参数资料
型号: ISL6323IRZ-T
厂商: Intersil
文件页数: 13/36页
文件大小: 0K
描述: IC HYBRID CTRLR PWM MONO 48-QFN
标准包装: 4,000
应用: 控制器,AMD SVI
输入电压: 5 V ~ 12 V
输出数: 2
输出电压: 最高 2V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 48-VFQFN 裸露焊盘
供应商设备封装: 48-QFN(7x7)
包装: 带卷 (TR)
ISL6323
INPUT-CAPACITOR CURRENT, 10A/DIV
CHANNEL 3
INPUT CURRENT
10A/DIV
CHANNEL 2
INPUT CURRENT
10A/DIV
CHANNEL 1
INPUT CURRENT
10A/DIV
1 μ s/DIV
FIGURE 2. CHANNEL INPUT CURRENTS AND INPUT
CAPACITOR RMS CURRENT FOR 3-PHASE
CONVERTER
Active Pulse Positioning Modulated PWM Operation
To further improve the transient response, ISL6323 also
implements Intersil’s proprietary Adaptive Phase Alignment
(APA) technique, which turns on all phases together under
transient events with large step current. With both APP and
APA control, ISL6323 can achieve excellent transient
performance and reduce the demand on the output capacitors.
Adaptive Phase Alignment (APA)
To further improve the transient response, the ISL6323 also
implements Intersil’s proprietary Adaptive Phase Alignment
(APA) technique, which turns on all of the channels together
at the same time during large current step transient events.
As Figure 3 shows, the APA circuitry works by monitoring the
voltage on the APA pin and comparing it to a filtered copy of
the voltage on the COMP pin. The voltage on the APA pin is
a copy of the COMP pin voltage that has been negatively
offset. If the APA pin exceeds the filtered COMP pin voltage
an APA event occurs and all of the channels are forced on.
The ISL6323 uses a proprietary Active Pulse Positioning (APP)
modulation scheme to control the internal PWM signals that
command each channel’s driver to turn their upper and lower
EXTERNAL CIRCUIT
APA
ISL6323 INTERNAL CIRCUIT
MOSFETs on and off. The time interval in which a PWM signal
can occur is generated by an internal clock, whose cycle time is
the inverse of the switching frequency set by the resistor
between the FS pin and ground. The advantage of Intersil’s
proprietary Active Pulse Positioning (APP) modulator is that the
C APA
R APA
V APA,TRIP
COMP
100μA
LOW
PASS
FILTER
+
APA
-
TO APA
CIRCUITRY
(EQ. 4)
V APA , TRIP = R APA ? 100 × 10
PWM signal has the ability to turn on at any point during this
PWM time interval, and turn off immediately after the PWM
signal has transitioned high. This is important because it allows
the controller to quickly respond to output voltage drops
associated with current load spikes, while avoiding the ring
back affects associated with other modulation schemes.
The PWM output state is driven by the position of the error
amplifier output signal, V COMP , minus the current correction
signal relative to the proprietary modulator ramp waveform as
illustrated in Figure 3. At the beginning of each PWM time
interval, this modified V COMP signal is compared to the
internal modulator waveform. As long as the modified V COMP
voltage is lower then the modulator waveform voltage, the
PWM signal is commanded low. The internal MOSFET driver
detects the low state of the PWM signal and turns off the
upper MOSFET and turns on the lower synchronous
MOSFET. When the modified V COMP voltage crosses the
modulator ramp, the PWM output transitions high, turning off
the synchronous MOSFET and turning on the upper
MOSFET. The PWM signal will remain high until the modified
V COMP voltage crosses the modulator ramp again. When this
occurs the PWM signal will transition low again.
During each PWM time interval the PWM signal can only
transition high once. Once PWM transitions high it can not
transition high again until the beginning of the next PWM
time interval. This prevents the occurrence of double PWM
pulses occurring during a single period.
13
ERROR
AMPLIFIER
FIGURE 3. ADAPTIVE PHASE ALIGNMENT DETECTION
The APA trip level is the amount of DC offset between the
COMP pin and the APA pin. This is the voltage excursion
that the APA and COMP pins must have during a transient
event to activate the Adaptive Phase Alignment circuitry.
This APA trip level is set through a resistor, R APA , that
connects from the APA pin to the COMP pin. A 100μA
current flows across R APA into the APA pin to set the APA
trip level as described in Equation 4. An APA trip level of
500mV is recommended for most applications. A 0.1μF
capacitor, C APA , should also be placed across the R APA
resistor to help with noise immunity.
– 6
PWM Operation
The timing of each core channel is set by the number of
active channels. Channel detection on the ISEN3- and
ISEN4- pins selects 2-channel to 4-channel operation for the
ISL6323. The switching cycle is defined as the time between
PWM pulse termination signals of each channel. The cycle
time of the pulse signal is the inverse of the switching
frequency set by the resistor between the FS pin and
FN9278.5
May 17, 2011
相关PDF资料
PDF描述
ADP1715ARMZ-3.0-R7 IC REG LDO 3V .5A 8-MSOP
ISL62882IRTZ-T IC REG PWM 2PHASE BUCK 40TQFN
ISL62882HRTZ-T IC REG PWM 2PHASE BUCK 40TQFN
2512-123K INDUCTOR POWER 12UH MOLDED SMD
RBM40DTMS-S189 CONN EDGECARD 80POS R/A .156 SLD
相关代理商/技术参数
参数描述
ISL6324ACRZ 功能描述:IC HYBRID CTRLR PWM DUAL 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器,Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN(7x7) 包装:管件
ISL6324ACRZR5381 制造商:Intersil Corporation 功能描述:4+1 PHASE CONTROLLER, CORE+NORTHBRIDGE, PROG PSI, 3.4MHZ SVI - Rail/Tube 制造商:Intersil Corporation 功能描述:IC HYBRID CTRLR PWM DUAL 48QFN
ISL6324ACRZ-T 功能描述:IC HYBRID CTRLR PWM DUAL 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器,Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN(7x7) 包装:管件
ISL6324ACRZ-TR5381 制造商:Intersil Corporation 功能描述:4+1 PHASE CONT., CORE + NORTHBRIDGE, PROG PSI, 3.4MHZ SVI, 5 - Tape and Reel 制造商:Intersil Corporation 功能描述:IC HYBRID CTRLR PWM DUAL 48QFN
ISL6324AIRZ 功能描述:IC HYBRID CTRLR PWM DUAL 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器,Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN(7x7) 包装:管件