- 您现在的位置：买卖IC网 > PDF目录16329 > LMK04031BEVAL/NOPB (National Semiconductor)EVAL BOARD LMK04031BISQ PDF资料下载
参数资料
| 型号： | LMK04031BEVAL/NOPB |
| 厂商： | National Semiconductor |
| 文件页数： | 28/65页 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD LMK04031BISQ |
| 标准包装： | 1 |
| 系列： | PowerWise® |
| 主要目的： | 计时，多用途 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | LMK04031 |
| 已供物品： | 板，线缆，文档，软件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页当前第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页
N
R
X FOSCin
(VCO_DIV CLK_DIV)
FCLK error =
N
R
FOSCin
(VCO_DIV CLK_DIV)
FCLK =
SNOSAZ8J – SEPTEMBER 2008 – REVISED SEPTEMBER 2011
CLKoutX_MUX: Clock Output Mux
The output of each CLKoutX channel pair is controlled by its' channel multiplexer (mux). The mux can select
between several signals: bypassed, divided only, divided and delayed, or delayed only.
Table 10. CLKoutX_MUX: Clock Channel Multiplexer Control Bits
CLKout_MUX [1:0]
Clock Mode
b1
b0
0
Bypassed
0
1
Divided
1
0
Delayed
1
Divided and Delayed
Registers 5, 6
These registers are reserved. These register values should not be modified from the values shown in the register
map.
Register 7
Reset bit
This bit is only in register R7. The use of this bit is optional and it should be set to '0' if not used. Setting this bit
to a '1' forces all registers to their power on reset condition and therefore automatically clears this bit.
Registers 8, 9
These registers are reserved. These register values should not be modified from the values shown in the register
map.
Register 10
RC_DLD1_Start: PLL1 Digital Lock Detect Run Control bit
This bit is used to control the state machine for the PLL2 VCO tuning algorithm. The following table describes the
function of this bit.
Table 11. RC_DLD1_Start bit States
RC_DLD1_Start
Description
1
The PLL2 VCO tuning algorithm trigger is delayed until PLL1 Digital Lock Detect is valid.
0
The PLL2 VCO tuning algorithm runs immediately after any PLL2_N counter update, despite the state of PLL1
Digital Lock Detect.
If the user is unsure of the state of the reference clock input at startup of the LMK040xx device, setting
RC_DLD1_Start = 0 will allow PLL2 to tune and lock the internal VCO to the oscillator attached to the OSCin
port. This ensures that the active clock outputs will start up at frequencies close to their desired values. The error
in clock output frequency will depend on the open loop accuracy of the oscillator driving the OSCin port. The
frequency of an active clock output is normally given by:
If the open loop frequency accuracy of the external oscillator (either a VCXO or crystal based oscillator) is "X"
ppm, then the error in the output clock frequency (FCLK error) will be:
34
Copyright 2008–2011, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| LTC2903CS6-D1#TRMPBF | IC QUAD SPLY MONITOR ADJ SOT23-6 |
| 3-1906054-1 | CA 2MM OFNR 62.5/125,LC SEC GRE |
| PCV1V820MCL1GS | CAP ALUM 82UF 35V 20% SMD |
| 3-1906053-1 | CA 2MM OFNR 62.5/125,LC SEC YEL |
| LMK04033BEVAL/NOPB | BOARD EVALUATION LMK04033 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LMK04031BEVALXO | 功能描述:时钟和定时器开发工具 LMK04031 EVAL BOARD RoHS:否 制造商:Texas Instruments 产品:Evaluation Modules 类型:Clock Conditioners 工具用于评估:LMK04100B 频率:122.8 MHz 工作电源电压:3.3 V |
| LMK04031BISQ | 制造商:Texas Instruments 功能描述:Clock Conditioner 48-Pin LLP EP T/R |
| LMK04031BISQ/NOPB | 功能描述:时钟合成器/抖动清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel |
| LMK04031BISQE | 制造商:Texas Instruments 功能描述:PRECISION CLOCK CONDITIONER, 48LLP |
| LMK04031BISQE/NOPB | 功能描述:时钟合成器/抖动清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。