- 您现在的位置：买卖IC网 > PDF目录15503 > LT3757IDD#PBF (Linear Technology)IC REG CTRLR BST FLYBK INV 10DFN PDF资料下载
参数资料
| 型号： | LT3757IDD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/36页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST FLYBK INV 10DFN |
| 产品培训模块： | LT3757 and LT3758 - Boost, Flyback, SEPIC and Inverting Controllers |
| 标准包装： | 121 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 电源电压： | 2.9 V ~ 40 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 是 |
| 反相： | 是 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LT3757/LT3757A
APPLICATIONS INFORMATION
DT S
FBXFrequencyFoldback
When V OUT is very low during start-up or a short-circuit
fault on the output, the switching regulator must operate
at low duty cycles to maintain the power switch current
within the current limit range, since the inductor current
decay rate is very low during switch off time. The minimum
on-time limitation may prevent the switcher from attaining
a sufficiently low duty cycle at the programmed switching
frequency. So, the switch current will keep increasing
through each switch cycle, exceeding the programmed
current limit. To prevent the switch peak currents from
exceeding the programmed value, the LT3757 contains
a frequency foldback function to reduce the switching
frequency when the FBX voltage is low (see the Normal-
ized Switching Frequency vs FBX graph in the Typical
Performance Characteristics section).
The typical frequency foldback waveforms are shown
in the Typical Performance Characteristics section. The
frequency foldback function prevents I L from exceeding
the programmed limits because of the minimum on-time.
During frequency foldback, external clock synchroniza-
tion is disabled to prevent interference with frequency
reducing operation.
Thermal Lockout
If LT3757 die temperature reaches 165°C (typical), the
part will go into thermal lockout. The power switch will
be turned off. A soft-start operation will be triggered. The
part will be enabled again when the die temperature has
dropped by 5°C (nominal).
Loop Compensation
Loop compensation determines the stability and transient
performance. The LT3757/LT3757A use current mode
control to regulate the output which simplifies loop com-
pensation. The LT3757A improves the no-load to heavy
load transient response, when compared to the LT3757.
New internal circuits ensure that the transient from not
switching to switching at high current can be made in a
few cycles.
The optimum values depend on the converter topology, the
component values and the operating conditions (including
the input voltage, load current, etc.). To compensate the
feedback loop of the LT3757/LT3757A, a series resistor-
capacitor network is usually connected from the V C pin to
GND. Figure 1 shows the typical V C compensation network.
For most applications, the capacitor should be in the range
of 470pF to 22nF, and the resistor should be in the range
of 5k to 50k. A small capacitor is often connected in par-
allel with the RC compensation network to attenuate the
V C voltage ripple induced from the output voltage ripple
through the internal error amplifier. The parallel capacitor
usually ranges in value from 10pF to 100pF. A practical
approach to design the compensation network is to start
with one of the circuits in this data sheet that is similar
to your application, and tune the compensation network
to optimize the performance. Stability should then be
checked across all operating conditions, including load
current, input voltage and temperature.
SENSE Pin Programming
For control and protection, the LT3757 measures the
power MOSFET current by using a sense resistor (R SENSE )
between GND and the MOSFET source. Figure 4 shows a
typical waveform of the sense voltage (V SENSE ) across the
sense resistor. It is important to use Kelvin traces between
the SENSE pin and R SENSE , and to place the IC GND as
close as possible to the GND terminal of the R SENSE for
proper operation.
V SENSE
? V SENSE = χ ? V SENSE(MAX)
V SENSE(MAX) V SENSE(PEAK)
t
T S
3757 F04
Figure 4. The Sense Voltage During a Switching Cycle
3757afd
13
相关PDF资料 |
PDF描述 |
|---|---|
| MIC2182-5.0YM | IC REG CTRLR BUCK PWM CM 16-SOIC |
| LTC1622IS8#PBF | IC REG CTRLR BUCK PWM CM 8-SOIC |
| MIC2182-5.0YSM | IC REG CTRLR BUCK PWM CM 16-SSOP |
| SPD62-352M | INDUCTOR PWR SHIELDED 3.50UH SMD |
| SPD62-242M | INDUCTOR PWR SHIELDED 2.40UH SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3757IDD-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Boost, Flyback, SEPIC and Inverting Controller |
| LT3757IMSE | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Flyback Controller 2.9V to 40V Input 10-Pin MSOP EP 制造商:Linear Technology 功能描述:CONTROLLER |
| LT3757IMSE#PBF | 功能描述:IC REG CTRLR PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT3757IMSE#TRPBF | 功能描述:IC REG CTRLR PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT3757IMSEPBF | 制造商:Linear Technology 功能描述:Boost Flyback SEPIC Controller MSOP10EP |
发布紧急采购，3分钟左右您将得到回复。