- 您现在的位置：买卖IC网 > PDF目录15165 > ISL6307ACRZ-T (Intersil)IC REG CTRLR BUCK PWM VM 48-QFN PDF资料下载
参数资料
| 型号： | ISL6307ACRZ-T |
| 厂商： | Intersil |
| 文件页数： | 25/33页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 48-QFN |
| 标准包装： | 4,000 |
| PWM 型： | 电压模式 |
| 输出数： | 6 |
| 频率 - 最大： | 275kHz |
| 占空比： | 66.7% |
| 电源电压： | 4.75 V ~ 5.25 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页
ISL6307A
compensate the temperature impact on the sensed current.
The block diagram of this function is shown in Figure 21.
TM
0.39*Vcc
0.33*Vcc
0.28*Vcc
VR_FAN
V CC
R TM1
TM
Non-linear
A/D
Channel current sense
I sen6
I sen5
I sen4
I sen3
I sen2
VR_HOT
Temperature
o c
R NTC
I 6
I 5
I 4
I 3
I 2
I 1
I sen1
T1
T2
T3
V CC
D/A
k i
FIGURE 20. VR_HOTAND VR_FAN SIGNAL VS TM VOLTAGE
Based on the NTC temperature characteristics and the
desired threshold of VR_HOT, the pull-up resistor R TM1 of
the TM pin is given by:
R TM1 = 2.75xR NTC ( T3 )
(EQ. 18)
R TC1
TCOMP
R TC2
4-bit
A/D
Droop, Iout &
Over current protection
R NTC(T3) is the NTC resistance at the VR_HOT threshold
temperature T3.
The NTC resistance at the set point T2 and release point T1
of VR_FAN can be calculated as:
FIGURE 21. BLOCK DIAGRAM OF INTEGRATED
TEMPERATURE COMPENSATION
When the TM NTC is placed close to the current sense
component (inductor or MOSFET), the temperature of the
NTC will track the temperature of the current sense
R NTC ( T2 ) = 1.267xR NTC ( T3 )
R NTC ( T1 ) = 1.644xR NTC ( T3 )
(EQ. 19)
(EQ. 20)
component. Therefore, the TM voltage can be utilized to
obtain the temperature of the current sense component.
ISL6307A converts the TM pin voltage to a 6-bit TM digital
signal for temperature compensation. With the non-linear
A/D converter of ISL6307A, TM digital signal is linearly
With the NTC resistance value obtained from Equations 19 &
20, the temperature T2 and T1 can be found from the NTC
datasheet.
Temperature Compensation
ISL6307A supports inductor DCR sensing, MOSFET
R DS(ON) sensing, or resistive sensing techniques. Both
inductor DCR and MOSFET R DS(ON) have positive
temperature coefficient, which is about +0.38%/°C. Because
the voltage across the inductor or MOSFET is sensed for
output current information, the sensed current has the same
positive temperature coefficient as the inductor DCR or
MOSFET R DS(ON) .
In order to obtain the correct current information, there
should be a way to correct the temperature impact on the
current sense component. ISL6307A provides two methods:
integrated temperature compensation and external
temperature compensation.
Integrated Temperature Compensation
When TCOMP voltage is equal or greater than Vcc/15,
ISL6307A will utilize the voltage at TM and TCOMP pins to
25
proportional to the NTC temperature. For accurate
temperature compensation, the ratio of the TM voltage to the
NTC temperature of the practical design should be similar to
that in Figure 19.
Depending on the location of the NTC and the air flow, the
NTC may be cooler or hotter than the current sense
component. TCOMP voltage can be utilized to correct the
temperature difference between NTC and the current sense
component. When a different NTC type or different voltage
divider is used for the TM function, TCOMP voltage can also
be used to compensate for the difference between the
recommended TM voltage curve in Figure 20 and that of the
actual design. ISL6307A converts the TCOMP pin voltage to
a 4-bit TCOMP digital signal as the TCOMP factor N.
TCOMP factor N is an integer between 0 and 15. The
integrated temperature compensation function is disabled for
N = 0. For N = 4, the NTC temperature is equal to the
temperature of the current sense component. For N < 4, the
NTC is hotter than the current sense component. The NTC is
cooler than the current sense component for N > 4. When
N > 4, the larger the TCOMP factor N, the larger the
difference between the NTC temperature and the
temperature of the current sense component.
FN9236.0
February 6, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| GMC22DRTN-S13 | CONN EDGECARD 44POS .100 EXTEND |
| CAT1021ZI-28-GT3 | IC SUPERVISOR CPU 2K EEPR 8MSOP |
| ECM25DTAD-S189 | CONN EDGECARD 50POS R/A .156 SLD |
| GSC22DRTH-S13 | CONN EDGECARD 44POS .100 EXTEND |
| GMC22DRTH-S13 | CONN EDGECARD 44POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6307AIRZ | 功能描述:IC REG CTRLR BUCK PWM VM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6307AIRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6307BCRZ | 功能描述:软开关 PWM 控制器 W/ANNEAL 6-PHS VR11 CNTRLR COM RoHS:否 制造商:Fairchild Semiconductor 输出端数量: 输出电流: 开关频率: 工作电源电压:30 V 电源电流: 最大工作温度:+ 105 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
| ISL6307BCRZ-T | 功能描述:软开关 PWM 控制器 W/ANNEAL 6-PHS VR11 CNTRLR COM TAPE AND RoHS:否 制造商:Fairchild Semiconductor 输出端数量: 输出电流: 开关频率: 工作电源电压:30 V 电源电流: 最大工作温度:+ 105 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
| ISL6307BIRZ | 功能描述:软开关 PWM 控制器 W/ANNEAL 6-PHS VR11 CNTRLR INDUSTRIAL RoHS:否 制造商:Fairchild Semiconductor 输出端数量: 输出电流: 开关频率: 工作电源电压:30 V 电源电流: 最大工作温度:+ 105 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。