参数资料
| 型号： | ISL6559CBZ-T |
| 厂商： | Intersil |
| 文件页数： | 10/21页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 28-SOIC |
| 标准包装： | 1 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 4MHz |
| 占空比： | 75% |
| 电源电压： | 4.75 V ~ 5.25 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 包装： | 标准包装 |
| 产品目录页面： | 1243 (CN2011-ZH PDF) |
| 其它名称： | ISL6559CBZ-TDKR |
ISL6559
sources, amplifiers and the reference so that the output
voltage remains within the specified system tolerance of
± 1 % over temperature.
LOAD-LINE REGULATION
Microprocessor load current demands change from near no-
load to full load often during operation. The resulting sizable
transient current slew rate causes an output voltage spike
since the converter is not able to respond fast enough to the
rapidly changing current demands. The magnitude of the
spike is dictated by the ESR and ESL of the output
capacitors selected. In order to drive the cost of the output
capacitor solution down, one commonly accepted approach
is active voltage positioning. By adding a well controlled
output impedance, the output voltage can effectively be level
shifted in a direction which works against the voltage spike.
The average current of all the active channels, I AVG , flows
out IOUT, see Figure 5. IOUT is connected to FB through a
load-line regulation resistor, R FB . The resulting voltage drop
across R FB is proportional to the output current, effectively
creating an output voltage droop with a steady-state value
defined as
DYNAMIC VID
Next generation microprocessors can change VID inputs at
any time while the regulator is in operation. The power
management solution is required to monitor the DAC inputs
and respond to VID voltage transitions or ‘on-the-fly’ VID
changes, in a controlled manner. Supervising the safe output
voltage transition within the DAC range of the processor
without discontinuity or disruption.
The ISL6559 checks the five VID inputs at the beginning of
each channel-1 switching cycle. If the VID code has
changed, the controller waits one complete switching cycle
to validate the new code. If the VID code is stable for this
entire switching cycle, then the controller will begin executing
the output voltage change. The controller begins
incrementing the reference voltage by making 25mV steps
every two switching cycles until it reaches the new VID code.
The total time required for a VID change, t DV , is dependent
on the switching frequency (f S ), the size of the change
( ? VID), and the time before the next switching cycle begins.
Since the ISL6559 recognizes VID-code changes only at the
beginning of switching cycles, up to one full cycle may pass
before a VID change registers. This is followed by a one-
V DROOP = I AVG R FB
(EQ. 5)
cycle wait before the output voltage begins to change. The
one-cycle uncertainty in Equation 8 is due to the possibility
that the VID code change may occur up to one full cycle
In most cases, each channel uses the same R ISEN value to
before being recognized.
----- ? 2 ------------------ – 1 ? < t DV ≤ ----- ? 2 ------------------ ?
f S ? 0.025
f S ? 0.025 ?
sense current. A more complete expression for V DROOP is
derived by combining equations 3 and 4.
?
1 ? VID 1 ? VID
(EQ. 8)
V DROOP = ------------- ---------------------- R FB
R ISEN
I OUT r DS ( ON )
N
(EQ. 6)
The time required for a converter running with f S = 500kHz to
make a 1.2V to 1.4V reference-voltage change is between
Droop is an optional feature of the ISL6559. If active voltage
positioning is not required, simply leave the IOUT pin open.
30 μ s and 32 μ s as calculated using Equation 8. This example
is also illustrated in Figure 7.
REFERENCE OFFSET
Typical microprocessor tolerance windows are centered
around a nominal DAC set point. Implementing a load-line
01110
00110
V ID , 5V/DIV
VID CHANGE OCCURS
ANYWHERE HERE
would require offsetting the output voltage above this
nominal DAC set point. Centering the load-line within the
static specification window. The ISL6559 features an internal
100 μ A current source which feeds out the OFS pin. Placing
a resistor from OFS and ground allows the user to set the
1.2V
V REF , 100mV/DIV
amount of positive offset desired directly to the reference
voltage. The voltage developed across the OFS resistor,
R OFS , is divided down internally by a factor of 10 and directly
counters the DAC voltage at the error amplifier non-inverting
input. Select the resistor value based on the voltage offset
desired, V OFS , using Equation 6.
1.2V
V OUT , 100mV/DIV
5 μ s/DIV
V OFS ? 10
R OFS = ---------------------------
100 μ A
10
(EQ. 7)
FIGURE 6. DYNAMIC-VID WAVEFORMS FOR 500KHZ
ISL6559 BASED MULTI-PHASE BUCK
CONVERTER
FN9084.8
December 29, 2004
相关PDF资料 |
PDF描述 |
|---|---|
| ISL6561CR-T | IC CTRLR PWM MULTIPHASE 40-QFN |
| ISL6563IR-T | IC CTRLR PWM MULTIPHASE 24-QFN |
| ISL6564AIRZ | IC REG CTRLR BUCK PWM VM 40-QFN |
| ISL6564IR-T | IC REG CTRLR BUCK PWM VM 40-QFN |
| ISL6565BCV-T | IC REG CTRLR BUCK PWM VM 28TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6559CR | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| ISL6559CR-T | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| ISL6559CRZ | 功能描述:电流型 PWM 控制器 2 TO 4 PHS BUCK CNTRLR 32L 5X5 MLFP RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL6559CRZR5265 | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6559CRZ-T | 功能描述:电流型 PWM 控制器 2 TO 4 PHS BUCK CNTRLR 32L 5X5 MLFP RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。