参数资料
| 型号： | LT3070EUFD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/28页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO ADJ 5A 28QFN |
| 产品培训模块： | LT3070 - 5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator |
| 标准包装： | 2,500 |
| 稳压器拓扑结构： | 正，可调式 |
| 输出电压： | 0.8 V ~ 1.8 V |
| 输入电压： | 0.95 V ~ 3 V |
| 电压 - 压降（标准）： | 0.085V @ 5A |
| 稳压器数量： | 1 |
| 电流 - 输出： | 5A |
| 电流 - 限制（最小）： | 5.1A |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 供应商设备封装： | 28-QFN（4x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3070
PIN FUNCTIONS
VIOC (Pin 1): Voltage for In-to-Out Control. The IC in-
corporates a unique tracking function to control a buck
regulator powering the LT3070’s input. The VIOC pin is
the output of this tracking function that drives the buck
regulator to maintain the LT3070’s input voltage at V OUT +
300mV. This function maximizes efficiency and minimizes
power dissipation. See the Applications Information sec-
tion for more information on proper control of the buck
regulator.
PWRGD (Pin 2): Power Good. The PWRGD pin is an open-
drain NMOS output that actively pulls low if any one of
these fault modes is detected:
? V OUT is less than 90% of V OUT(NOMINAL) on the rising
edge of V OUT .
? V OUT drops below 85% of V OUT(NOMINAL) for more than
25μs.
? Junction temperature typically exceeds 145°C.
? V BIAS is less than its undervoltage lockout threshold.
? The OUT-to-IN reverse-current detector activates.
See the Applications Information section for more infor-
mation on PWRGD fault modes.
REF/BYP (Pin 3): Reference Filter. The pin is the output
of the bandgap reference and has an impedance of ap-
proximately 19kΩ. This pin must not be externally loaded.
Bypassing the REF/BYP pin to GND with a 10nF capacitor
decreases output voltage noise and provides a soft-start
function to the reference. LTC recommends the use of a
high quality, low leakage capacitor. See the Applications
Information section for more information on noise and
output voltage margining considerations.
GND (Pins 4, 9-14, 20, 26, 29): Ground. The exposed pad
(Pin 29) of the QFN package is an electrical connection to
GND. To ensure proper electrical and thermal performance,
solder Pin 29 to the PCB ground and tie to all GND pins
of the package. These GND pins are fused to the internal
die attach paddle and the exposed pad to optimize heat
sinking and thermal resistance characteristics. See the Ap-
plications Information section for thermal considerations
and calculating junction temperature.
IN (Pins 5, 6, 7, 8): Input Supply. These pins supply
power to the high current pass transistor. Tie all IN pins
together for proper performance. The LT3070 requires a
bypass capacitor at IN to maintain stability and low input
impedance over frequency. A 47μF input bypass capacitor
suffices for most battery and power plane impedances.
Minimizing input trace inductance optimizes performance.
Applications that operate with low V IN -V OUT differential
voltages and that have large, fast load transients may require
much higher input capacitor requirements to prevent the
input supply from drooping and allowing the regulator to
enter dropout. See the Applications Information section
for more information on input capacitor requirements.
OUT (Pins 15, 16, 17, 18): Output. These pins supply
power to the load. Tie all OUT pins together for proper
performance. A minimum output capacitance of 15μF is
required for stability. LTC recommends low ESR, X5R or
X7R dielectric ceramic capacitors for best performance.
A parallel ceramic capacitor combination of 10μF + 4.7μF
+ 2.2μF or 15 1μF ceramic capacitors in parallel provide
excellent stability and load transient response. Large load
transient applications require larger output capacitors to
limit peak voltage transients. See the Applications Infor-
mation section for more information on output capacitor
requirements.
SENSE (Pin 19): Kelvin Sense for OUT . The SENSE pin is
the inverting input to the error amplifier. Optimum regulation
is obtained when the SENSE pin is connected to the OUT
pins of the regulator. In critical applications, the resistance
(R P ) of PCB traces between the regulator and the load cause
small voltage drops, creating a load regulation error at the
point of load. Connecting the SENSE pin at the load instead
of directly to OUT eliminates this voltage error. Figure 1
illustrates this Kelvin-Sense connection method. Note that
the voltage drop across the external PCB traces adds to the
dropout voltage of the regulator. The SENSE pin input bias
current depends on the selected output voltage. SENSE
pin input current varies from 50μA typically at V OUT = 0.8V
to 300μA typically at V OUT = 1.8V.
3070fb
12
For more information www.linear.com/LT3070
相关PDF资料 |
PDF描述 |
|---|---|
| MIC5310-SGYML TR | IC REG LDO 3.3V/1.8V .15A 8-MLF |
| GBB90DHBD | CONN EDGECARD 180PS R/A .050 SLD |
| HCC65DREI-S93 | CONN EDGECARD 130PS .100 EYELET |
| HBC65DREI-S93 | CONN EDGECARD 130PS .100 EYELET |
| EMC50DRTN-S93 | CONN EDGECARD 100PS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3070IUFD | 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator |
| LT3070IUFD#PBF | 功能描述:IC REG LDO ADJ 5A 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:8V 输入电压:10.5 V ~ 23 V 电压 - 压降（标准）:1.7V @ 40mA 稳压器数量:1 电流 - 输出:100mA（最小值） 电流 - 限制（最小）:- 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:剪切带 (CT) 产品目录页面:1075 (CN2011-ZH PDF) 其它名称:296-24390-1 |
| LT3070IUFD#TRPBF | 功能描述:IC REG LDO ADJ 5A 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.5V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:300mA（最小值） 电流 - 限制（最小）:360mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) |
| LT3070IUFDPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator |
| LT3070IUFDTR | 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator |
发布紧急采购，3分钟左右您将得到回复。