参数资料
型号: LT3686HDD#TRPBF
厂商: Linear Technology
文件页数: 9/28页
文件大小: 0K
描述: IC REG BUCK ADJ 1.2A 10DFN
标准包装: 2,500
类型: 降压(降压)
输出类型: 可调式
输出数: 1
输出电压: 0.8 V ~ 30 V
输入电压: 3.6 V ~ 37 V
PWM 型: 电流模式
频率 - 开关: 300kHz ~ 2.5MHz
电流 - 输出: 1.2A
同步整流器:
工作温度: -40°C ~ 150°C
安装类型: 表面贴装
封装/外壳: 10-WFDFN 裸露焊盘
包装: 带卷 (TR)
供应商设备封装: 10-DFN(3x3)
LT3686
OPERATION
The LT3686 is a current mode step-down regulator. The
EN/UVLO pin is used to place the LT3686 in shutdown. The
1.27V threshold on the EN/UVLO pin can be programmed
by an external resistor divider (R4, R5) to disable the
LT3686. When the EN/UVLO pin is driven above 1.27V, an
internal regulator provides power to the control circuitry.
This regulator includes both overvoltage and undervoltage
lockout to prevent switching when V IN is more than 37V
or less than 3.6V.
Tracking soft-start is implemented by providing constant
current via the SS pin to an external soft-start capacitor
(C4) to generate a voltage ramp. FB voltage is regulated to
the voltage at the SS pin until it exceeds 0.8V; FB is then
regulated to the reference 0.8V. Soft-start also reduces
the oscillator frequency to avoid hitting current limit dur-
ing start-up. The SS capacitor is reset during fault events
such as overvoltage, undervoltage, thermal shutdown
and startup.
An oscillator is programmed by resistor R T . The oscillator
sets an RS flip-flop, turning on the internal 1.2A power
switch Q1. An amplifier and comparator monitor the cur-
rent flowing between the V IN and SW pins, turning the
switch off when this current reaches a level determined by
the voltage at V C . An error amplifier measures the output
voltage through an external resistor divider tied to the FB
pin and servos the V C node. If the error amplifier’s output
increases, more current is delivered to the output; if it
decreases, less current is delivered. An active clamp (not
shown) on the V C node provides current limit.
The switch driver operates from either V IN or from the
BOOST pin. An external capacitor and the internal boost
diode are used to generate a voltage at the BOOST pin that
is higher than the input supply. This allows the driver to
fully saturate the internal bipolar NPN power switch for
efficient operation.
A comparator monitors the current flowing through the
catch diode via the DA pin and reduces the LT3686’s op-
erating frequency when the DA pin current exceeds the
1.7A valley current limit. This helps to control the output
current in fault conditions such as shorted output with high
input voltage. The DA comparator works in conjunction
with the switch peak current limit comparator to determine
the maximum deliverable current of the LT3686.
The active load is enabled when MODE is tied above 0.8V
and disabled when the MODE pin is below 0.4V. To use the
active load, the BD pin should be tied to V OUT . The LT3686
will prevent pulse skipping at light loads by regulating the
active load. The active load will assist startup by guarantee-
ing a minimum load to charge the boost capacitor. It also
hastens the recharge of boost capacitor when operating
beyond maximum duty cycle.
The active load works only when the BD pin is less than
5.2V.
3686fc
9
相关PDF资料
PDF描述
LT3688HFE#TRPBF IC REG BUCK ADJ 0.8A DL 24TSSOP
LT3689EUD#PBF IC REG BUCK ADJ 0.7A 16QFN
LT3690MPUFE#TRPBF IC REG BUCK SYNC ADJ 4A 26QFN
LT3692IUH#TRPBF IC REG BUCK ADJ 3.5A DL 32QFN
LT3693IMSE#TRPBF IC REG BUCK ADJ 3.5A 10MSOP
相关代理商/技术参数
参数描述
LT3686IDD 制造商:LINER 制造商全称:Linear Technology 功能描述:37V/1.2A Step-Down Regulator in 3mm × 3mm DFN
LT3686IDD#PBF 功能描述:IC REG BUCK ADJ 1.2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON(1.45x1) 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2
LT3686IDD#PBF 制造商:Linear Technology 功能描述:DC-DC CONVERTER BUCK 2.5MHZ 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BUCK, 2.5MHZ, DFN-10
LT3686IDD#TRPBF 功能描述:IC REG BUCK ADJ 1.2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V,1.5V,1.8V,2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘
LT3686IDDPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:37V/1.2A Step-Down Regulator in 3mm × 3mm DFN