- 您现在的位置：买卖IC网 > PDF目录80167 > L99PM62XPTR (STMICROELECTRONICS) 4-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 PDF资料下载
参数资料
| 型号： | L99PM62XPTR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 电源管理 |
| 英文描述： | 4-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 |
| 封装： | ROHS COMPLIANT, POWERSSO-36 |
| 文件页数： | 20/98页 |
| 文件大小： | 1117K |
| 代理商： | L99PM62XPTR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页
L99PM62XP
Description
Doc ID 16363 Rev 2
This is necessary for a defined start of the micro controller when the application is switched
on. Since the NRESET output is realized as an open drain output it is also possible to
connect an external NRESET open drain NRESET source to the output. It must be
considered that as soon the NRESET is released from the L99PM62 the Watchdog timing
starts.
A reset pulse (2 ms) is generated in case of:
●
V1 drops below Vrth (configurable by SPI) for more than 8 s
●
Watchdog failure
Note:
An external pull-up resistor (1k
Ω) to V1 is recommended in order to ensure ILOAD1 > Icmp
during reset condition
2.7
Operational amplifiers
The operational amplifiers are especially designed to be used for sensing and amplifying the
voltage drop across ground connected shunt resistors. Therefore the input common mode
range includes -0.2 V to 3 V.
The operational amplifiers are designed for -0.2 V to +3 V input voltage swing and rail-to-rail
output voltage range.
All pins (positive, negative and outputs) are available to be able to operate in non-inverting
and inverting mode. Both operational amplifiers are on-chip compensated for stability over
the whole operating range within the defined load impedance.
The operational amplifiers may also be used to setup an additional high current voltage
source with an external pass element. Refer to Section 2.1.3 for a detailed description.
2.8
LIN bus interface
Features
●
Speed communication up to 20 kbit/s.
●
LIN 2.1 compliant (SAEJ2602 compatible) transceiver.
●
Function range from +40 V to -18 V DC at LIN pin.
●
GND disconnection fail safe at module level.
●
Off mode: does not disturb network.
●
GND shift operation at system level.
●
Micro controller Interface with CMOS compatible I/O pins.
●
Internal pull up resistor.
●
Internal high-side switch to disconnect master pull-up resistor in case of short circuit of
bus signal.
●
ESD and transient immunity according to ISO7637 and EN / IEC61000-4-2.
●
Matched output slopes and propagation delay.
In order to further reduce the current consumption in standby mode, the integrated LIN bus
interface offers an ultra low current consumption.
Note:
Use of master pull-up switch is optional.
相关PDF资料 |
PDF描述 |
|---|---|
| LSN-1.8/10-D3J | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| LSN-1.25/10-D3B | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| LS4601-7EPD7TB1 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS5540-7ERD9TB1 | 2-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS5540-7ERD5TB1 | 2-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L99PM72GXPTR | 功能描述:Automotive PMIC PowerSSO-36 制造商:stmicroelectronics 系列:- 包装:剪切带（CT） 零件状态:有效 应用:汽车级 电流 - 电源:6mA 电压 - 电源:6 V ~ 18 V 工作温度:-40°C ~ 130°C 安装类型:表面贴装 封装/外壳:36-??FSOP（0.295"，7.50mm 宽） 供应商器件封装:PowerSSO-36 标准包装:1 |
| L99SD01-E | 制造商:STMicroelectronics 功能描述:ABD VIPOWER - Rail/Tube |
| L99SD01TR-E | 制造商:STMicroelectronics 功能描述:ABD VIPOWER - Tape and Reel |
| L9A0212 | 制造商:LSI 制造商全称:LSI 功能描述:Microprocessor |
| L9D112G80BG4 | 制造商:LOGIC 制造商全称:LOGIC 功能描述:1.2 Gb, DDR - SDRAM Integrated Module |
发布紧急采购，3分钟左右您将得到回复。