
D I O = Output Current
rents.
For L 1 choose: DO5022P-222HC (2.2 m H,12A)
For L 2 choose: DO5022P-332HC (3.3 m H,10A)
D V O =75mV and D I O =10A, result to ESR=7.5m V
Power MOSFET Selection
The Sanyo TPC series, Poscap capacitor is a good choice.
The 6TPC150M 150 m F, 6.3V has an ESR 40m V . Se-
lecting six of these capacitors in parallel, results to an
ESR of ? 7m V which achieves our low ESR goal.
The capacitor value must be high enough to absorb the
inductor's ripple current. The larger the value of capaci-
The selections criteria to meet power transfer require-
ments is based on maximum drain-source voltage (V DSS ),
gate-source drive voltage (V GS ), maximum output cur-
rent, On-resistance R DS(ON) and thermal management.
The MOSFET must have a maximum operating voltage
(V DSS ) exceeding the maximum input voltage (V IN ).
tor, the lower will be the output ripple voltage.
The gate drive requirement is almost the same for both
P COND (Upper Switch) = I LOAD 3 R DS(ON) 3 D 3 q
P COND (Lower Switch) = I LOAD 3 R DS(ON) 3 (1 - D) 3 q
The resulting output ripple current is smaller then each
channel ripple current due to the 180 8 phase shift. These
currents cancel each other. The cancellation is not the
maximum because of the different duty cycle for each
channel.
Inductor Selection
The inductor is selected based on output power, operat-
ing frequency and efficiency requirements. Low induc-
tor value causes large ripple current, resulting in the
smaller size, but poor efficiency and high output noise.
Generally, the selection of inductor value can be reduced
to desired maximum ripple current in the inductor ( ? i);
the optimum point is usually found between 20% and
50% ripple of the output current.
MOSFETs. Caution should be taken with devices at very
low V GS to prevent undesired turn-on of the complemen-
tary MOSFET, which results a shoot-through current.
The total power dissipation for MOSFETs includes con-
duction and switching losses. For the Buck converter
the average inductor current is equal to the DC load cur-
rent. The conduction loss is defined as:
2
2
q = R DS(ON) Temperature Dependency
The total conduction loss is defined as:
P CON(TOTAL) =P CON (Upper Switch) q + P CON (Lower Switch) q
Rev. 1.9
09/27/02
www.irf.com
7
相关PDF资料 |
PDF描述 |
|---|---|
| IRU3047CWTR | IC REG CTRLR BUCK PWM VM 20-SOIC |
| IRU3048CFTR | IC REG CTRLR BUCK PWM VM 16TSSOP |
| IRU3055CQTR | IC CTRL SYNC 3-PHASE 36-QSOP |
| IRU3065CLTR | IC REG CTRLR INV PWM SOT23-6 |
| IRU3137CSTRPBF | IC REG CTRLR BUCK PWM VM 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IRU3046CFTRPBF | 制造商:International Rectifier 功能描述:DUAL SYNCHRONOUS PWM CONTROLLER WITH CURRENT SHARING CIRCUITRY AND LDO CONTROLLER |
| IRU3047 | 制造商:IRF 制造商全称:International Rectifier 功能描述:DUAL SYNCHRONOUS PWM CONTROLLER WITH CURRENT SHARING CIRCUITRY AND LDO CONTROLLER |
| IRU3047CW | 制造商:IRF 制造商全称:International Rectifier 功能描述:DUAL SYNCHRONOUS PWM CONTROLLER WITH CURRENT SHARING CIRCUITRY AND LDO CONTROLLER |
| IRU3047CWTR | 功能描述:IC REG CTRLR BUCK PWM VM 20-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| IRU3048 | 制造商:IRF 制造商全称:International Rectifier 功能描述:DUAL SYNCHRONOUS PWM CONTROLLER CIRCUITRY AND LDO CONTROLLER |
发布紧急采购，3分钟左右您将得到回复。