- 您现在的位置：买卖IC网 > PDF目录16001 > LT3650IMSE-8.2#PBF (Linear Technology)IC CHARGER LI-ION 8.2V 2A 12MSOP PDF资料下载
参数资料
| 型号： | LT3650IMSE-8.2#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/22页 |
| 文件大小： | 0K |
| 描述： | IC CHARGER LI-ION 8.2V 2A 12MSOP |
| 标准包装： | 37 |
| 功能： | 充电管理 |
| 电池化学： | 锂离子（Li-Ion）、锂聚合物（Li-Pol） |
| 电源电压： | 9 V ~ 32 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-TSSOP （0.118"，3.00mm 宽）裸露焊盘 |
| 供应商设备封装： | 12-MSOP，裸露焊盘 |
| 包装： | 管件 |
LT3650-8.2/LT3650-8.4
APPLICATIONS INFORMATION
R RNG/SS = RNG/SS
R RNG/SS =
= 10k ?
RNG/SS:DynamicChargeCurrentAdjust
The LT3650 gives the user the capability to adjust maximum
charge current dynamically through the RNG/SS pin. The
voltage on the RNG/SS pin corresponds to ten times the
maximum voltage across the sense resistor (R SENSE ). The
default maximum sense voltage is 100mV, so maximum
charge current can be expressed as:
I MAX(RNG/SS) = I MAX ? V RNG/SS
where I MAX(RNG/SS) is the maximum charge current if
V RNG/SS is within 0V to 1V. Voltages higher than 1V have
no effect on the maximum charge current.
The LT3650 sources 50μA from the RNG/SS pin, such that
a current control voltage can be set by simply connecting
an appropriately valued resistor to ground, following the
relation:
V
50μA
For example, to reduce the maximum charge current to 50%
of the original value, which corresponds to a maximum
sense voltage of 50mV, RNG/SS would be set to 0.5V.
0.5V
50μA
LT3650
RNG/SS
10k
This feature could be used, for example, to switch in a
reduced charge current level. Active servos can also be
used to impose voltages on the RNG/SS pin, provided they
can only sink current. Active circuits that source current
cannot be used to drive the RNG/SS pin. Resistive pull-
ups can be used, but extreme care must be taken not to
exceed the 2.5V absolute maximum voltage on the pin.
RNG/SS: Soft-Start
Soft-start functionality is also supported by the RNG/SS
pin. 50μA is sourced from the RNG/SS pin, so connecting
a capacitor from the RNG/SS pin to ground (C RNG/SS ) cre-
ates a linear voltage ramp. The maximum charge current
follows this voltage. Thus, the charge current increases
from zero to the fully programmed value as the capacitor
charges from 0V to 1V. The value of C RNG/SS is calculated
based on the desired time to full current (t SS ) following
the relation:
C RNG/SS = 50μA ? t SS
The RNG/SS pin is pulled to ground internally when charg-
ing is terminated so each new charging cycle begins with
a soft-start cycle. RNG/SS is also pulled to ground during
bad-battery and NTC fault conditions, so a graceful recovery
from these faults is possible.
LT3650
RNG/SS
+
365082 F06
LOGIC HIGH = HALF CURRENT
365082 F07
–
SERVO REFERENCE
Figure 6. Using the RNG/SS Pin for Digital
Control of Maximum Charge Current
Figure 7. Driving the RNG/SS Pin with a
Current-Sink Active Servo Amplifier
LT3650
RNG/SS
C PROG
365082 F08
Figure 8. Using the RNG/SS Pin for Soft-Start
36508284fd
14
相关PDF资料 |
PDF描述 |
|---|---|
| CCF0.25TB100 | CLEAN CUT FR 1/4" BLK/WHT 100' |
| ACC07DRTF-S13 | CONN EDGECARD 14POS DIP .100 SLD |
| RCC26DRXN | CONN EDGECARD 52POS DIP .100 SLD |
| RCC26DRXH | CONN EDGECARD 52POS DIP .100 SLD |
| RCC17DRTF | CONN EDGECARD 34POS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3651 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage High Current Controller for Battery Charging and Power Management |
| LT3651-4.1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 4A High Voltage Monolithic 4A High Voltage |
| LT3651-4.2 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 4A High Voltage Li-Ion Battery Charger |
| LT3651-8.2 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 4A HIgh Voltage 2-Cell Li-Ion Battery Charger |
| LT3651-8.4 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 4A HIgh Voltage 2-Cell Li-Ion Battery Charger |
发布紧急采购，3分钟左右您将得到回复。