- 您现在的位置：买卖IC网 > PDF目录13881 > LT1956IFE-5#PBF (Linear Technology)IC REG BUCK 5V 1.5A 16TSSOP PDF资料下载
参数资料
| 型号： | LT1956IFE-5#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 3/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK 5V 1.5A 16TSSOP |
| 标准包装： | 95 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 5V |
| 输入电压： | 5.5 V ~ 60 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 500kHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 16-TSSOP-EP |
第1页第2页当前第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT1956/LT1956-5
ELECTRICAL CHARACTERISTICS
The q denotes specifications which apply over the full operating temperature range, otherwise specifications are at T J = 25 ° C.
V IN = 15V, V C = 1.5V, SHDN = 1V, Boost o/c, SW o/c, unless otherwise noted.
PARAMETER
Switch Current Limit
CONDITIONS
V C Open, Boost = V IN + 5V, FB = 1V or V SENSE = 4.1V q
MIN
1.5
TYP
2
MAX
3
UNITS
A
Switch On Resistance
Maximum Switch Duty Cycle
I SW = 1.5A, Boost = V IN + 5V (Note 7)
FB = 1V or V SENSE = 4.1V
q
q
82
75
0.2
90
90
0.3
0.4
?
?
%
%
Switch Frequency
f SW Line Regulation
f SW Shifting Threshold
Minimum Input Voltage
Minimum Boost Voltage
Boost Current (Note 5)
Input Supply Current (I VIN )
Output Supply Current (I BIAS )
Shutdown Supply Current
V C Set to Give DC = 50%
5.5V ≤ V IN ≤ 60V
Df = 10kHz
(Note 3)
(Note 4) I SW ≤ 1.5A
Boost = V IN + 5V, I SW = 0.5A
Boost = V IN + 5V, I SW = 1.5A
(Note 6) V BIAS = 5V
(Note 6) V BIAS = 5V
SHDN = 0V, V IN ≤ 60V, SW = 0V, V C Open
q
q
q
q
q
q
q
460
430
500
0.05
0.8
4.6
2
12
42
1.4
2.9
25
540
570
0.15
5.5
3
25
70
2.2
4.2
75
200
kHz
kHz
%/V
V
V
V
mA
mA
mA
mA
μ A
μ A
Lockout Threshold
Shutdown Thresholds
Minimum SYNC Amplitude
V C Open
V C Open, Shutting Down
V C Open, Starting Up
q
q
q
q
2.30
0.15
0.25
2.42
0.37
0.45
1.5
2.53
0.6
0.6
2.2
V
V
V
V
SYNC Frequency Range
SYNC Input Resistance
580
20
700
kHz
k ?
Note 1: Absolute Maximum Ratings are those values beyond which the life
of a device may be impaired.
Note 2: Gain is measured with a V C swing equal to 200mV above the low
clamp level to 200mV below the upper clamp level.
Note 3: Minimum input voltage is not measured directly, but is guaranteed
by other tests. It is defined as the voltage where internal bias lines are still
regulated so that the reference voltage and oscillator remain constant.
Actual minimum input voltage to maintain a regulated output will depend
upon output voltage and load current. See Applications Information.
Note 4: This is the minimum voltage across the boost capacitor needed to
guarantee full saturation of the internal power switch.
Note 5: Boost current is the current flowing into the BOOST pin with the
pin held 5V above input voltage. It flows only during switch on time.
Note 6: Input supply current is the quiescent current drawn by the input
pin when the BIAS pin is held at 5V with switching disabled. Bias supply
current is the current drawn by the BIAS pin when the BIAS pin is held at
5V. Total input referred supply current is calculated by summing input
supply current (I VIN ) with a fraction of supply current (I BIAS ):
I TOTAL = I VIN + (I BIAS )(V OUT /V IN )
Note 7: Switch on resistance is calculated by dividing V IN to SW voltage by
the forced current (1.5A). See Typical Performance Characteristics for the
graph of switch voltage at other currents.
Note 8: The LT1956EFE/LT1956EFE-5/LT1956EGN/LT1956EGN-5 are
guaranteed to meet performance specifications from 0 ° C to 125 ° C
junction temperature. Specifications over the –40 ° C to 125 ° C operating
junction temperature range are assured by design, characterization and
correlation with statistical process controls. The LT1956IFE/LT1956IFE-5/
LT1956IGN/LT1956IGN-5 are guaranteed over the full – 40 ° C to 125 ° C
operating junction temperature range.
Note 9: Transconductance and voltage gain refer to the internal amplifier
exclusive of the voltage divider. To calculate gain and transconductance,
refer to the SENSE pin on fixed voltage parts. Divide values shown by the
ratio V OUT /1.219.
Note 10: This IC includes overtemperature protection that is intended to
protect the device during momentary overload conditions. Junction
temperature will exceed 125 ° C when overtemperature protection is active.
Continuous operation above the specified maximum operating junction
temperature may impair device reliability.
with V IN = 15V, V OUT = 5V, I VIN = 1.4mA, I BIAS = 2.9mA, I TOTAL = 2.4mA.
1956f
3
相关PDF资料 |
PDF描述 |
|---|---|
| UWT0G330MCR1GB | CAP ALUM 33UF 4V 20% SMD |
| GCM36DTAT | CONN EDGECARD 72POS R/A .156 SLD |
| LT1766IFE-5#PBF | IC REG BUCK 5V 1.5A 16TSSOP |
| UWT0G220MCR1GB | CAP ALUM 22UF 4V 20% SMD |
| 25ZL100MEFCTA8X7 | CAP ALUM 100UF 25V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1956IGN | 功能描述:IC REG BUCK ADJ 1.5A 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT1956IGN#PBF | 功能描述:IC REG BUCK ADJ 1.5A 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT1956IGN#PBF | 制造商:Linear Technology 功能描述:IC STEP-DOWN REGULATOR SSOP-16 |
| LT1956IGN#TR | 功能描述:IC REG BUCK ADJ 1.5A 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT1956IGN#TRPBF | 功能描述:IC REG BUCK ADJ 1.5A 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。