参数资料
| 型号： | ISL78200AVEZ |
| 厂商： | Intersil |
| 文件页数： | 3/22页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK BOOST SYNC 20HTSSOP |
| 标准包装： | 740 |
| 类型： | 降压（降压），升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 可调至 0.8V |
| 输入电压： | 3 V ~ 40 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 200kHz ~ 2.2MHz |
| 电流 - 输出： | 2.5A |
| 同步整流器： | 两者兼有 |
| 工作温度： | -40°C ~ 105°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 管件 |
| 供应商设备封装： | 20-HTSSOP |
ISL78200
Functional Pin Description (Continued)
PIN NAME
PHASE
EXT_BOOST
SYNC
LGATE
PAD
PIN #
16, 17
18
19
20
21
DESCRIPTION
These pins are the PHASE nodes that should be connected to the output inductor. These pins are connected to the source of
the high-side N channel MOSFET.
This pin is used to set boost mode and monitor the battery voltage that is the input of the boost converter. After VCC POR, the
controller will detect the voltage on this pin, if voltage on this pin is below 200mV, the controller is set in
synchronous/non-synchronous buck mode and latch in this state unless VCC is below the POR falling threshold; if the voltage
on this pin after VCC POR is above 200mV, the controller is set in boost mode and latch in this state.
In boost mode, this pin is used to monitor input voltage through a resistor divider. By setting the resistor divider, the high
threshold and hysteresis can be programmed. When voltage on this pin is above 0.8V, the PWM output (LGATE) for the boost
converter is disabled, and when voltage on this pin is below 0.8V minus the hysteresis, the boost PWM is enabled.
In boost mode operation, PFM is disabled when boost PWM is enabled. Check Boost Mode Operation in the “Functional
This pin can be used to synchronize two or more ISL78200 controllers. Multiple ISL78200 can be synchronized with their SYNC
pins connected together. 180 degree phase shift is automatically generated between the master and slave ICs.
The internal oscillator can also lock to an external frequency source applied on this pin with square pulse waveform (with
frequency 10% higher than the IC’s local frequency, and pulse width higher than 150ns).
This pin should be left floating if not used. Range: 0V to 5.5V.
In synchronous buck mode, this pin is used to drive the lower side MOSFET to improve efficiency.
In non-synchronous buck when a diode is used as the bottom side power device, this pin should be connected to VCC before
VCC start-up to have low-side driver (LGATE) disabled.
In boost mode, it can be used to drive the boost power MOSFET. The boost control PWM is the same with the buck control PWM.
Bottom thermal pad. It is not connected to any electrical potential of the IC. In layout it must be connected to PCB ground
copper plane with an area as large as possible to effectively reduce the thermal impedance.
Ordering Information
PART
TEMP.
NUMBER
(Notes 1, 2, 3)
ISL78200AVEZ
PART
MARKING
ISL78200 AVEZ
RANGE
(°C)
-40 to +105
PACKAGE
(Pb-Free)
20 Ld HTSSOP
PKG.
DWG. #
MDP0048
ISL78200EVAL1Z
Evaluation Board
NOTES:
1. Add “-T*” suffix for tape and reel. Please refer to TB347 for details on reel specifications.
2. These Intersil Pb-free plastic packaged products employ special Pb-free material sets, molding compounds/die attach materials, and 100% matte
tin plate plus anneal (e3 termination finish, which is RoHS compliant and compatible with both SnPb and Pb-free soldering operations). Intersil
Pb-free products are MSL classified at Pb-free peak reflow temperatures that meet or exceed the Pb-free requirements of IPC/JEDEC J STD-020.
3. For Moisture Sensitivity Level (MSL), please see device information page for ISL78200 . For more information on MSL please see techbrief TB363 .
3
FN7641.2
December 24, 2013
相关PDF资料 |
PDF描述 |
|---|---|
| ISL78205AVEZ | IC REG BUCK SYNC ADJ 20HTSSOP |
| ISL78210ARUZ-T | IC REG MULTI-OUTPUT 32TQFP |
| ISL78211ARZ | IC REG 1PHASE BUCK 40QFN |
| ISL78213ARZ | IC REG BUCK SYNC ADJ 3A 16VQFN |
| ISL78214ARZ | IC REG BUCK SYNC ADJ 4A 16QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL78200AVEZ-T | 功能描述:IC REG BUCK BOOST SYNC 20HTSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
| ISL78201AVEZ-T | 制造商:Intersil Corporation 功能描述:2.5A SYNC BUCK W PRE-BOOST REG, 20LD HTSSOP 4.4MM, T&R - Tape and Reel |
| ISL78201AVEZ-TR5303 | 制造商:Intersil Corporation 功能描述: 制造商:Intersil Corporation 功能描述:HARMAN BECKER ISL78201AVEZ-T W/SPECIAL CHANGE CONTROL, 12 MO - Tape and Reel |
| ISL78205 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:2.5A Buck Controller with Integrated High-Side MOSFET |
| ISL78205AVEZ | 功能描述:IC REG BUCK SYNC ADJ 20HTSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
发布紧急采购，3分钟左右您将得到回复。